Instrukcja obsługi Haws 8315CTFP
Haws
system prysznicowy
8315CTFP
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Haws 8315CTFP (13 stron) w kategorii system prysznicowy. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/13
10/20 Model 8315CTFP (120V) & 8315CTFP.220V Page 1 o 13 f
1455 Kleppe Lane Sparks, NV 89431-
6467 4712 7424(775) 359- Fax (775) 359-
E-mail: website: haws@hawsco.com www.hawsco.com
No. (2) 0510001018
Model 8315CTFP (120V & )
8315CTFP.220V
INSTALLATION, OPERATION
&
MAINTENANCE INSTRUCTIONS
LIMITED WARRANTY
HAWS warrants that this specic product is guaranteed against defective material or poor
workmanship for a period of . HAWS liability under this one year from d e of shipmentat
warranty shall be discharged by furnishing without charge F.O.B. HAWS Factory any goods,
or part thereof, which shall appear to the Company upon inspection to be of defective
material or not of rst class workman ip, provided that claim is made in writing to Haws sh
within a reasonable period after receipt of the product. Where claims for defects are made,
the defective part or parts shall be delivered to the Company, prepaid, for inspection. HAWS
will not be liable for the cost of repairs, alterations or replacements, or for any expense
connected therewith made by the owner or his agents, except upon written authority from
HAWS, Sparks, Nevada. HAWS will not be liable for any damages caused by defective
materials or poor workmanship, except for replacements, as provided above. Buyer agrees
that Haws has made no other warranties either expressed or implied in addition to those
above stated, except that of title with respect to any of the products or equipment sold
hereunder and that HAWS shall not be liable for general, special, or consequential damages
claimed to arise under the contract of s ale.
The emergency equipment manufactured by HAWS is warranted to function if installation
and m are adhered to. The units also must be used for the aintenance instructions provided
purpose for which they were intended. This product is intended to supplement rst-aid
treatment. Due to widely varying conditions, Haws cannot guarantee that the use of this
emergency equipment will pr ent serious injury or the aggravation of existing or prior ev
injuries.
NO OTHER WARRANTIES EXPRESSED OR IMPLIED ARE AUTHORIZED, PROVIDED
OR GIVEN BY HAWS.
NOTE TO INSTALLER: Please leave this information with the Maintenance Department.
SHOULD YOU EXPERIENCE DIFFICULTY WITH THE INSTALLATION OF THIS
MODEL PLEASE CALL:
TECHNIC SUPPORT:AL 1- - -5612 800 766
FOR CUSTOMER SERVICE: 1-888- - 97 640 42
10/20 Model 8315CTFP (120V) & 8 5CTFP.220V Page 2 of 13 31
RECOMMENDED TOOLS SUPPLIES: &
• Pipe wrench (both with teeth smooth jaws) es and
• Power drill with Phillips bit (preferr ), or Phillips screwdriver (preferably ratcheting) #2 ed #2
• Adjustable wrench (or a s ndard wrench set up 7/8 ) ta ”
• 7/32" hex key
• Level
• Three (3) rust-resistant anchors (3/8” diameter)
• Pipe joint sealant (Loctite # 7 recommended) PST 56
• Silicone caulking (Dow Corning 832 recommended)
• Stepladder
LOCATION OF UNIT:
• The Model 8315CTFP (120V) & 8 5CTFP.220V Emergency Shower Eye/Face Wash should be installed in 31
close proximity to potential accident areas. It should be clearly identied, free from obstructio , and easy to ns
access.
• Suitable for use in Class 1, Division 2 Group B,C,& D areas.
• Temperature rating T6 (85°C).
ELECTRICAL SUPPLY: D ing potentially freezing periods, ensure that unit is connected to a continuous ur
power supply.
• e rical power required for standard heat traced unit is 120 VAC. Average power MODEL 8315CTFP: El ct
consumption a °F (10°C) ambient temperature is 1 watts. Maximum without lighting is 130 wattst 50 10 .
Connection at input junction box is 3/4” NPT.
• Electrical power required for standard heat traced unit is 220 VAC. Average MODEL 8315CTFP.220V:
power consumption at 50° (10°C) ambient temperature is 1 watts. Maximum without lighting is 130 wattsF 10 .
Connection at input junction box is 3/4" NPT.
WATER SUPPLY: ater supply must be freez protected. W e
• The minimum recommended line is 1- -90 psi (2-6 ATM) o pressure. 1/4” IPS with 30 wing
• An inlet lter is recommended where sediment or mineral content is a problem.
• Main inlet connection is 1-1/4” IPS.
• Optional SP121 auxi ary outlet plumbing 1-1/4 li is ”IPS.
MAINTENANCE:
• Allow eye/face wash piping to drain out completely be re replacing eye/face wash dust cover. fo
• In freezing conditions, wipe eye/face wash head and dust cover dry after each use to prevent unwanted ice
buildup.
• During regula testing, also verify these items: r
o Verify that both the eye/face wash and the showe are able to drain completely. r
o Verify that the st cover is intact and rmly in place. du
• Optional SP158.15 Freeze Protection Valve is a eld serviceable item; refer to its manual for more
information.
WARNING Fire and shock hazards must use a ground fault electrical protection device (30mA GFEPD) for : –
heat trace. Electrical fault currents may be insucient to trip a conventional circuit breaker.
10/20 Model 8315CTFP (120V) & 8315CTFP.220V Page 3 o 13 f
INSTALLATION PROCEDURE
STEP 1: U nboxing
The following components are included with this model. N locations within the packaging and the ote the
p tinent cluded for reference. er installation steps in
Top Tray
6 plastic jacket components .………… Step 6
Large Carton Internal
Painted m or ange etal flo ……………Steps 2-3
Plastic shower b ell……………………Step 4
6 lengths of seal trim …………………Step 6
N lored tapeote co
Universal shower ..sign……………… Step 9
Small Internal Carton
Piping connec tor………………………Step 3
Piping union ……………………………Step 3
6 large zip ties . ……………… .............Steps 3 & 5
2 piping elbows ………………………..S 4tep
Bag
• Eye/face wash assembly . …… Step 7
Bag
• Metal shower lever …………...Step 7
• Eyewash push . ag………….. Step 7
• Paper test tag ………………...Step 9
Bag
• Plastic shower nozzle ………..Step 4
• Plastic hole plug ………………Step 7
• Plastic shower handle ………..Step 7
B ag
• Retaining ring …………………Step 4
• Nut, shower lever . …………… Step 7
• S wer ho handle bolt…………..Step 7
• Push ag nut . ………………… Step 7
• adhesive ru covers 2 bber ……Step 7
• 4 read-forming screws .. th …… Step 9
• Small zip tie……………………Step 9
Central Area of Main Car ton
Factory-assembled section . ………… Steps 3-9
2 insulation sections .tubing ………… S 5 tep
Bottom Area Main Carton of
1- 4 e .. 1/ ”pip nipple…………………… Step 3
2 pip 1 ”e nipples ……………………..Step 4
2 expanded foam support …………...Step 6
spacers the horizontal for
shower piping
Expanded foam s t .. uppor …………… Step 6
spacer the vertical for
shower piping
Refer to e tallation Drawing . th Ins for further details
Specyfikacje produktu
| Marka: | Haws |
| Kategoria: | system prysznicowy |
| Model: | 8315CTFP |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Haws 8315CTFP, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje system prysznicowy Haws
25 Września 2024
25 Września 2024
25 Września 2024
25 Września 2024
25 Września 2024
25 Września 2024
25 Września 2024
Instrukcje system prysznicowy
- system prysznicowy Ikea
- system prysznicowy Hozelock
- system prysznicowy Dimplex
- system prysznicowy Delta
- system prysznicowy Fieldmann
- system prysznicowy Hansgrohe
- system prysznicowy Miomare
- system prysznicowy Juno
- system prysznicowy Schütte
- system prysznicowy Omnires
- system prysznicowy Sani-Lav
- system prysznicowy Fala
- system prysznicowy Pulse ShowerSpas
- system prysznicowy BMI
- system prysznicowy ECOstyle
- system prysznicowy Curaqua
- system prysznicowy Belanger
Najnowsze instrukcje dla system prysznicowy
8 Października 2024
8 Października 2024
7 Października 2024
7 Października 2024
7 Października 2024
7 Października 2024
7 Października 2024
7 Października 2024
7 Października 2024
2 Października 2024