Instrukcja obsługi Star Micronics TSP654IIBI-24
Star Micronics
Printer
TSP654IIBI-24
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Star Micronics TSP654IIBI-24 (33 stron) w kategorii Printer. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/33
THERMAL PRINTER
TSP650II
SERIES
Hardware Manual
Federal Communications Commission
Radio Frequency Interference
Statement
is device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) is device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: is equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. ese limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
For compliance with the Federal Noise Interference Standard, this equipment requires a shielded cable.
For RF interference suppression, if a ferrite core is provided with this device, ax it to the interface cable.
is statement will be applied only for the printers marketed in U.S.A.
Statement of
e Canadian Department of Communications
Radio Interference Regulationst
is Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
e above statement applies only to printers marketed in Canada.
Caution Symbol
ese symbols are located near the thermal print head.
Because the thermal print head is hot immediately aer printing, do not touch it. Static
electricity can damage the thermal print head. To protect the thermal print head from
static electricity, do not touch it.
is symbol is located near the cutter.
Never touch the cutter blade, as you could injure your ngers.
is symbol is located near the peripheral drive connector.
Do not connect this to a telephone.
is symbol is located near the screws securing the case or the protective plate, which
should not be opened by individuals other than service personnel. Individuals, other
than service personnel, should not remove these screws. High voltage areas in the case
can be dangerous.
Trademark acknowledgments
TSP650II : Star Micronics Co., Ltd.
Notice
• All rights reserved. Reproduction of any part of this manual in any form whatsoever, without STAR’s express
permission is forbidden.
• e contents of this manual are subject to change without notice.
• All eorts have been made to ensure the accuracy of the contents of this manual at the time of going to press.
However, should any errors be detected, STAR would greatly appreciate being informed of them.
• e above notwithstanding, STAR can assume no responsibility for any errors in this manual.
Copyright
©
2013-2014 Star Micronics Co., Ltd..
< For Bluetooth models >
Federal Communications Commission
Radio Frequency Interference
Statement
is device complies with Part 15 of the FCC Rules and RSS-Gen of IC Rules. Operation is subject to the following
two conditions:
(1)this device may not cause harmful interference, and
(2)this device must accept any interference received,including interference that may cause undesired operation.
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and
meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio
frequency (RF) Exposure rules. is equipment has very low levels of RF energy that it deemed to comply without
maximum permissive exposure evaluation(MPE). But it is desirable that it should be installed and operated keeping
the radiator at least 20cm or more away from person's body (excluding extremities: hands,wrists,feet and ankles).
is statement will be applied only for the printers marketed in U.S.A and Canada.
CE MARKING WARNING
Hereby, Star Micronics Co., Ltd. declares that this device is in compliance with the essential requirements and other
relevant provisions of Directive 1999/5/EC.
Notice) is device can be operated in all European countries.
Italy: e public use is subject to general authorisation by the respective service provider.
Norway: is subsection does not apply for the geographical area within a radius of 20 km from the centre of Ny-
Alesund.
is statement will be applied only for the printers marketed in Europe.
Specyfikacje produktu
Marka: | Star Micronics |
Kategoria: | Printer |
Model: | TSP654IIBI-24 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Star Micronics TSP654IIBI-24, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Printer Star Micronics
12 Września 2024
12 Września 2024
11 Września 2024
9 Września 2024
9 Września 2024
8 Września 2024
Instrukcje Printer
- Printer Sony
- Printer Samsung
- Printer Sharp
- Printer Epson
- Printer Roland
- Printer Panasonic
- Printer Canon
- Printer Fujifilm
- Printer Toshiba
- Printer Citizen
- Printer HP
- Printer Brother
- Printer Honeywell
- Printer Kodak
- Printer Primera
- Printer Xerox
- Printer Godex
- Printer Olivetti
- Printer Zebra
- Printer Dell
- Printer Digitus
- Printer Kyocera
- Printer Ricoh
- Printer Seiko
- Printer Thomson
- Printer Panduit
- Printer Olympus
- Printer OKI
- Printer Mitsubishi
- Printer Intermec
- Printer NEC
- Printer Polaroid
- Printer Konica Minolta
- Printer Bixolon
- Printer Pantum
- Printer Datamax O'Neil
- Printer DNP
- Printer TSC
- Printer HiTi
- Printer Lexmark
- Printer Sagem
- Printer Nilox
- Printer Royal Sovereign
- Printer Oce
- Printer Paxar
- Printer Metapace
- Printer Ultimaker
- Printer Toshiba TEC
- Printer Frama
- Printer Posiflex
- Printer Dascom
Najnowsze instrukcje dla Printer
19 Września 2024
19 Września 2024
19 Września 2024
19 Września 2024
19 Września 2024
18 Września 2024
17 Września 2024
16 Września 2024
16 Września 2024
16 Września 2024