Instrukcja obsługi Khyam Marseille 9 DLX

Khyam namiot Marseille 9 DLX

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Khyam Marseille 9 DLX (7 stron) w kategorii namiot. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/7
1
ERECTION INSTRUCTIONS
MARSEILLE 9 DLX
BEFORE USE
PLEASE TAKE TIME TO READ AND UNDERSTAND THE ERECTION INSTRUCTIONS. FAILURE
TO ERECT THE TENT IN ACCORDANCE WITH THE INSTRUCTIONS MAY RESULT IN
DAMAGE TO BOTH FABRIC AND POLE SYSTEMS. SUCH DAMAGE CANNOT BE COVERED BY
THE WARRANTY.
WARNING!!
DO NOT PUSH TENT PEGS IN BY HAND, ALL TENT PEGS SHOULD BE DRIVEN HOME USING
A WOODEN OR RUBBER FACED MALLET OR SIMILAR TOOL.
TO ENSURE MAXIMUM POSSIBLE WATERPROOFING THE MAIN FLY SHEET SEAMS HAVE BEEN
TAPED. SHOULD THE TAPE BE DAMAGED AND PEEL AWAY YOU CAN EFFECT A REPAIR BY
USING SEAM SEALER AROUND THE PROBLEM AREA.
WE ALSO RECOMMEND THAT SEEM SEALER IS APPLIED TO UNTAPED SEEMS TO PREVENT
LEAKAGE.
IT IS IMPORTANT THAT YOU DO NOT ALLOW SEAM SEALER TO CONTAMINATE THE TEETH OF
ANY ZIPS AS THIS WILL PREVENT THE ZIP FROM FUNCTIONING CORRECTLY.
IF YOU DO USE SEAM SEALER IT IS BEST APPLIED WHEN THE TENT IS DRY. PICK A DRY WARM
DAY TO CARRY OUT ANY SEALING AND PLEASE ALLOW 48 HOURS FOR THE SEALANT TO
CURE PRIOR TO RE-PACKAGING THE TENT.
FAILURE TO ALLOW THE SEALANT TO DRY FULLY PRIOR TO PACKING THE TENT UP WILL
STICK THE FABRIC TOGETHER POSSIBLY CAUSING IRREPARABLE DAMAGE.
DURING USE
TENTS CONTAINING A HIGH PROPORTION OF SYNTHETIC MATERIALS ARE SOMETIMES
AFFECTED BY CONDENSATION, THIS SHOULD NOT BE CONFUSED WITH LEAKAGE AND CAN
USUALLY BE CURED BY ENSURING THAT ADEQUATE VENTILATION IS AVAILABLE BY
LEAVING DOORWAYS SLIGHTLY UNZIPPED WHEREVER POSSIBLE.
DO NOT PITCH UNDER TREES, MAKE USE OF NATURAL WIND BREAKS LIKE HEDGES OR
WALLS, FACE THE TENT DOOR AWAY FROM THE PREVAILING WIND. USE TWO HANDS WHEN
OPENING AND CLOSING ZIPS, THIS WILL HELP PREVENT PREMATURE ZIP FAILURE.
READ AND UNDERSTAND THE FIRE PRECAUTIONS INFORMATION ATTACHED TO THE INSIDE
OF THE TENT.
CARE OF YOUR TENT WARNING!!
TENT FABRICS CAN BE WEAKENED BY PROLONGED EXPOSURE TO SUNLIGHT, UNDER
NORMAL HOLIDAY USE YOUR TENT WILL GIVE YOU LONG SERVICE BUT ERECTION FOR
EXTENDED PERIODS IN STRONG SUNLIGHT WILL CAUSE DETERIORATION.
IF YOU ARE LIKELY TO USE YOUR TENT FOR PROLONGED PERIODS IT WOULD BE WISE TO USE
A SITE WHICH IS A SHADED AS POSSIBLE.
TENTS ARE BEST STORED OPENED OUT, IF THIS IS NOT POSSIBLE AIR FULLY AND ENSURE IT
IS TOTALLY DRY BEFORE PACKING IT AWAY AT THE END OF YOUR HOLIDAY.
STORE YOUR TENT IN A WELL VENTILATED DRY PLACE. LOOK AFTER YOUR TENT AND IT
WILL LOOK AFTER YOU.
HAVE ANY DAMAGE TO YOUR TENT REPAIRED AT FIRST OPPORTUNITY.
FAILURES IN FIBERGLASS POLES NORMALLY OCCUR THROUGH INCORRECT USE, MAKE SURE
THE POLE SECTIONS ARE FULLY INSERTED INTO THEIR ADJOINING FERULES AND DO NOT
2
OVER STRESS THE POLE BEYOND IT S DESIGNED CURVE. ZIPS SHOULD BE TREATED WITH
CARE TO PREVENT PREMATURE FAILURE AND THE TENT SHOULD BE KEPT CLEAN AND DRY
AFTER USE.
INSURANCE
WE HIGHLY RECOMMEND THAT YOUR TENT BE INSURED AGAINST THEFT AND STORM OR
ACCIDENTAL DAMAGE. STORM OR ACCIDENTAL DAMAGE IS NOT COVERED BY THE
WARRANTY.
CHECK YOUR EQUIPMENT BEFORE GOING AWAY WITH YOUR TENT. ENSURE THAT YOU ARE
FAMILIAR WITH THE PITCHING OF THE TENT AND THAT ALL PARTS ARE PRESENT.
YOU SHOULD FAMILIARIZE YOURSELF WITH THE TENT, INCLUDING ANY LIMITATIONS THAT
IT MAY HAVE FOR YOUR PARTICULAR USE.
DOME TENTS ARE PORTABLE STRUCTURES WHICH UNDER MOST CIRCUMSTANCES WILL
PROVIDE COMFORTABLE SHELTER AGAINST THE ELEMENTS. THERE ARE HOWEVER
EXTREMES OF WEATHER FOR WHICH ALLOWANCES SHOULD BE MADE.
DO NOT BLAME THE TENT !
ERECTING YOUR TENT
PLEASE NOTE THE MARSEILLE 9 IS A LARGE FAMILY TENT AND WE STRONGLY
RECOMMEND IT IS ERECTED BY A MINIMUM OF TWO ADULTS.
1: REMOVE THE CONTENTS OF THE CARRY BAG AND IDENTIFY ALL THE COMPONENT PARTS.
· INNER TENTS
· FLYSHEET
· POLE BAG AND CONTENTS
·
PEG BAG AND CONTENTS
2: SELECT A SITE THAT IS CLEAR OF ANY SHARP OBJECTS, STICKS AND STONES E.T.C
3: IN THE POLE BAG, THERE SHOULD BE NINE SETS OF MAIN SHOCKCORDED FIBERGLASS
POLES.
ALL POLES WILL BE MARKED WITH A COLOURED STICKER, THIS WILL CORRESPOND TO A
COLOURED TRIM ON THE EDGE OF THE SLEEVE THAT THE POLE IS INTENDED TO FIT
THROUGH.
4: UNFOLD THE FLYSHEET AND SPREAD OUT ON THE FLOOR SO YOU ARE ABLE TO SEE ALL
THE SLEEVE SECTIONS OF THE ROOF.
MAIN DOME SECTION
START WITH THE CENTRAL DOME SECTION TAKE ONE OF THE MAIN DOME SHOCKCORDED
FIBERGLASS POLES. CHECK THE POLE STICKER COLOUR AND MATCH WITH THE RELEVANT
ROOF SLEEVE, THEN THREAD THE POLE THROUGH THE SLEEVE SECTIONS IN A DIAGONAL
FASHION, SO THERE IS AN EQUAL LENGTH OF POLE PROTRUDING FROM EITHER SIDE OF THE
SLEEVE ENDS. REPEAT THIS WITH THE SECOND MAIN DOME POLE.
AT THIS POINT HELP FROM THE SECOND PERSON PRESENT WILL MAKE THE FOLLOWING
PROCESS MUCH EASIER. WITH THE FLYSHEET ON THE FLOOR, FIND A DOORWAY AND
CAREFULLY ENTER THE TENT CRAWLING UNDER THE FLYSHEET UNTIL YOU GET TO THE
MIDDLE OF THE CENTRAL DOME SECTION. CAREFULLY PUSH THE CENTRE OF THE TENT UP
AND SUPPORT THE CENTRAL SECTION, WHISLT THE OTHER PERSON LOCATES THE MAIN
DOME POLES INTO POSITION.
3
WITH THE SECOND PERSON IN POSITION AND SUPPORTING THE CENTRE OF THE MAIN DOME,
CHOOSE ONE END OF ONE POLE AND ENGAGE THE END FERRULE INTO THE POLE RETAINING
FIXTURE OR EYELET. THIS WILL BE LOCATED AT THE BASE OF THE FLYSHEET, NEAR TO THE
SEAM RUNNING DOWN FROM THE SLEEVE, IN WHICH THE POLE IS LOCATED. EACH POLE
RETAINING FIXTURE WILL HAVE A METAL RING WITH ONE OR MORE RETAINING PINS
ATTACHED TO IT (DEPENDANT UPON MODEL) THE RETAINING PIN IS DESIGNED TO SLIDE UP
INSIDE THE POLE ENDS THUS SECURING THE POLE INTO PLACE.
FROM THE OPPOSITE END OF THE SAME POLE CAREFULLY PUSH THE REMAINING POLE
THROUGH THE SLEEVES SO IT ASSUMES A SEMI-CIRCULAR SHAPE. WHEN THE END FERRULE
IS LEVEL TO THE POLE RETAINING FIXTURE OR EYELET ON THIS SIDE, ENGAGE IT INTO
PLACE AS BEFORE.
REPEAT THIS ON THE SECOND MAIN DOME POLE SET.
PLEASE NOTE ON SOME MODELS THERE MAY BE AN ADJUSTABLE WEBBING LOOP
CONNECTING THE RING TO THE BASE OF THE FLYSHEET. THIS LOOP SHOULD BE OPENED UP
TO ITS FULL LENGTH WHILE ENGAGING THE PIN ON THE RING INTO THE POLE END. ONCE THE
PIN IS INSERTED THE WEBBING LOOP CAN BE TIGHTENED SO THE POLE IS FIRMLY LOCKED
INTO THE POLE END.
ENSURE CARE IS TAKEN DURING THIS PROCEDURE, NOT TO ALLOW THE ENDS OF THE
SHOCKCORDED POLES TO DAMAGE SLEEVES OR FLYSHEET MATERIAL.
RUNNING DOWN THE SEAM, FROM THE SLEEVE, ON EACH SIDE OF THE TENT YOU WILL
NOTICE THREE FLYSHEET TO MAIN POLE WEBBING CLIPS. ALL THESE, SHOULD SIMPLY BE
CLIPPED TO THE MAIN SHOCKCORDED POLES ALLOWING THE FLYSHEET TO TAKE FULL
SHAPE. PLEASE NOTE THAT THESE ARE NOT INTENDED AS GUY POINT FIXINGS.
THE MAIN CENTRAL DOME SECTION SHOULD NOW BE STANDING AND CAN BE TEMPORALLY
PEGGED. IN WINDY WEATHER YOU MAY ALSO WANT TO PEG THE GUY POINTS LOCATED
NEAR TO THE ROOF OF THE MAIN DOME. PLEASE REMEMBER THAT THESE AND ANY PEG
POINTS WILL NEED TO BE READJUSTED LATER.
BEDROOM SECTIONS
TAKING THE BEDROOM SECTION POLES, CHECK THE COLOURED STICKER ON EACH POLE AND
THREAD THE POLES THROUGH THE RELEVANT SLEEVES ON BOTH BEDROOM SECTIONS.
ONCE BOTH BEDROOM POLES HAVE BEEN THREADED THROUGH THE SLEEVES ON BOTH
BEDROOM SECTIONS YOU CAN LOCATE THE POLES INTO PLACE AS BEFORE.
STARTING WITH ONE BEDROOM SECTION AT A TIME, CHOOSE ONE END OF ONE POLE AND
ENGAGE THE END FERRULE INTO THE POLE RETAINING FIXTURE OR EYELET. THIS WILL BE
LOCATED AT THE BASE OF THE FLYSHEET, NEAR TO THE SEAM RUNNING DOWN FROM THE
SLEEVE, IN WHICH THE POLE IS LOCATED. EACH POLE RETAINING FIXTURE WILL HAVE A
METAL RING WITH ONE OR MORE RETAINING PINS ATTACHED TO IT (DEPENDANT UPON
MODEL) THE RETAINING PIN IS DESIGNED TO SLIDE UP INSIDE THE POLE ENDS THUS
SECURING THE POLE INTO PLACE.
FROM THE OPPOSITE END OF THE SAME POLE CAREFULLY PUSH THE REMAINING POLE
THROUGH THE SLEEVES SO IT ASSUMES A SEMI-CIRCULAR SHAPE. WHEN THE END FERRULE
IS LEVEL TO THE POLE RETAINING FIXTURE OR EYELET ON THIS SIDE, ENGAGE IT INTO
PLACE AS BEFORE.
PLEASE NOTE ON SOME MODELS THERE MAY BE AN ADJUSTABLE WEBBING LOOP
CONNECTING THE RING TO THE BASE OF THE FLYSHEET. THIS LOOP SHOULD BE OPENED UP
TO ITS FULL LENGTH WHILE ENGAGING THE PIN ON THE RING INTO THE POLE END. ONCE THE
PIN IS INSERTED THE WEBBING LOOP CAN BE TIGHTENED SO THE POLE IS FIRMLY LOCKED
INTO THE POLE END.


Specyfikacje produktu

Marka: Khyam
Kategoria: namiot
Model: Marseille 9 DLX

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Khyam Marseille 9 DLX, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje namiot Khyam

Khyam

Khyam Aerotech Nevada 4 Instrukcja

4 Października 2024
Khyam

Khyam Marseille 9 DLX Instrukcja

4 Października 2024
Khyam

Khyam Tourer 400 Plus Instrukcja

4 Października 2024
Khyam

Khyam Freerider Instrukcja

4 Października 2024
Khyam

Khyam Makalu 200 Instrukcja

4 Października 2024
Khyam

Khyam Almeria Instrukcja

4 Października 2024
Khyam

Khyam Nimbus Instrukcja

4 Października 2024
Khyam

Khyam Winnipeg Instrukcja

4 Października 2024
Khyam

Khyam Perpignan 6 Instrukcja

4 Października 2024
Khyam

Khyam Scafell 400 Instrukcja

4 Października 2024

Instrukcje namiot

Najnowsze instrukcje dla namiot

SereneLife

SereneLife SLTET30 Instrukcja

9 Października 2024
Calima

Calima 46074 Instrukcja

9 Października 2024
SereneLife

SereneLife SLPTLB106 Instrukcja

9 Października 2024
SereneLife

SereneLife SLPTSR107 Instrukcja

9 Października 2024
SereneLife

SereneLife SLPTMR108 Instrukcja

9 Października 2024
SereneLife

SereneLife SLPTMLR109 Instrukcja

9 Października 2024
Brunner

Brunner Beyond Instrukcja

8 Października 2024