Instrukcja obsługi Jindara Hamersley MK2 Freestanding

Jindara Podgrzewacz Hamersley MK2 Freestanding

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Jindara Hamersley MK2 Freestanding (16 stron) w kategorii Podgrzewacz. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/16
Operation & Installation Instructions
Hamersley MK2 Freestanding
Please keep these instructions for future reference.Rev* 235798
Hamersley MK2 Freestanding 12
A.F. Gason Pty Ltd reserves the right to modify or alter specications, material etc. in the interest of product improvement
WARRANTY
Heating
A division of A.F. Gason Pty. Ltd.
1. Subject to clauses 2 & 3 of this Warranty, A.F. Gason Pty Ltd ACN 004 667 556 (Gason warrants the follow components of its heaters against defects in workmanship
and/or materials for the following periods from the date of purchase:
a) the rebox for ten years;
b) the paint nish for a period of twelve months if the Purchaser has followed the instructions provided by Gason in the Operation and Installation Instructions manual; and
c) all other components for twelve months execpt the glass, re brick lining or bae plate if, in the opinion of Gason, these ite ms have been damaged by impact.
2. This extended warranty does not apply;
a) if the heater is purchased from a person who has not been authorised by Gason to sell its products;
b) if, in the opinion of Gason, the heater or any other component has been subject to abuse, misuse, alteration, modication or has not been installed, operated or maintained in
accordance with the instructions provided by Gason; or,
c) to owne rs other then the original Purchaser.
3. If you believe that the heater you purchased contains a manufacturing defect and you wish to make a claim under this Warranty, please contact an authorised Gason service
centre to arrange for an assessment.
4. If, after assessing the heater, Gason determines that the heater contains a manufacturing fault, Gason may at its discretion:
a) re place the heater;
b) repair or replace specic components of the heater; or
c) provide a full refund.
5. Parts replaced under warranty are warranted for the balance of their original warranty period.
6. If, at the discretion of Gason, the heater or any part needs to be replaced, serviced or repaired at an authorised Gason service centre, then the person claiming under this
Warranty must pay all costs associated with:
a) returning the heater; and
b) the delivery or collection of any new or repaired heater.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for
compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
Any benets you receive under these warranties are in addition to other rights and remedies that you may have as a consumer under a law in relation to the heater to which
these warranties relate.
These warranties are given by:
A.F. Gason Pty. Ltd.
Blake Street
Ararat VIC 3377
Please contact us if you have any queries on:
Phone: 03 97632700
or email us via the “Contact Us” section of our website: www.gason.com.au
Hamersley MK2 Freestanding 2 Hamersley MK2 Freestanding 11
PAGE INTENTIONALLY BLANK
T
Read and follow these instructions carefully before installing and
u
sing this appliance
S
AVE THESE INSTRUCTIONS
WARNING
!
WARNING
!
Safety Warnings
•
A ue re with resulting damage may occur if the appliance is not installed,
operated and maintained as per this booklet.
• Never place combustible materials such as wood, paper or furniture near the
appliance.
• This appliance is designed to burn dry hardwood. Do not burn rubbish,
driftwood, ammable liquids or any substance containing salts or corrosives.
• This appliance must not be installed and operated in an area where kerosene,
petrol, paint thinner or other ammable liquid is used or stored.
• The ue system must be inspected and cleaned annually or sooner if required.
Failure to do so could result in an excessive build up of creosote which may
result in a ue re which may damage the ue or cause damage to your home.
• The surface of the appliance becomes hot during operation. Do not touch the
surface of this appliance. Keep children away from this appliance during
operation. Do not allow anyone to operate this appliance who is not familiar
with this instruction booklet.
WARNING
!
Paint Curing and Care
Your heater is coated with the best available heat resistant paint. Even though
t
he paint has been baked after application, it may require further temperature
c
uring. It may, if you overre the heater on its rst re, discolour. For your rst
t
wo or three rings, never exceed the medium air setting and always have the fan
o
n when above low burn. Do not wipe the heater while the paint is curing. After
t
he paint has cured the only maintenance required to maintain the heater’s nish
i
s to wipe it with a soft cloth. Do not use any commercial cleaners or solvents on
t
he paint nish.
W
e are proud of the presentation of our products. If at any time you need to
f
reshen up the paint, your local dealer has touch up paint available for purchase.
Y
ou may even change the colour of your heater if you wish.
If you have any enquiries, please contact the dealer from whom you purchased your heater:
P
LEASE COMPLETE:
D
ealer Name
D
ealer Address
Phone:
P
lease attach your original purchase dockets to this booklet for future reference.
Hamersley MK2 Freestanding 10 Hamersley MK2 Freestanding 3
Installation
WARNING
!
Installation
THE INS TALLATION OF THIS APPLIANCE MUST BE CARRIED OUT AS PER THIS
MANUAL AND THE FLUE MANU FA ACTURER’S SPECIFIC TIONS.
WE RECOMMEND TH AT YOU USE A QUALIFIED INS TALLER TO RY TCAR OU
THE INS TALLATION.
If you have any other enquirie please contact the dealer from whom yo s, u
purchased your heate r.
THIS APPLIANCE WEIGHS IN EXCESS OF 190 KILOGRAM S. EEXTREME CAR
SHOULD BE TAKEN WHEN HANDLING THE APPLIANCE.
Troubleshooting (continued)
• Smoke entering the room from the rebox when the door is open may be caused by
• Insucient length of ue (ue to be 4500mm minimum underneath the base of heater to
underside of cowl)
Increase height of ue
• Flue downdraught
Consult dealer or increase height of ue.
• Creosote buildup in ue
Remove cowl and clean ue as per cleaning instructions. Check moisture content of wood.
• Excessive ash build up
Some woods will give large amounts of ash despite how you run the he ater. Others will give you very little.
Use the wood which is most convenient for you as long as it is dry. After a period of time you will get to
know when to empty your unit. Bark will give you excessive ash. Try not to burn it.
If you are burning wood that gives you charcoal, you may nd that after running the heater say for 8 hours
at maximum burn rate, the charcoal builds up excessively. Overnight burn will reduce this charcoal back to
a ne ash. If you are not ready to shut down for overnight burn when you next fuel the stove, load the
stove with only one piece of wood and lay it across the rebox on top of the charcoal. Open the air control
wide open and you will nd the charcoal will burn down with the one piece of wood. Repeat the process
until the ash level is signicantly reduced.
A.F. Gason Pty. Ltd. accepts no liability whatsoever for interpretation of AS/NZS 2918:2001
It is important you understand these installation instructions and minimum clearances to combustible materials
before selecting a position for your Jindara Hamersley to ensure safe and correct installation is achieved.
Installation Permit
Depending on your local authority requirements, a permit may be required for the installation of your heater.
It is your responsibility to arrange for these requirements to be met.
Clearances
All dimensions used in this document are in millimetres and are minimum unless otherwise stated. These
dimensions state the minimum distance the Jindara Hamersley can be placed in relation to any combustible
materials - plaster, wallpaper, timber, MDF, etc.
In the instance your Jindara Hamersley is surrounded by non-combustible materials – brick, stone, concrete,
cement sheet, Villaboard or similar, wall clearances can be reduced to 100mm. A 100mm clearance is required,
to ensure room air can circulate around the wood heater during operation.
The Jindara Hamersley freestanding heater conforms to AS/NZS 2918:2001 when positioned in relation to
combustible surfaces as shown in the graphic on the following page.
For additional clearance details, please contact the Jindara dealer from whom you purchased your heater.
Hearth requirements
If the Jindara Hamersley will be installed onto a non-combustible oor such as stone, a concrete slab
with tiles, brick, etc. with a thickness of at least 24mm, extending at least 530mm in front of the appliance base,
a hearth or oor protector may not be required.
If the Jindara Hamersley is to be installed onto a combustible oor, a minimum 24mm cement sheet or similar
non-combustible hearth or oor protector must be placed on top of the combustible oor. At a minimum, the
oor protector must extend 530mm in front of the appliance base. The protector must be at least 1000mm wide
(central to the appliance) and 1100mm deep. If desirable, the oor protector can extend further, to meet the
skirting boards or walls at the rear of the appliance, when installed as per the wall clearances.
For details please refer to the diagrams on the next page.

Specyfikacje produktu

Marka: Jindara
Kategoria: Podgrzewacz
Model: Hamersley MK2 Freestanding

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Jindara Hamersley MK2 Freestanding, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Podgrzewacz Jindara

Jindara

Jindara Kimberley Mk2 Instrukcja

22 Września 2024
Jindara

Jindara Hamersley MK2 Freestanding Instrukcja

21 Września 2024
Jindara

Jindara Tilga Instrukcja

20 Września 2024
Jindara

Jindara Hamersley Mk2 Instrukcja

19 Września 2024
Jindara

Jindara Riverina Instrukcja

16 Września 2024
Jindara

Jindara Mallee Instrukcja

14 Września 2024
Jindara

Jindara Spectre Instrukcja

14 Września 2024
Jindara

Jindara Grange Instrukcja

13 Września 2024
Jindara

Jindara Gawler Instrukcja

11 Września 2024
Jindara

Jindara Sturt Instrukcja

11 Września 2024

Instrukcje Podgrzewacz

Najnowsze instrukcje dla Podgrzewacz

Electrolux

Electrolux EO12D103C0 Instrukcja

21 Grudnia 2024
Electrolux

Electrolux EO12D104C0 Instrukcja

21 Grudnia 2024
NewAir

NewAir AH-450B Instrukcja

20 Grudnia 2024
NewAir

NewAir NGH1K6WH00 Instrukcja

20 Grudnia 2024
Sencor

Sencor SOH 8211GY Instrukcja

20 Grudnia 2024
Yamazen

Yamazen DSF-VE121 Instrukcja

19 Grudnia 2024
Yamazen

Yamazen DSE-SKC103 Instrukcja

19 Grudnia 2024
Yamazen

Yamazen DBC-L122 Instrukcja

19 Grudnia 2024
Yamazen

Yamazen DMSF-J062 Instrukcja

19 Grudnia 2024
Yamazen

Yamazen DC-ZT12 Instrukcja

19 Grudnia 2024