Instrukcja obsługi AstralPool OC-1
AstralPool
filtr do wody
OC-1
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla AstralPool OC-1 (83 stron) w kategorii filtr do wody. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/83
OC-1 FILTERS
Residential Filter Instructions
Congratulations on purchasing an OC-1 filter, the revolutionary new filter media that
can save you energy and water.
OC-1 Media
OC-1 is not a traditional filter media that relies on
trapping dirt between particles, OC-1 works by reducing
the velocity of the dirt passing through the bed until it
settles out in a quiet void. This difference in the way it
works means it will behave differently to what you might
be used to with an old-fashioned filter.
Save Water
The pressure will not rise with OC-1 no matter how
much debris is in the filter. Therefore, backwashing
should be done on a time basis. For a normally used
domestic pool this would mean approx. once every
month instead of every week, saving water and time.
Save Energy
OC-1 has less resistance than traditional filter medias,
so it should be possible to use a smaller pump or
reduce the speed with a variable speed pump and
maintain the same flow that you would through
a traditional media (this is dependent on existing
restrictions through your pipework). This will save you
electricity and money. For example, if you can reduce
the speed of the pump by 20% this will equate to an
electrical saving of 48.8% (using the pump affinity law).
This booklet will take you through the basics of filtration,
for further information on OC-1 please visit:
www.ocmproducts.com
SAVE WATER
SAVE ENERGY
1
What happens to the water in your pool?
This should be a question of prime consideration for all pool owners. In the past some pools did not use filtering systems,
the owner was faced with the problem of refilling the pool with clean water when this became necessary. Refilling the
pool was laborious, meanwhile the owner had an unsanitary pool with unpleasant bathing owing to the poor clarity of the
water. Today pool owners demand absolute hygiene, crystal clear water and economy of effort. These objectives are
achieved by effective filtration and chemical treatment of the pool water.
After filling the pool with clean water in the summer, two basic factors will take place, due to the exposure of water to the
sun, the air and bathers.
1.-Biological contamination. The water is contaminated by micro-organisms which may be airborne or introduced by
bathers. These organisms reproduce rapidly in still, warm water and algae may form giving a green appearance to the
pool water.
2.-Rainfall and wind may introduce dust with leaves and seeds which muddy and pollute the pool water.
These two factors generate in a short period of time an unsanitary swimming pool and unpleasant bathing.
Solutions to the problem:
1. “CHEMICAL” TREATMENT
Maintain the correct level of sanitiser (chlorine, bromine, oxygen...) in the water to combat existing micro-
organisms by its disinfecting action.
As chlorine is the more common method, it will be taken as the reference point.
2. “PHYSICAL” TREATMENT
Provide the pool with a filtration system (filter and pump) to remove suspended particles from the water.
PH LEVEL
The pH level is an indicator of acidity or alkalinity present in the water. The neutral value is 7.0. a pH of 0-7 means levels
of acidity whilst 7-14 gives levels of alkalinity.
Why pH is important?
“THE IDEAL PH VALUE IN A POOL SHOULD BE BETWEEN 7.2 AND 7.6”.
As previously stated, sufficient residual chlorine must exist in the pool to destroy unwanted micro-organisms, in fact the
chlorine will only act as a bactericide when the pool water has a pH of between 7.2 and 7.6.
There are other reasons which call for a correct pH level:
Once above 7.6, calcium in the pool will precipitate to a visible cloudy form (accentuated in hard water areas).
This gives a milky appearance to the water, and hinders the filtering, deposits may also appear on the pool walls and
fittings.
Once the pH level falls below 7.0 the pool water becomes corrosive causing eye irritation and affecting mucus
membranes. There is also a long-term threat to metallic parts in the pool.
The quality of the pool water is highly dependent on maintaining the correct pH level.
2
Specyfikacje produktu
| Marka: | AstralPool |
| Kategoria: | filtr do wody |
| Model: | OC-1 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z AstralPool OC-1, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje filtr do wody AstralPool
7 Września 2024
7 Września 2024
7 Września 2024
7 Września 2024
7 Września 2024
7 Września 2024
7 Września 2024
7 Września 2024
7 Września 2024
7 Września 2024
Instrukcje filtr do wody
- filtr do wody Electrolux
- filtr do wody Philips
- filtr do wody GE
- filtr do wody BRITA
- filtr do wody Hyundai
- filtr do wody Fisher & Paykel
- filtr do wody Fiap
- filtr do wody Grohe
- filtr do wody Juwel
- filtr do wody Ecowater
- filtr do wody Franke
- filtr do wody Eheim
- filtr do wody Flama
- filtr do wody Ionmax
- filtr do wody PUR
Najnowsze instrukcje dla filtr do wody
2 Października 2024
29 Września 2024
24 Września 2024
11 Września 2024
22 Sierpnia 2024
7 Sierpnia 2024
18 Czerwca 2024
27 Maja 2024
26 Maja 2024
25 Maja 2024