Instrukcja obsługi Da-Lite DescenderPro 29788LS

Da-Lite Projectiescherm DescenderPro 29788LS

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Da-Lite DescenderPro 29788LS (12 stron) w kategorii Projectiescherm. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/12
INSTRUCTION BOOK FOR
DescenderPro
2
Original Instructions
Important Safety Instructions
Disclaimer
Milestone and its ailiated corporations and subsidiaries (collectively "Milestone"), intend to make this manual accurate and complete.
However, Milestone makes no claim that the information contained herein covers all details, conditions or variations, nor does it provide
for every possible contingency in connection with the installation or use of this subject to change without notice or obligation of any
kind. Milestone makes no representation of warranty, expressed or implied, regarding the information contained herein. Milestone
assumes no responsibility for accuracy, completeness or suiciency of the information contained in this document.
Da-Lite® is a registered trademark of Milestone AV Technologies. All rights reserved.
When using your video equipment, basic safety precautions
should always be followed, including the following:
1. Read and understand all instructions before using.
2. Maximum surrounding air temperature 122°F (50°C).
3. Main disconnect must be incorporated in the ixed wiring in
accordance with the wiring rules.
4. Rated for indoor use only.
5. Use copper rated conductors rated 167°F (75°C) or higher.
6. If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualiied persons in
order to avoid hazard.
7. Supplied drive is only intended for use in Da-Lite screen models
Advantage, Contour, and Cosmopolitan.
8. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.
9. If an extension cord is necessary, a cord with a current rating at
least equal to that of the appliance should be used. Cords rated
for less amperage than the appliance may overheat.
10. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric shock
when the appliance is used subsequently.
11. The use of an accessory attachment not recommended by the
manufacturer may cause a risk of ire, electric shock, or injury to
persons.
12. Failure to provide adequate structural strength for this
component can result in serious personal injury or damage to
equipment! It is the installer’s responsibility to make sure the
structure to which this component is attached can support the
weight of all equipment. Reinforce the structure as required
before installing the component.
13. Use this projection screen only for its intended use as described
in these instructions. Do not use attachments not recommended
by the manufacturer.
Save These Instructions
3
Suggested Methods of Installation
Method 1
Method 2
Adjustable
Mounting Nuts
Motor
End
Electrical
Junction Box
15½"
[39.4cm]
Fixed
Mounting
Nuts
Audience Side
15½"
[39.4cm]
NOTE: For method 2 threaded rod must be 5/1618 thread.
Variable Position
Mounting Bracket
Motor
End
Electrical
Junction Box
15½"
[39.4cm]
Fixed
Bracket
Audience Side
15½"
[39.4cm]
"
[23.5 cm]
5¾"
[14.6cm]
5"
[12.6cm]
5¾" [14.6cm] 2"
[4.8cm]
1⅝" [4.2cm]
"
[17.2cm]
3/8" Threaded Rod
(Not Included)
Attached to
Mounting Bracket
Finished Ceiling
Self-Trimming
Flange
4"
[10 cm]
5¾"
[14.6cm]
5⅛"
[13.1cm]
5¾"
[14.6cm]
1⅝" [4.2cm]
"
[17.2cm]
Finished Ceiling
Self-Trimming
Flange
5/16" Threaded
Rod (Not
Included)
Attached to
Mounting Nut

Specyfikacje produktu

Marka: Da-Lite
Kategoria: Projectiescherm
Model: DescenderPro 29788LS

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Da-Lite DescenderPro 29788LS, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą