Instrukcja obsługi Janome MC6300
Janome
Naaimachines
MC6300
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Janome MC6300 (69 stron) w kategorii Naaimachines. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/69
INSTRUCTION BOOK
IMPORTANT SAFETY INSTRUCTIONS
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabiliti es, or lack of experience and knowledge, unless they have been given supervision or instruction concern-
ing use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with this sewing machine.
When using an electrical appliance, basic safety precautions should always be followed, including the
following:
This sewing machine is designed and manufactured for household use only.
Read all instructions before using this sewing machine.
DANGER— To reduce the risk of electric shock:
1. An appliance should never be left unattended when plugged in. Always unplug this sewing
machine from the electric outlet immediately after using and before cleaning.
2. Always unplug before replacing a sewing machine bulb. Replace bulb with same type rated 12 Volts,
5 W tts.a
WARNING—To reduce the risk of burns, fire, electric shock, or injury to persons:
1. Do not allow to be used as a toy. Close attention is necessary when this sewing machine is used
by or near children.
2. Use this appliance only for its intended use as described in this ownerʼs manual.
Use only attachments recommended by the manufacturer as contained in this ownerʼs manual.
3. Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly, if
it has been dropped or damaged, or dropped into water.
Return this sewing machine to the nearest authorized dealer or service center for examination,
repair, electrical or mechanical adjustment.
4. Never operate the appliance with any air opening blocked. Keep ventilation openings of this
sewing machine and foot controller free from accumulation of lint, dust and loose cloth.
5. Never drop or insert any object into any opening.
6. Do not use outdoors.
7. Do not operate where aerosol (spray) products are being used or where oxygen is being
administered.
8. To disconnect, turn all controls to the off (“O”) position, then remove plug from outlet.
9. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
10. Keep fingers away from all moving parts. Special care is required around the sewing machine
needle and/or cutting blade.
11. Always use the proper needle plate. The wrong plate can cause the needle to break.
12. Do not use bent needles.
13. Do not pull or push fabric while stitching. It may deflect the needle causing it to break.
14. Switch this sewing machine off (“O”) when making any adjustment in the needle area, such as
threading the needle, changing the needle, threading the bobbin or changing the presser foot, and
the like.
15. Always unplug this sewing machine from the electrical outlet when removing covers, lubricating, or
when making any other adjustments mentioned in this ownerʼs manual.
SAVE THESE INSTRUCTIONS
The design and specifications are subject to change without a prior notice.
Please note that on disposal, this product must be safely recycled in accordance with relevant National
legislatio n relating to electrical/electronic products. If in doubt please contact your retailer for guidance.
(European Union only)
OPERATING INSTRUCTION:
For appliances with a polarized plug (one blade wider than the other):
To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only
one way.
If the plug does not fit fully in the outlet, reverse the plug.
If it still does not fit, contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
Foot Controller 21371 for use with this sewing machine.
Do’s and Don’ts
1. Always be aware of the up-and-down movement of the needle and do not turn your attention
away from the machine while it is running.
2. When leaving the sewing machine unattended, the main switch of the machine must be
switched off or the plug must be removed from the socket-outlet.
3. When servicing the sewing machine, or when removing covers or changing lamps, the machine
must be disconnected from the power supply by removing the plug from the socket-outlet.
4. Do not place anything on the foot control, otherwise the machine will start inadvertently, or the
control or motor may burn out.
5. The maximum permissible power for the sewing lamp bulb is 5 watts.
6. When using your sewing machine for the first time, place a piece of waste fabric under the
presser foot and run the machine without thread for a few minutes. Wipe away any oil which
may have appeared.
Specyfikacje produktu
| Marka: | Janome |
| Kategoria: | Naaimachines |
| Model: | MC6300 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Janome MC6300, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Naaimachines Janome
6 Lipca 2024
3 Lipca 2024
Instrukcje Naaimachines
- Naaimachines Toyota
- Naaimachines Singer
- Naaimachines Brother
- Naaimachines Baby Lock
- Naaimachines Bernina
- Naaimachines Juki
- Naaimachines Kenmore
- Naaimachines Pfaff
- Naaimachines Kunft
- Naaimachines Sewmaq
- Naaimachines Jata
- Naaimachines Elna
- Naaimachines Yamato
- Naaimachines RCE
- Naaimachines White
- Naaimachines Vendomatic
- Naaimachines Silver
Najnowsze instrukcje dla Naaimachines
9 Sierpnia 2024
9 Sierpnia 2024
9 Sierpnia 2024
9 Sierpnia 2024
9 Sierpnia 2024
9 Sierpnia 2024
9 Sierpnia 2024
9 Sierpnia 2024
9 Sierpnia 2024
8 Sierpnia 2024