Instrukcja obsługi Fluval SP6

Fluval Pompa wodna SP6

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Fluval SP6 (40 stron) w kategorii Pompa wodna. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/40
SP2
SP4
SP6
INSTRUCTION MANUAL
MODE D’EMPLOI
MANUAL DE INSTRUCCIONES
BEDIENUNGSANLEITUNG
INSTRUCTIEHANDLEIDING
MANUAL DE INSTRUÇÕES
IMPORTANT SAFETY INSTRUCTIONS
WARNING - To guard against injury, basic safety precautions should be observed, including the following:
1.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
and all important notices on the appliance before using. Failure to do so may result in loss of fish life and/or damage to this appliance.
2.
DANGER
– To avoid possible electric shock, special care should be taken since water is employed in the use of aquarium
equipment. For each of the following situations, do not attempt repairs yourself; return the appliance to an authorized service
facility for service or discard the appliance.
A. If the appliance shows any sign of abnormal water leakage or if RCD (or GFCI- Ground Fault Current Interrupter) switches off
disconnect the power supply cord from main power supply and remove the aquarium pump from water.
B. Carefully examine the appliance after installation. It should not be plugged if there is water on parts not intended to be wet.
C. Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning or it is dropped or damaged in any
manner. The power cord of this appliance cannot be replaced; if the cord is damaged, the
appliance should be discarded. Never cut the cord.
D. To avoid the possibility of the appliance plug or receptacle getting wet, position the ap-
pliance to one side of a wall mounted receptacle to prevent water from dripping onto the
receptacle or plug. A “drip loop” (see illustration) should be arranged by the user for the cord
connecting appliance to a receptacle. The “drip loop” is that part of the cord below the level
of the receptacle or the connector if an extension cord is used, to prevent water travelling
along the cord and coming in contact with the receptacle. If the plug or receptacle does get
wet, DON’T unplug the cord. Disconnect the fuse or circuit breaker that supplies power to
the appliance. Then unplug and examine for presence of water in receptacle.
3.
WARNING
– Close supervision is necessary when any appliance is used by or near children.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not play with the appliance.
4. To avoid injury, do not touch moving parts or hot parts.
5.
CAUTION
– Always unplug or disconnect all appliances in the aquarium from electricity supply before placing hands in water,
before putting on or taking off parts and whilst the equipment is being installed, maintained or handled. When inserting or removing
the aquarium pump from the water, always pull out the main electricity plug. Never yank cord to pull plug from outlet. Grasp the
plug and pull to disconnect. Always unplug an appliance from an outlet when not in use.
6. This appliance is an aquarium pump for submersed use (in/underwater) as well as for use outside (inline use) in ornamental
aquariums. Do not use this appliance for other than its intended use (i.e.: don’t use it with inflammable or drinkable liquids,
in swimming pools or other situations where people are immersed, in garden ponds, bathrooms, etc.). This appliance is suitable for
use in water temperatures up to 35°C. The use of attachments not recommended or sold by the appliance manufacturer may cause
an unsafe condition and will invalidate your warranty.
7. This aquarium pump is suitable for
INDOOR/HOUSEHOLD
use only. Do not install or store the appliance where it will be exposed
to the weather or to temperatures below freezing.
8. Make sure that this appliance is securely installed before operating it and that the electrical connection is in accordance with the
data on the rating label. Do not allow the aquarium pump to run dry.
9. If an extension cord is necessary, a cord with proper rating should be used. A cord rated for less amperes or watts than the
appliance rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled. The connection
should be carried out by a qualified electrical installer.
10.
SAVE THESE INSTRUCTIONS
For the complete use and understanding of this product it is recommended that this manual is thoroughly read and understood.
Failure to do so may result in damage to this product.
AQUARIUM
TANK
PUMP
DRIP LOOP
POWER CORD

Specyfikacje produktu

Marka: Fluval
Kategoria: Pompa wodna
Model: SP6

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Fluval SP6, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Pompa wodna Fluval

Fluval

Fluval CP3 Instrukcja

7 Października 2024
Fluval

Fluval SP6 Instrukcja

7 Października 2024
Fluval

Fluval CP2 Instrukcja

7 Października 2024
Fluval

Fluval CP4 Instrukcja

7 Października 2024
Fluval

Fluval CP1 Instrukcja

7 Października 2024

Instrukcje Pompa wodna

Najnowsze instrukcje dla Pompa wodna

Dimplex

Dimplex WI 22 TE Instrukcja

11 Października 2024
DAB

DAB FEKA Instrukcja

9 Października 2024
Einhell

Einhell BG-DP 3730 Instrukcja

9 Października 2024
Einhell

Einhell Royal RHW 1000 Niro Instrukcja

9 Października 2024
Einhell

Einhell Royal HW 811 Instrukcja

9 Października 2024
Einhell

Einhell Royal GP-F 1300 Niro Instrukcja

9 Października 2024
Hayward

Hayward S240SLETL Instrukcja

9 Października 2024
Anova

Anova BE1450ASC Instrukcja

8 Października 2024
Anova

Anova BA2C10 Instrukcja

8 Października 2024
Einhell

Einhell RG-GP 1139 Instrukcja

8 Października 2024