Instrukcja obsługi Khyam Aerotech Nevada 4

Khyam Tent Aerotech Nevada 4

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Khyam Aerotech Nevada 4 (5 stron) w kategorii Tent. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/5
ERECTION INSTRUCTIONS
AEROTECH NEVADA 4
Before use
Please take me to read and understand the erecon instrucons. Failure to erect the tent
in accordance with the instrucons may result in damage to both fabric
and pole systems such damage cannot be covered by the warranty.
Warning!!
Do not push tent pegs in by hand, all tent pegs should be driven home using
a wooden or rubber faced mallet or similar tool.
To ensure maximum possible waterproong the main y sheet seams have been taped. Should the
tape be damaged and peel away you can eect a repair by using seam sealer around the problem area.
Seam sealer is available from most camping retailers. Please test any seam sealer on a small inconspicuous
area of your tent prior to proceeding. We also recommend that seam sealer is applied to untaped seams to
prevent leakage.
It is important that you do not allow seam sealer to contaminate
the teeth of any zips as this will prevent the zip from funconing correctly.
If you do use seam sealer it is best applied when the tent is dry. Pick a dry warm day to carry
out any sealing and please allow 48 hours for the sealant to cure prior to re-packaging the tent.
Failure to allow the sealant to dry fully prior to packing the tent
up will sck the fabric together possibly causing irreparable damage.
Further advice on sealing can be found in the FAQ area of our website www.khyam.co.uk
During use
Tents containing a high proporon of synthec materials are somemes affected by condensation,
this should not be confused with leakage and can usually be cured by ensuring that
adequate venlation is available by leaving doorways slightly unzipped wherever possible.
Do not pitch under trees, make use of natural wind breaks like hedges or walls, face the tent door away
from the prevailing wind.
Use two hands when opening and closing zips, this will help prevent premature zip failure.
read and understand the re precauons informaon aached to the inside of the tent.
Care of your tent warning!!
Tent fabrics can be weakened by prolonged exposure to sunlight, under
normal holiday use your tent will give you long service but
erection for extended periods in strong sunlight will cause deterioration.
If you are likely to use your tent for prolonged periods it would
be wise to use a site which is a shaded as possible. Applicaon of a proofer with UV protecon is
also strongly recommend if use in strong sunlight is envisaged.
Tents are best stored opened out, if this is not possible air fully and ensure it is
totally dry before packing it away at the end of your holiday.
Store your tent in a well venlated dry place.Look aer your tent and it will look aer you.
Have any damage to your tent repaired at the rst opportunity.
Zips should be treated with care to prevent premature failure and the tent should be
kept clean and dry aer use.
Insurance
We highly recommend that your tent be insured against theft and storm or accidental damage. Storm
or accidental damage is not covered by the warranty.
Check your equipment before going away with your tent. Ensure that you are familiar
with the pitching of the tent and that all parts are present.
You should familiarise yourself with the tent, including any limitaons
that it may have for your parcular use.
Tents are portable structures which under most circumstances will provide comfortable shelter
against the elements. There are however extremes of weather for which allowances should be made.
do not blame the tent !
PAGE 1
www.khyam.co.uk
ERECTION INSTRUCTIONS
AEROTECH NEVADA 4
ERECTING YOUR TENT
Remove the contents of the carry bag and idenfy all the component parts.
Flysheet
Inner tent
Air pump
Eyebrow Canopy Fibreglass pole set
Peg bag and contents
Select a site that is clear of any sharp objects, scks and stones e.t.c
THE PICTURES SHOWN IN THESE INSTRUCTIONS MAY NOT BE OF THE MODEL PURCHASED
BUT ARE INTENDED TO DEMONSTRATE THE COMMON PITCHING PROCEDURES FOR THIS
STYLE OF TENT/tent.
PAGE 2
www.khyam.co.uk
1/ Unfold the tent and layout on the ground
posioned ready to pitch.
2/ Pull out the fabric of the tent so that the sewn in
groundsheet is at and free from creases or folds.
Then securely peg the four corners. Please remember
that you may need to reposion the corner pegs aer
inaon.
3/ Starting from the rear of the tent, locate the small
zipped access panel (pictured upper right inset).
Open the zipped panel and then locate the inaon
valve as shown. Remove the dust cap to reveal the
inaon port.
4/ Before inaon you must check the position of the
central pin on the valve. The sprung pin is designed
to switch the valve between ‘ ’ mode foroneway
inaon and an ‘open’ mode for easy deaon.
With the pin in it’s ‘outer’ or ‘longest’ most posion
the valve will be in its ‘oneway’ mode, ready for
inaon. Now using the relevant connector (pictured
upper right inset) connect the nozzle of the pump
provided to the valve ready to inflate.
PAGE 3
www.khyam.co.uk
ERECTION INSTRUCTIONS
AEROTECH NEVADA 4
5/ Open the door zips so air can ow freely into the
tent during the inaon process.
Using the pump provided (pictured upper right inset)
start inang the Aerotech tube by pulling and
pushing the handle of the pump up and down, unl
the Aerotech tube starts to lift and take shape.
6 You may nd that you need to stop pumping and /
assist the Aerotech Tube to pop into shape by gently
liing at the centre. Inate to around 3psi at this
stage.
Once the Aerotech tube has lied and taken shape
you can remove the nozzle. A lile air will escape at
this point but this is only from the pressure in the
tube of the pump and not the tent.
Should the Aerotech tube deate on removal of the
nozzel then the valve was not in the correct mode.
Correct the valve posion (Point 4) and reinate.
7/ Moving forwards towards the front of the tent
repeat steps 3,4,5,& 6 on the second Aerotech tube
8/ Moving forwards towards the front of the tent
repeat steps 3,4,5,& 6 on the remaining Aerotech
tube/s
10/ Adjust and peg all guy ropes and intermediate
pegging points securely.
For further advice on pegging please go to the
Pegging Hints and Tips secon on page 5.
Finally recheck the pressure in each Aerotech Air
Tube which should be around 3.5 to 4psi. For further
advice on ination please go to the Aerotech
Inaon Frequently Asked Quesons section on
page 6.
11/ Taking the thin set of shockcorded breglass poles,
thread the pole set through the sleeves on the front of
the small ‘eyebrow’ canopy over the main door.
Sewn near to the main seam on each side of the
eyebrow canopy will be a small velcro webbing pocket.
Carefully open the ap of the webbing pocket
and locate the pole end into posion. Repeat this for
the opposite end of the pole and ensure both velcro
aps are securely closed holding the pole ends into
place.

Specyfikacje produktu

Marka: Khyam
Kategoria: Tent
Model: Aerotech Nevada 4

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Khyam Aerotech Nevada 4, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Tent Khyam

Khyam

Khyam Aerotech Nevada 4 Instrukcja

4 Października 2024
Khyam

Khyam Marseille 9 DLX Instrukcja

4 Października 2024
Khyam

Khyam Tourer 400 Plus Instrukcja

4 Października 2024
Khyam

Khyam Freerider Instrukcja

4 Października 2024
Khyam

Khyam Makalu 200 Instrukcja

4 Października 2024
Khyam

Khyam Almeria Instrukcja

4 Października 2024
Khyam

Khyam Nimbus Instrukcja

4 Października 2024
Khyam

Khyam Winnipeg Instrukcja

4 Października 2024
Khyam

Khyam Perpignan 6 Instrukcja

4 Października 2024
Khyam

Khyam Scafell 400 Instrukcja

4 Października 2024

Instrukcje Tent

Najnowsze instrukcje dla Tent

MSR

MSR Advance Pro 2 Instrukcja

7 Października 2024
MSR

MSR Mutha Hubba NX Instrukcja

7 Października 2024
MSR

MSR Hubba Hubba NX Instrukcja

7 Października 2024
Mx Onda

Mx Onda MX-ED2345 Instrukcja

7 Października 2024
Wechsel

Wechsel Endeavour Instrukcja

6 Października 2024
Wechsel

Wechsel Conqueror Instrukcja

6 Października 2024
Wechsel

Wechsel Aurora 1 Instrukcja

6 Października 2024
Gerjak

Gerjak Zuid 300 Instrukcja

5 Października 2024
Gerjak

Gerjak Noord 300 Instrukcja

5 Października 2024