Instrukcja obsługi Interlogix WMC252-1W-1T-300

Interlogix Punkt dostępu WMC252-1W-1T-300

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Interlogix WMC252-1W-1T-300 (93 stron) w kategorii Punkt dostępu. Ta instrukcja była pomocna dla 12 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/93
I
WMC252 1W 1T- - - 300
User Manual
P/N 1073055 • REV A • ISS 15OCT15
II
Copyright
© 2015 United Technologies Corporation
Interlogix is part of UTC Building & Industrial Syste
ms, Inc. a unit of United
Technologies Corporation.
All rights reserved.
Trademarks and
patents
The WMC252 Series name and logo are trademarks of United Technologies.
Other trade names used in this document may be trademarks or registered
trademarks of
the manufacturers or vendors of the respective products.
Manufacturer
Interlogix
3211 Progress Drive, Lincolnton, NC 28092 USA
Authorized EU manufacturing representative:
UTC Climate Controls & Security B.V.,
Kelvinstraat
7, 6003 DH Weert, Netherlands
Intended use
Use this product only for the purpose it was designed for; refer to the data sheet
and user documentation for details. For the latest product information, contact
your local supplier or visit us online at www.in
terlogix.com.
Certification
ACMA compliance
Notice!
This is a Class B product. In a domestic environment this product may
cause radio interference in which case the user may be required to take
adequate measures.
European Union
directives
2004/108/EC (EMC Directive):
Hereby, UTC Building & Industrial Systems, Inc.
declares that this device is in compliance with the essential requirements and
other relevant provisions of Directive 2004/108/EC.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his/her own
expense. Any changes or modifications not expressly approved by UTC could void the user’s
authority to operate this equipment under the rules and regulations of the FCC.
FCC Caution:
To assure continued compliance, ( use only shielded interface cables when connecting for example,
to computer or peripheral devices) any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference
(2) T dhis evice must accept any interference received, including interference that may cause
undesired operation.
III
Federal Communication Commission (FCC) Radiation Exposure Statement
This equipment complies with FCC radiation exposure set forth for an uncontrolled environment. In
order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity
to the antenna shall not be less than 20 cm (8 inches) during normal operation.
CAUTION: Changes or modifications not expressly approved by UTC for compliance could void the
user’s authority to operate the equipment.
CE Mark Warning
This is a Class B product. In a domestic environment, this product may cause radio interference, in
which case the user may be required to take adequate measures.
Energy Saving Note of the Device
This power required device does not support Standby mode operation. For energy saving, please
remove the DC plug to disconnect the device from the power circuit. Without remov the DC- ing -plug,
the device still consum power from the power circuit. In view of Saving the Energyes , it is strongly
suggested to remove the DC plug for the device if this device is not intended to be active.-
Canadian Compliance
This Class B digital apparatus meets all requirements of the Canadian Interference Causing
Equipment Regulations. Cet appareil numérique de la classe B respects toutes les exigences du
Règlement sur le matériel brouilleur du Canada.
Canada - Industry Canada (IC)
The wireless radio of t vice complies with RSS 247 and RSS 102 of Industry Canada.his de
This Class B digital device complies with Canadian ICES 003 (NMB- -003).
Cet appareil numérique de la classe B respects toutes les exigences du Règlement sur le matériel
brouilleur du Canada.
This device complies with Industry Canada’s licence exempt RSSs. Operation is subject to the -
following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
WMC25 1W 1T2- - - - 2 300 complies with IC requirements, IC: 20201 WMC25 300.

Specyfikacje produktu

Marka: Interlogix
Kategoria: Punkt dostępu
Model: WMC252-1W-1T-300

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Interlogix WMC252-1W-1T-300, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Punkt dostępu Interlogix

Interlogix

Interlogix WMC252-1W-1T-300 Instrukcja

15 Sierpnia 2024

Instrukcje Punkt dostępu

Najnowsze instrukcje dla Punkt dostępu

Peplink

Peplink AP One AX Instrukcja

20 Marca 2025
Cisco

Cisco Aironet 3600i Instrukcja

15 Stycznia 2025
Luxul

Luxul P40 Instrukcja

14 Stycznia 2025
Luxul

Luxul XAP-1440 Instrukcja

14 Stycznia 2025
Ubiquiti Networks

Ubiquiti Networks UniFi AP Flex HD Instrukcja

12 Stycznia 2025
Mikrotik

Mikrotik LTAP Mini LTE kit Instrukcja

30 Grudnia 2025
TP-Link

TP-Link Omada EAP115-Wall Instrukcja

30 Grudnia 2025
D-Link

D-Link AirXpert DWL-7000AP Instrukcja

23 Grudnia 2024
EQ-3

EQ-3 HMIP-HAP Instrukcja

15 Grudnia 2024
Vimar

Vimar 20195.N Instrukcja

15 Grudnia 2024