Instrukcja obsługi Eaton Network Card-MS

Eaton Karta sieciowa/adapter Network Card-MS

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Eaton Network Card-MS (89 stron) w kategorii Karta sieciowa/adapter. Ta instrukcja była pomocna dla 11 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/89
Eaton® Network Card-MS
User’s Guide
Class B EMC Statements
FCC Part 15 Class B
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
lReorient or relocate the receiving antenna.
lIncrease the separation between the equipment and the receiver.
lConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.
lConsult the dealer or an experienced radio/TV technician for help.
Requesting a Declaration of Conformity
Units that are labeled with a CE mark comply with the following harmonized standards and EU directives:
lSafety for ATI: IEC/EN 60950-1 2002
lEN 61000-6-2 (2002)
EN 61000-6-3 (2002)
IEC/EN 62040-2 (2002).
lEU Directives: 99/336/EEC and 93/68/EEC.
Low voltage: 73/23/EEC and 93/68/EEC.
The EC Declaration of Conformity is available upon request for products with a CE mark. For copies of the EC
Declaration of Conformity, contact:
Eaton Power Quality Oy
Koskelontie 13
FIN-02920 Espoo
Finland
Phone: +358-9-452 661
Fax: +358-9-452 665 68
Eaton is a registered trademark of Eaton Corporation or its subsidiaries and affiliates. Phillips and Pozidriv are a
registered trademarks of Phillips Screw Company. National Electrical Code and NEC are registered trademarks
of National Fire Protection Association, Inc. All other trademarks are properties of their respective companies.
©Copyright 2011 Eaton Corporation, Raleigh NC, USA. All rights reserved. No part of this document may be
reproduced in any way without the express written approval of Eaton Corporation.
Special Symbols
The following are examples of symbols used on the UPS or accessories to alert you to important information:
RISK OF ELECTRIC SHOCK - Observe the warning associated with the risk
of electric shock symbol.
CAUTION: REFER TO OPERATOR'S MANUAL - Refer to your operator's
manual for additional information, such as important operating and
maintenance instructions.
This symbol indicates that you should not discard the UPS or the UPS
batteries in the trash. This product contains sealed, lead-acid batteries and
must be disposed of properly. For more information, contact your local
recycling/reuse or hazardous waste center.
This symbol indicates that you should not discard waste electrical or
electronic equipment (WEEE) in the trash. For proper disposal, contact your
local recycling/reuse or hazardous waste center.


Specyfikacje produktu

Marka: Eaton
Kategoria: Karta sieciowa/adapter
Model: Network Card-MS

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Eaton Network Card-MS, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Karta sieciowa/adapter Eaton

Instrukcje Karta sieciowa/adapter

Najnowsze instrukcje dla Karta sieciowa/adapter