Instrukcja obsługi E-flite UMX Yak 54 3D BNF

E-flite zabawka sterowana radiowo UMX Yak 54 3D BNF

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla E-flite UMX Yak 54 3D BNF (18 stron) w kategorii zabawka sterowana radiowo. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/18

Instruction Manual

Bedienungsanleitung

Manuel d’utilisation

Manuale di Istruzioni

WARNING: Read the ENTIRE instruction manual to become familiar with the features of the

product before operating. Failure to operate the product correctly can result in damage to the product,

personal property and cause serious injury.

This is a sophisticated hobby product. It must be operated with caution and common sense and requires

some basic mechanical ability. Failure to operate this product in a safe and responsible manner could

result in injury or damage to the product or other property. This product is not intended for use by

children without direct adult supervision. Do not use with incompatible components or alter this product

in any way outside of the instructions provided by Horizon Hobby, LLC. This manual contains instructions

for safety, operation and maintenance. It is essential to read and follow all the instructions and warnings

in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or serious

injury.

Age Recommendation: Not for children under 14

years. This is not a toy.

Safety Precautions and Warnings

• Always keep a safe distance in all directions

around your model to avoid collisions or injury.

This model is controlled by a radio signal subject

to interference from many sources outside your

control. Interference can cause momentary loss

of control.

• Always operate your model in open spaces away

from full-size vehicles, trafﬁ c and people.

• Always carefully follow the directions and

warnings for this and any optional support equip-

ment (chargers, rechargeable battery packs,

etc.).

• Always keep all chemicals, small parts and

anything electrical out of the reach of children.

• Always avoid water exposure to all equipment

not speciﬁ cally designed and protected for this

purpose. Moisture causes damage to electronics.

• Never place any portion of the model in your

mouth as it could cause serious injury or even

death.

• Never operate your model with low transmitter

batteries.

• Always keep aircraft in sight and under control.

• Always use fully charged batteries.

• Always keep the transmitter powered on while

aircraft is powered.

• Always remove batteries before disassembly.

• Always keep moving parts clean.

• Always keep parts dry.

• Always let parts cool after use before touching.

• Always remove batteries after use.

• Always ensure failsafe is properly set before

ﬂ ying.

• Never operate aircraft with damaged wiring.

• Never touch moving parts.

Meaning of Special Language:

The following terms are used throughout the product literature to indicate various levels of potential

harm when operating this product:

NOTICE: Procedures, which if not properly followed, create a possibility of physical property damage

AND little or no possibility of injury.

CAUTION: Procedures, which if not properly followed, create the probability of physical property

damage AND a possibility of serious injury.

WARNING: Procedures, which if not properly followed, create the probability of property damage,

collateral damage, and serious injury OR create a high probability of superﬁ cial injury.

NOTICE

All instructions, warranties and other collateral documents are subject to change at the sole discretion

of Horizon Hobby, LLC. For up-to-date product literature, visit www.horizonhobby.com and click on the

support tab for this product.

To register your product online, go to www.e-ﬂ iterc.com

19.6 in (497mm)

16.9 in (430mm)

1.3oz

(36 g)

Table of Contents

Speciﬁ cations

Wing Area: 37.2 sq. in.

(472.3 cm2)



1. Charge flight battery.

2. Install flight battery in aircraft (once it

has been fully charged).

3. Bind aircraft to transmitter.

4. Make sure linkages move freely.

5. Perform Control Direction Test with

transmitter.



6. Set dual rates.

7. Adjust center of gravity.

8. Perform a radio system Range Check.

9. Find a safe and open area.

10. Plan flight for flying field conditions.

Preﬂ ight Checklist

Installed

Motor: Ultra Micro Brushed Motor

8.5mm x 23mm (EFLU5152)

Receiver : DSM2/DSMX UM AS3X®

Receiver/Servos/ESC (EFLU5164)

(2) 2.3-Gram Performance Linear Long

Throw Servo (SPMSA2030L)

Required to Complete

Battery: 150mAh 1S 3.7V 25C/45C

Li-Po, (EFLB1501S25 or EFLB1501S45)

Battery Charger:

Celectra™ 4-Port 1S 3.7V 0.3A DC

Li-Po Charger (EFLC1004)

Recommended Transmitter:

Full range Spektrum™ DSM2®/DSMX®

with dual-rates (DX4e and up)

Transmitter and Receiver Binding ..........................4

Low Voltage Cutoff (LVC) .......................................4

Alternate Flight Mode Programming ......................5

ESC/Receiver Arming, Battery Installation and

Center of Gravity ...................................................6

Control Direction Tests ..........................................7

Control Centering .................................................8

Trimming ..............................................................8

Control Horn Settings ............................................8

Dual Rates and Expos ...........................................8

Flying Tips and Repairs .........................................9

Post Flight Checklist .............................................9

Power Components Service ................................10

Troubleshooting Guide ........................................11

Limited Warranty ................................................12

Warranty and Service Contact Information ..........14

IC Information .....................................................14

FCC Information ..................................................14

Compliance Information for the European Union ..15

Replacement Parts ...............................................54

Optional Parts and Accessories ............................ 55

Specyfikacje produktu

Marka:	E-flite
Kategoria:	zabawka sterowana radiowo
Model:	UMX Yak 54 3D BNF
Kolor produktu:	Black, Red, White
Typ produktu:	Samolot sterowany radiowo (RC)
Liczba kanałów:	6 kan.
Wymagane baterie:	Tak
Kompatybilność marki:	E-flite
Rodzaj konstrukcji:	Sparuj z aparaturą i leć
Rozpiętość skrzydeł:	430 mm
Długość produktu:	497 mm
Rodzaj silnika:	Silnik elektryczny
Liczba serw:	1
Replica:	Nie
Zalecana bateria:	150mAh 1S 3.7V 45C LiPo
Serwo waga:	2.3 g