Instrukcja obsługi Star Micronics FVP10


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Star Micronics FVP10 (67 stron) w kategorii drukarka. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/67
THERMAL PRINTER
FVP10 SERIES
Hardware Manual
Federal Communications Commission
Radio Frequency Interference
Statement
is device complies with Part 15 of FCC Rules and Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) is device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
FCC CAUTION
Changes or modications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
For compliance with the Federal Noise Interference Standard, this equipment requires a shielded cable.
For RF interference suppression, if a ferrite core is provided with this device, ax it to the interface cable.
NOTE:
is equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. ese limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. is equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
CAN ICES-3 (A) / NMB-3 (A)
is equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and
meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65 and RSS-102 of the IC radio
frequency (RF) Exposure rules. is equipment has very low levels of RF energy that it deemed to comply without
maximum permissive exposure evaluation(MPE). But it is desirable that it should be installed and operated keeping
the radiator at least 20cm or more away from person's body (excluding extremities: hands,wrists,feet and ankles).
Cet équipement est conforme aux limites d"exposition aux rayonnements énoncées pour un environnement non
contrôlé et respecte les règles les radilectriques (RF) de la FCC lignes directrices d'exposition dans le Supplément
C à OET65 et d"exposition aux fréquences radioélectriques (RF) CNR-102 de l"IC. Cet équipement émet une
énergie RF très faible qui est considérée conforme sans évaluation de l"exposition maximale autorisée. Cependant,
cet équipement doit être instal et utilisé en gardant une distance de 20 cm ou plus entre le dispositif rayonnant et
le corps (à l"exception des extrémités : mains, poignets, pieds et chevilles).
Trademark acknowledgments
FVP10 : Star Micronics Co., Ltd.
Notice
All rights reserved. Reproduction of any part of this manual in any form whatsoever, without STAR’s express permission is forbidden.
The contents of this manual are subject to change without notice.
All eorts have been made to ensure the accuracy of the contents of this manual at the time of going to press. However, should any
errors be detected, STAR would greatly appreciate being informed of them.
The above notwithstanding, STAR can assume no responsibility for any errors in this manual.
IOS is a trademark or registered trademark of Cisco in the U.S. and other countries and is used under license.
Android is a trademark of Google Inc.
Windows is registered trademarks of Microsoft Corporation.
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc.
Copyright © 2010-2019 Star Micronics Co., Ltd.
Caution Symbol
ese symbols are located near the thermal print head.
Because the thermal print head is hot immediately aer printing, do not touch it. Static
electricity can damage the thermal print head. To protect the thermal print head from
static electricity, do not touch it.
is symbol is located near the cutter.
Never touch the cutter blade, as you could injure your ngers.
is symbol is located near the peripheral drive connector.
Do not connect this to a telephone.
is symbol is located near the screws securing the case or the protective plate, which
should not be opened by individuals other than service personnel. Individuals, other
than service personnel, should not remove these screws. High voltage areas in the case
can be dangerous.


Specyfikacje produktu

Marka: Star Micronics
Kategoria: drukarka
Model: FVP10

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Star Micronics FVP10, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje drukarka Star Micronics

Instrukcje drukarka

Najnowsze instrukcje dla drukarka

Kyocera

Kyocera ECOSYS P2135dn Instrukcja

15 Października 2024
OKI

OKI C920WT Instrukcja

15 Października 2024
Brother

Brother DCP-J152W Instrukcja

15 Października 2024
Sharp

Sharp MX-M7570 Instrukcja

14 Października 2024
Ricoh

Ricoh P C300W Instrukcja

14 Października 2024
OKI

OKI MC851dn Instrukcja

13 Października 2024
Kyocera

Kyocera TASKalfa 8052ci Instrukcja

13 Października 2024
Epson

Epson Mobilink TM-P20II Instrukcja

13 Października 2024