Instrukcja obsługi RCA RP7702S

RCA radio RP7702S

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla RCA RP7702S (2 stron) w kategorii radio. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/2

RP-7702

PHONES

RECORDPAUSE STOP / EJECT F. FWD REWIND PLAY

TAPE FM

PHONES

RECORDPAUSE STOP / EJECT F. FWD REWIND PLAY

TAPE FM

FM 88 92 96 100 104 106 108 MHz

AM 53 60 70 80 100 120 140 170 x10kHz

RP7702 - RADIO CASSETTE RECORDER

Cleaning the Tape Heads

Iron oxide particles from the magnetic tape can build

up on the parts that come in contact with the tape.

These deposits can cause incomplete erasure, muffled

playback sound, and might prevent automatic stop.

To clean a cassette tape deck, open the compartment

door, press PLAY and gently clean the heads, capstan,

and pinch wheel with a liquid head cleaner.

Always unplug the power cord before cleaning, and allow 30 minutes drying time when using a

liquid cleaner.

Clean heads after every 25 hours of use.

• Demagnetize the head occasionally with a head demagnetizing cassette (available from

many audio equipment stores).

• Never use any metal objects on or near the tape heads. Do not allow any cleaning material to

fall into the tape assembly.

Tape Care

• Don’t expose tapes to sunlight or store in hot places. High temperatures may warp the

shell or damage the tape itself.

• Keep cassettes in their boxes when not in use.

• Cassette tapes can be erased by magnetic fields produced by magnets, electric motors,

electrical transformers, and other devices. Keep tapes away from magnets and magnetic

fields.

Recording from the Radio

1. Insert a cassette tape into the tape deck and close door.

2. Move the Function switch to the desired band: or AM FM.

3. Tune to the desired radio station by adjusting the Tuning knob.

4. Press to begin recording. Both the RECORD and PLAY buttons are now depressed.RECORD

5. To stop recording, press STOP/EJECT.

6. To turn off radio, slide Function Switch to TAPE.

Quit Slacking

A little bit of slack in your tapes can cause

scratches on the tape, or worse yet, the tape

could break. If you notice some slack in the tape,

use a pencil to tighten it up before you insert it.

Pause for a Moment

Use PAUSE on the cassette deck instead of to momentarily interruptSTOP

recording gives a much cleaner sounding recording!

Troubleshooting Tips

Problem Solution

Unit doesn’t turn on • Make sure power cord is securely plugged into the AC

power outlet (or that the batteries are fresh).

• Unplug the unit for a moment, and then plug it back in.

• Check the outlet by plugging in another device.

No sound • Adjust volume setting.

• Make sure you’ve selected the correct function: TAPE or

RADIO (AM/FM).

Poor radio reception • Adjust the FM whip antenna for better FM reception.

• Rotate the unit to achieve better AM reception.

• Try turning off electrical appliances near the unit, such

as hair dryers, vacuum cleaners, or fluorescent lights.

Distorted or noisy recordings • Inspect the recording head and clean it if necessary.

• Demagnetize recording head (as explained in the "CARE

AND MAINTENANCE" section) .

Erase Protection

When you record new material, the cassette

deck records over whatever is on a tape. To

protect a tape from accidental erasure, break

off one or both plastic tabs (one for each tape

side) on the top of the cassette tape. If you

decide later to record on the tape, seal the

hole with a piece of cellophane tape.

FCC INFORMATION

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

In accordance with FCC requirements, changes or modifications not expressly approved by Thomson

Consumer Electronics could void the user’s authority to operate this product.

This device generates and uses radio frequency (RF) energy, and if not installed and used properly, this

equipment may cause interference to radio and television reception.

If this equipment does cause interference to radio or television reception (which you can determine by

turning the equipment off and on), try to correct the interference by one or more of the following measures:

• Reorient the receiving antenna (that is, the antenna for the radio or television that is “receiving” the

interference).

• Move the unit away from the equipment that is receiving interference.

• Plug the unit into a different wall outlet so that the unit and the equipment receiving interference are

on different branch circuits.

If these measures do not eliminate the interference, please consult your dealer or an experienced radio/

television technician for additional suggestions.

Headset Safety

•Do not play your headset at a high volume. Hearing experts advise against continuous extended

play.

• If you experience a ringing in your ears, reduce volume or discontinue use.

• You should use extreme caution or temporarily discontinue use in potentially hazardous situations.

• Even if your headset is an open-air type designed to let you hear outside sounds, don't turn up the

volume so high that you can't hear what's around you.

WARNING:

TO PREVENT FIRE

OR ELECTRICAL SHOCK HAZARD,

DO NOT EXPOSE THIS PRODUCT

TO RAIN OR MOISTURE.

SEE MARKING ON BOTTOM / BACK OF PRODUCT

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

THE EXCLAMATION

POINT WI T H IN THE

T RI A N G L E I S A

WARNIN G SIGN

ALERTI N G Y O U OF

I M P O R T A N T

I N S T R U C T I O N S

A C C O M P A N Y I N G

T H E P R O D U C T.

T H E L I G HT NI N G

FLASH AND ARROW-

HEAD WITHIN THE

T R IA N GL E I S A

W A RN I N G S I GN

ALERTING YOU OF

" D A N G E R O U S

VOLTAGE" INSID E

THE PRODUCT.

CAUTION: T O REDUCE THE

RISK O F ELECTRIC SHOCK,

DO N OT RE MO VE CO V ER

( O R B A C K ) . N O U S E R -

SE RV IC EA BL E P A RT S I N-

SI D E . R E F ER S ER V I CIN G

T O Q UA L I F IE D S E RV I C E

PER SONNEL.

Powering Up

This unit operates on battery or AC power.

Battery Power

Insert 4 C-sized alkaline batteries (not supplied) and you can take

your stereo just about anywhere. Open the battery compartment

door on the back of the unit by pressing down on the two tabs and

pulling out the cover. Insert batteries as shown in the battery

compartment. Note that the AC line cord must be unplugged from the AC power

outlet to operate on batteries. You can wind the line cord and store it into the built-in cord cabinet.

Using the Radio

Tuning In Radio Stations

Move the FUNCTION switch to or for turning ON the radio.AM FM

• Tune to the desired station by adjusting the tuning knob.

• To turn off the radio, move the Function switch to TAPE.

Have a Blast—Just Not on Your Eardrums

Make sure that you turn down the stereo before you put on

the headphones; then increase the volume to the desired

level after they are in place.

Antennas

The AM antenna is built in, so adjusting the position of the unit may help AM reception.

The FM whip antenna on the back of the unit can be extended and rotated for better FM reception.

Headphones

To listen to your stereo with headphones (not included), use the 1/8-inch PHONE jack on the

top of the unit.

If you know what each button does, it’s easy to figure out how to operate the tape deck.

RECORD — Press to record from the radio.

PLAY — Press to play the loaded cassette tape.

REWIND — From stop mode, press to rewind the tape toward the beginning.

F. FWD — From stop mode, press to advance the tape toward the end.

STOP/EJECT — Press to stop current tape activity, or to open the cassette compartment door

when no buttons are active.

PAUSE — Press to interrupt tape play or record mode. Press a second time to resume tape

play or tape record mode.

Playing a Cassette Tape

1. Move the Function switch to TAPE.

2. Press to open the cassette compartment door.STOP/EJECT

3. Insert cassette tape into the compartment with the open edge facing up and the full reel

on the right.

4. Close the door securely.

5. Press or REWIND F. FWD to move tape to the desired starting point.

6. Press PLAY to begin playing the tape. The cassette tape plays until it reaches the end of

the side, then unit automatically stops.

PAUSE

STOP/EJECT

PLAY

RECORD

IMPORTANT: Be sure to remove batteries when storing the set for more than 30 days. Leaky

batteries can badly damage the stereo. Always return tape operation buttons to their off

position before storing. This will relieve pressure on certain parts in the tape recorder that

might deform after long periods of time. Dispose of leaky, dead or weak batteries properly.

AC Power

Plug the power supply cord into an AC power outlet that accepts the

polarized plug (one blade wider than the other).

Portable radio &

cassette player

Model RP-7702

20994610 (Rev.0 E/F)

98-50

Printed in Hong Kong

Trademark(s) ® Registered

Marque(s) déposee

Before you begin

general controls

Headphone Jack - plug a set of headphones (not included) into this jack for private listening.

Function Switch – Move the function switch to select which part of the portable stereo you

want to use; TAPE, FM or AM.

VOLUME – Adjust the volume control knob to increase or decrease volume to the desired level.

FM Antenna – When listening to FM radio broadcast, extend this antenna for clearer reception.

Tuning knob - Adjust this knob for tuning to the desired radio station.

Function

Switch

Tuning

knob

Headphone

Jack

VOLUME

control

FM Antenna

Using the Tape Player

REWIND

F.FWD

CARE AND MAINTENANCE

care and maintenance ( )CONTINUED

SIZE AAA/LR20/1.5V

M ercury

ALKALINE

0% Mercury

ALKALINE

0% Mercury

ALKALINE

0% Mercury

ALKALINE

0% Mercury

ALKALINE

Canadian Warranty

Thomson Consumer Electronics Canada, Inc. warrants to the purchaser or gift recipient that if

any manufacturing defect becomes apparent in this product within

1 year from the original date of purchase, it will be replaced free of charge, including return

transportation.

This warranty does not include damage to the product resulting from accidents, misuse or

leaking batteries.

Should your product not perform properly during the warranty period, either:

1. Return it to the selling dealer with proof of purchase for replacement,

2. Remove the batteries (where applicable), and pack product complete with accessories in

the original carton (or equivalent).

Mail prepaid (with proof of purchase) and insured to:

Thomson Consumer Electronics Canada, Inc.

Distribution Centre

7400 A Bramalea Road

Mississauga, Ontario L5S 1X1

The provisions of this written warranty are in addition to and not a modification of or

subtraction from the statutory warranties and other rights and remedies contained in any

applicable legislation, and to the extent that any such provisions purport to disclaim, exclude

or limit any such statutory warranties and other rights and remedies, such provisions shall be

deemed to be amended to the extent necessary to comply therewith.

If you are unable to find a qualified servicer for out of warranty service, you may write to:

Thomson Consumer Electronics Canada, Inc.

P.O. Box 0944

Indianapolis, Indiana, U.S.A., 46206-0944

Attach your sales receipt to this booklet for future reference. This information is required if

service is needed during the warranty period.

PURCHASE DATE _________________________________________________________

NAME OF STORE _________________________________________________________

Specyfikacje produktu

Marka:	RCA
Kategoria:	radio
Model:	RP7702S

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z RCA RP7702S, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje radio RCA

RCA RP7702S Instrukcja

2 Września 2024

RCA RC100 Instrukcja

22 Sierpnia 2024

RCA RC10 Instrukcja

17 Sierpnia 2024

RCA RCD159 Instrukcja

4 Lipca 2024

Instrukcje radio

Najnowsze instrukcje dla radio

Ruarkaudio Rseven Instrukcja

15 Października 2024

Ruarkaudio MR1 Instrukcja

15 Października 2024

Denver TWE-55B Instrukcja

15 Października 2024

Audiosonic CL-1486 Instrukcja

14 Października 2024

Sangean DPR-39 Instrukcja

13 Października 2024

Roberts Stream 93i Instrukcja

13 Października 2024

Sangean RCR-9 Instrukcja

13 Października 2024

Uniden UH45CP Instrukcja

12 Października 2024

Muse M-178 P Instrukcja

10 Października 2024

Sencor SIR 5000WDB Instrukcja

10 Października 2024