Instrukcja obsługi Garmin Charge Power Pack

Garmin komputer rowerowy Charge Power Pack

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Garmin Charge Power Pack (4 stron) w kategorii komputer rowerowy. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/4
EDGE® EXTERNAL BATTERY PACK
Installation Instructions 2
Instructions d'installation 4
Istruzioni di installazione 6
Installationsanweisungen 8
Instrucciones de instalación 10
Instruções de instalação 12
Installatie-instructies 14
Installationsvejledning 16
Asennusohjeet 18
Installeringsinstruksjoner 20
Installationsinstruktioner 22
Instrukcja instalacji 24
Pokyny pro instalaci 26
Navodila za namestitev 28
Upute za instalaciju 30
Garmin®, the Garmin logo, and Edge® are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. These trademarks may not be used without the express permission of
Garmin.
Other trademarks and trade names are those of their respective owners.
July 2017
190-02220-92_0A
EDGE® EXTERNAL BATTERY PACK
Installation Instructions
Important Safety Information
WARNING
See the guide in the Important Safety and Product Information
GPS device product box for product warnings and other
important information.
A lithium-ion battery is used in this device.
If these guidelines are not followed, the battery may experience
a shortened life span or may present a risk of damage to the
device, fire, chemical burn, electrolyte leak, and/or injury.
• Do not disassemble, modify, remanufacture, puncture or
damage the battery pack.
• Do not expose the battery pack to fire, explosion, or other
hazard.
NOTICE
• Do not immerse the battery pack in water or other liquids.
• Do not leave the battery pack exposed to a heat source or in
a high-temperature location, such as in the sun in an
unattended vehicle. To prevent the possibility of damage,
remove the battery pack from the vehicle or store it out of
direct sunlight, such as in the glove box.
• Do not operate the battery pack outside of the temperature
ranges specified in the printed manual in the product
packaging.
• When storing the battery pack for an extended time period,
store within the temperature ranges specified in the printed
manual in the product packaging.
• Do not use a power and/or data cable that is not approved or
supplied by Garmin®.
• Contact your local waste disposal department to dispose of
the battery pack in accordance with applicable local laws and
regulations.
Device Overview
ÀStatus LEDs
ÁDevice key
ÂInput power Micro-USB port (under weather cap)
ÃOutput power USB-A port (under weather cap)
Charging the Battery Pack
NOTICE
To prevent corrosion, thoroughly dry the USB port, the weather
cap, and the surrounding area before charging or connecting to
a computer.
NOTE: The device will not charge when outside the charging
temperature range ( ).Specifications, page 3
1Pull up the weather cap from the Micro-USB port.
2Plug the small end of the USB cable into the Micro-USB port
on the device.
3Plug the large end of the USB cable into the USB wall
charger.
4Charge the battery pack completely.
The status LEDs flash blue while charging. The status LEDs
are solid blue when charging is complete. Charging a fully
depleted battery pack takes approximately four hours using
the USB cable and wall charger included with the battery
pack. The battery pack may charge slowly when using a
third-party USB cable or power source.
Tips for Using the Battery Pack
• Select the device key to check the battery charge level.
Each solid LED represents up to a 25% battery charge level.
When one LED is flashing, the battery pack has less than a
5% charge remaining.
• Connect your Edge® device to the battery pack.
Edge devices with electrical contacts start charging when
connected to the charging pins on the battery pack. For Edge
devices without electrical contacts, you must connect a USB
cable to the USB-A port on the battery pack. Go to
buy.garmin.com to purchase an accessory cable.
• Hold the device key for five seconds to stop charging a
connected Edge device.
You can select the device key to continue charging.
Installing the Lever Adapter
1Use the 2 mm hex key to remove the two screws À on the
bottom of the mount.
2Remove the quarter-turn adapter Á.
3Insert the lever adapter Â.
4Replace the screws, and use the 2 mm hex key to tighten the
screws.
Installing the Out-Front Mount
You can use the out-front mount to install the battery pack and
your Edge device.
1Select a secure location to mount the Edge device and
battery pack where they do not interfere with the safe
operation of your bike.
2 Installation Instructions
2Use the 2.5 mm hex key to remove the screw
À from the
handlebar connector Á.
3Place a rubber pad around the handlebar:
• If the handlebar diameter is 25.4 mm, use the thicker pad.
• If the handlebar diameter is 31.8 mm, use the thinner pad.
4Place the handlebar connector around the rubber pad.
NOTE: You should align the contours on the rubber pad with
the grooves on the inside of the handlebar connector.
5Replace the screw, and use the 2.5 mm hex key to tighten
the screw.
NOTE: Garmin recommends tightening the screw so the
mount is secure, with a maximum torque specification of
7 lbf-in. (0.8 N-m). You should check the tightness of the
screw periodically.
6Insert the battery pack into the bottom of the mount.
The lever  must be in the open position. The red mark
indicates the open position.
7Snap the lever to the closed position to lock the battery pack
into the mount.
8Insert the Edge device into the top of the mount.
The lever à must be in the open position. The red mark
indicates the open position.
9Snap the lever to the closed position to lock the Edge device
into the mount.
10 If necessary, use a USB cable to connect the Edge device to
the output power USB-A port on the battery pack (Tips for
Using the Battery Pack, page 2).
Device Information
Specifications
Battery type Lithium-ion battery
Output capacity 3100 mAh at 5 V (15.5 Wh)
Battery operation time Up to 24 hr. powering the Edge 1030 device
Charging temperature
range
From 0º to 45°C (from 32º to 113°F)
Operating and storage
temperature range
From -20º to 60ºC (from -4º to 140ºF)
Input 5 to 5.5 V, 2 A
Output Electrical contacts: 5.07 V, up to 1 A
USB port: 5.07 V, up to 2.4 A
Water rating IEC 60529 IPX7*
*The device withstands incidental exposure to water of up to 1 m
for up to 30 min. For more information, go to www.garmin.com
/waterrating.
Limited Warranty
The Garmin standard limited warranty applies to this accessory.
For more information, go to www.garmin.com/support/warranty
.html.
Installation Instructions 3

Specyfikacje produktu

Marka: Garmin
Kategoria: komputer rowerowy
Model: Charge Power Pack

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Garmin Charge Power Pack, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje komputer rowerowy Garmin

Garmin

Garmin Edge 530 Instrukcja

3 Lipca 2024
Garmin

Garmin Edge 820 Instrukcja

1 Lipca 2024
Garmin

Garmin Edge Explore 820 Instrukcja

28 Czerwca 2024
Garmin

Garmin Edge 520 Plus Instrukcja

28 Czerwca 2024
Garmin

Garmin Charge Power Pack Instrukcja

13 Maja 2024

Instrukcje komputer rowerowy

Najnowsze instrukcje dla komputer rowerowy

Pro

Pro phete BW 020 Instrukcja

3 Stycznia 2025
Lezyne

Lezyne Micro C Instrukcja

30 Grudnia 2025
Cateye

Cateye Commuter CC-COM10W Instrukcja

21 Grudnia 2024
BBB

BBB BCP-35W Instrukcja

12 Października 2024
Wahoo

Wahoo Elemnt Roam v2 Instrukcja

9 Października 2024
VDO

VDO R4 Instrukcja

7 Października 2024
VDO

VDO R5 Instrukcja

7 Października 2024
Sigma

Sigma Eox View 1700 Instrukcja

7 Października 2024
IGPSport

IGPSport BSC100 Instrukcja

7 Października 2024
IGPSport

IGPSport iGS800 Instrukcja

7 Października 2024