Instrukcja obsługi Cisco Aironet 3600i

Cisco Punkt dostępu Aironet 3600i

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Cisco Aironet 3600i (31 stron) w kategorii Punkt dostępu. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/31
G ETTING S GTARTED UIDE
Cisco Aironet 3600 Series Lightweight Access Points
Last Updated: March 31, 2015
1About this Guide
2Introduction to the Access Point
3Safety Instructions
4Unpacking
5Configurations
6Access Point Ports and Connectors
7Configuring the Access Point
8Mounting the Access Point
9Deploying the Access Point on the Wireless Network
10 Installing Modules
11 Troubleshooting
12 Declarations of Conformity and Regulatory Information
13 Configuring DHCP Option 43 and DHCP Option 60
14 Access Point Data Sheet
15 Obtaining Documentation and Submitting a Service Request
2
1 About this Guide
This Guide provides instructions on how to install and configure your Cisco Aironet 3600 Series Access Point and how to install
any port modules. This guide also provides mounting instructions and limited troubleshooting procedures.
The 3600 Series Access Point is referred to as the access point in this document.
2 Introduction to the Access Point
The 3600 series supports high-performing Spectrum Intelligence which sustains three spatial stream rates over a deployable
distance with high reliability when serving clients. The 3600 series provides high reliability and overall wireless performance.
The 3600 series offers dual-band radios (2.4 GHz and 5 GHz) with integrated and external antenna options. The access points
support full inter-operability with leading 802.11n clients, and support a mixed deployment with other access points and
controllers.
The 3600 series access point is a controller-based (Unified) product and supports:
• Simultaneous dual-band (2.4 GHz/5 GHz) radios
• Integrated antennas on the 3602I access point model (AIR-CAP3602I-x-K9, AIR-AP3602I-UXK9)
• External antennas for rugged 3602E access point model (AIR-CAP3602E-x-K9, AIR-AP3602E-UXK9)
Note The ‘x’ in the model numbers represents the regulatory domain. Model numbers containing -UX, support the
universal regulatory domain. Refer to “Regulatory Domains” section on page 5 for a list of supported regulatory
domains.
The features of the 3600 series are:
• Processing sub-systems (including CPUs and memory) and radio hardware which supports:
–
Network management
–
CleanAir —Automatic detection, classification, location and mitigation of RF interference
–
ClientLink+ —BeamForming to 802.11n clients as well as legacy 802.11a/g OFDM clients
–
VideoStream
–
Location
–
WIDS/WIPS
–
Security
–
Radio Resource Management (RRM)
–
Rogue detection
–
Management Frame Protection (MFP)
–
Throughput, forwarding, and filtering performance scaled to meet 3 spatial stream 450 Mbps data-rates
• 32 MB flash size
• 802.11af/at
–
CDP (Cisco Discovery Protocol)
• 2.4 GHz and 5 GHz 802.11n radios with the following features:
–
4TX x 4RX
–
3-spatial streams, 450 Mbps PHY rate
–
Spectrum intelligence
–
DPD (Digital Pre-Distortion) technology
–
Cisco Vector Beamforming—Implicit Co-phase beamforming for .11ag clients and 1x1 11n clients
–
Radio hardware is capable of explicit compressed beamforming (ECBF) per 802.11n standard
3
3 Safety Instructions
Translated versions of the following safety warnings are provided in the translated safety warnings document that is shipped
with your access point. The translated warnings are also in the Translated Safety Warnings for Cisco Aironet Access Points,
which is available on Cisco.com.
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any
equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for
preventing accidents. Use the statement number provided at the end of each warning to locate its translation in
the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Warning
Read the installation instructions before you connect the system to its power source.
Statement 1004
Warning
Installation of the equipment must comply with local and national electrical codes.
Statement 1074
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than:
20A.
Statement 1005
Warning
Do not operate your wireless network device near unshielded blasting caps or in an explosive environment unless
the device has been modified to be especially qualified for such use.
Statement 245B
Warning
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a minimum of 7.9
inches (20 cm) or more from the body of all persons.
Statement 332
Caution The fasteners you use to mount an access point on a ceiling must be capable of maintaining a minimum pullout
force of 20 lbs (9 kg) and must use all 4 indented holes on the mounting bracket.
Caution This product and all interconnected equipment must be installed indoors within the same building, including the
associated LAN connections as defined by Environment A of the IEEE 802.af Standard.
Note The access point is suitable for use in environmental air space in accordance with section 300.22.C of the National
Electrical Code and sections 2-128, 12-010(3), and 12-100 of the Canadian Electrical Code, Part 1, C22.1. You should
not install the power supply or power injector in air handling spaces.
Note Use only with listed ITE equipment.

Specyfikacje produktu

Marka: Cisco
Kategoria: Punkt dostępu
Model: Aironet 3600i

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Cisco Aironet 3600i, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Punkt dostępu Cisco

Cisco

Cisco Aironet 3600i Instrukcja

15 Stycznia 2025
Cisco

Cisco MR12 Instrukcja

14 Października 2024
Cisco

Cisco AIR-CAP702I-I-K9 Instrukcja

4 Października 2024
Cisco

Cisco Meraki MR74 Instrukcja

3 Października 2024
Cisco

Cisco Aironet 1142N Instrukcja

27 Września 2024
Cisco

Cisco Meraki MR72 Instrukcja

19 Września 2024
Cisco

Cisco AIR-CAP702I-S-K9 Instrukcja

17 Września 2024
Cisco

Cisco Meraki MR42 Instrukcja

13 Września 2024
Cisco

Cisco Aironet 1810 Instrukcja

10 Września 2024
Cisco

Cisco Aironet 3700E Instrukcja

9 Września 2024

Instrukcje Punkt dostępu

Najnowsze instrukcje dla Punkt dostępu

Luxul

Luxul P40 Instrukcja

14 Stycznia 2025
Luxul

Luxul XAP-1440 Instrukcja

14 Stycznia 2025
Ubiquiti Networks

Ubiquiti Networks UniFi AP Flex HD Instrukcja

12 Stycznia 2025
Mikrotik

Mikrotik LTAP Mini LTE kit Instrukcja

30 Grudnia 2025
TP-Link

TP-Link Omada EAP115-Wall Instrukcja

30 Grudnia 2025
D-Link

D-Link AirXpert DWL-7000AP Instrukcja

23 Grudnia 2024
EQ-3

EQ-3 HMIP-HAP Instrukcja

15 Grudnia 2024
Vimar

Vimar 20195.N Instrukcja

15 Grudnia 2024
Vimar

Vimar 19195.M Instrukcja

15 Grudnia 2024
Vimar

Vimar 20195 Instrukcja

15 Grudnia 2024