Instrukcja obsługi HQ Power VDLL10ST

HQ Power Maszyna efektów VDLL10ST

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla HQ Power VDLL10ST (14 stron) w kategorii Maszyna efektów. Ta instrukcja była pomocna dla 12 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/14

VDLL10ST

STROBE LIGHT WITH RGB LEDs

STROBOSCOOP MET RGB-LEDS

STROBOSCOPE À LED RGB

ESTROBOSCOPIO CON LEDs RGB

STROBOSKOP MIT RGB-LEDs

USER MANUAL

GEBRUIKERSHANDLEIDING

NOTICE D’EMPLOI

MANUAL DEL USUARIO

BEDIENUNGSANLEITUNG

VDLL T10S HQPOWER

VDLL T STROBE LIGHT WITH RGB LEDs 10S –

1. Introduction

To all residents of the European Union

Important environmental information about this product

This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm

the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a

specialized company for recycling. This device should be returned to your distributor or to a local recycling

service. Respect the local environmental rules.

If in doubt, contact your local waste disposal authorities.

Thank you for choosing HQPOWER! Please read the manual thoroughly before bringing this device into service. If the

device was damaged in transit, don't install or use it and contact your dealer.

2. Safety Instructions

 Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer

will not accept responsibility for any ensuing defects or problems.

 Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device

against damage by leaving it switched off until it has reached room temperature.

 This device falls under protection class I. It is therefore essential that the device be earthed. Have a qualified

person carry out the electric connection.

 Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.

 Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.

 Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.

 Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.

 Keep the device away from splashing and dripping liquids. Never put objects filled with liquid on top of the device.

 The LEDs and mechanical wear are not covered by warranty.

 Note that damage caused by user modifications to the device is not covered by the warranty.

 Keep the device away from children and unauthorised users.

3. General Guidelines

 This device is designed for home use. The should only be used indoors with the PSU connected to VDLL10ST an

alternating current of max. 100-240VAC/50-60Hz.

 Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.

 Do not shake the device. Avoid brute force when installing or operating the device.

 Select a location where the device is protected against extreme heat (see “ ”), dust and Technical Specifications

moisture. Respect a minimum distance of 0.5m between the device‟s light output and any illuminated surface.

 Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified

people. Any damage that may occur will most probably be due to unprofessional use of the device.

 Use the original packaging if the device is to be transported.

 All modifications of the device are forbidden for safety reasons.

 Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,

crash, etc. Using the device in an unauthorised way will void the warranty.

Be very careful during the installation: touching live wires can cause life-threatening electroshocks.

Keep this device away from rain and moisture.

Unplug the mains lead before opening the housing.

Specyfikacje produktu

Marka:	HQ Power
Kategoria:	Maszyna efektów
Model:	VDLL10ST
Kolor produktu:	Czarny
Waga produktu:	155 g
Ilość lamp:	10 lamp(y)
Napięcie:	6 V
Wymiary produktu (SxGxW):	132 x 90 x 55 mm