Instrukcja obsługi AstralPool NanoFiber
AstralPool
filtr do wody
NanoFiber
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla AstralPool NanoFiber (56 stron) w kategorii filtr do wody. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/56
NanoFiber Filter Auto
Filtre NanoFiber Auto
Filtro NanoFiber Auto
Filtro NanoFiber Auto
NanoFiber-Filter Auto
Filtro NanoFiber Auto
INSTALLATION AND MAINTENANCE MANUAL
MANUEL D’INSTALLATION ET D’ENTRETIEN
MANUAL DE INSTALACIÓN Y MANTENIMIENTO
MANUALE DI INSTALAZIONE E MANUTENZIONE
EINBAU-UND BETRIEBSANLEITUNG
MANUAL DE INSTRUÇÕES E MANUTENÇÃO
67355 67356 67357
67509
2
To achieve optimum performance of the Nanofiber Filter Auto follow the instructions provided below:
General safety prescriptions:
These symbols indicate the possibility of danger as the consequence of not respecting
the corresponding prescriptions.
DANGER. Risk of electrocution. The lack of warning of this prescription involves a risk of
electrocution.
DANGER. The lack of warning of this prescription involves a risk of personal injury or material
damages.
WARNING. The lack of warning of this prescription involves a risk of damage to the filter or the
installation.
GENERAL SAFETY REGULATIONS.
The filter described in this manual has been specially designed to provide
correct water filtration in the swimming pool.
It has been designed to work with clean water at temperatures not exceeding
35ºC.
The installation must be carried out in accordance with the specifi c instruc-
tions for each particular implementation.
Current in-force regulations for the prevention of accidents must be observed.
Any modifi cation to the filter’s electronic module requires the prior authori-
sation from the manufacturer. Original spare parts and accessories authori-
sed by the manufacturer will guarantee greater safety. The manufacturer of
this filter is exempt from all responsibility for any damage caused by non-
authorised spare parts or accessories.
During operation, the filter’s electric and electronic parts have electric power
connected to them.
Any work to the filter and any equipment connected to it, must only be ca-
rried out when the start-up devices have been disconnected.
The user must ensure that installation and maintenance work is carried out
by adequately qualifi ed and authorised personnel, and these have previously
carefully read the installation and service instructions.
Filter operational safety is only guaranteed by full compliance and respect of
the installation and service instructions.
The appliance is not to be used by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction. Children being super-
vised not to play with the appliance.
ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures
to be implemented for installation and start-up. Therefore, the installer as well as the user must read the
instructions before beginning installation and start-up. Keep this manual for future reference.
3
ADVICE DURING INSTALLATION AND ASSEMBLY OPERATIONS.
During the connection operations of the electrical wiring to the filter modules, great attention must be
given to polarity, and it must be verifi ed that pieces of wiring are not left inside after closing.
Make all connections by following the instructions in this manual.
It should be verified that the electrical wiring connections to the electronic card are fi rmly made.
The seal on the module’s box should be checked for correct positioning to prevent the entry of water, it
should also be checked that the compression gland is also correctly located.
Particular attention should be paid, so that, under no circumstances, is it possible for water to enter
the electronic module. In the case where the intended use is not that for which the valve was designed,
adaptation and supplementary technical regulations may be necessary.
ADVICE FOR WHEN PUTTING INTO SERVICE.
Before putting the into service, it is necessary to verify the calibration of the electrical protection filter
devices in the operations cabinet and that they are correctly positioned and fi xed in place.
The maximum voltage values must never be exceeded under any circumstances.
In the case of incorrect operation or a fault, please contact the closest manufacturer’s representative
or technical assistance service.
NOTE: It is recommended that the bathing facilities are not used while the fi ltration
equipment is in operation.
ADVICE DURING INSTALLATION AND MAINTENANCE WORK.
National installation regulations must be taken into account when assembling and installing the filter.
Extra care must be taken so that it is not possible, under any circumstances, for water to enter the filter
electronic circuit.
All contact, including accidental, must be avoided at all times with the moving parts in the during filter
operation and/or before complete shutdown.
Before carrying out any maintenance or any other electrical or electronic work, it must be ensured that
switch-on devices are locked.
It is recommended that the following steps be taken before performing any maintenance on the filter:
1- Remove electrical power to the filter.
2- Lock the switch-on devices.
3- Verify that there is no electrical power being applied to the circuits, including auxiliary and
supplementary services.
This list must be considered indicative and not binding with respect to safety, there may
be other specifi c safety standards in particular regulations.
IMPORTANT: due to the complexity of the situations covered, the instructions for installation, use
and maintenance contained in this manual, do not make any attempt to cover all possible service and
maintenance cases. If additional instructions are necessary or specifi c problems arise, please do not
hesitate in contacting the distributor or the filter manufacturer directly.
Our filters may only be installed in swimming or other pools which fully comply with the HD 384.7.702
standard. When any doubt exists a specialist should be consulted.
1. CONTENT OF 67355-67356-67357:
Inside the box, you will find:
- Nanofiber filter
- Nanofiber filter cartridge (inside the filter)
- Bag of components:
Pressure gauge
Connections
Additional cable gland
Operating Instructions
2. CONTENT OF 67509 KIT:
If you have purchased the 67509 KIT you must
begin the installation in step nº7. Inside the box,
you will find:
- Cover assembly
- Bag of components:
Pressure gauge
Additional cable gland
Operating Instructions
Specyfikacje produktu
| Marka: | AstralPool |
| Kategoria: | filtr do wody |
| Model: | NanoFiber |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z AstralPool NanoFiber, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje filtr do wody AstralPool
7 Września 2024
7 Września 2024
7 Września 2024
7 Września 2024
7 Września 2024
7 Września 2024
7 Września 2024
7 Września 2024
7 Września 2024
7 Września 2024
Instrukcje filtr do wody
- filtr do wody Electrolux
- filtr do wody Philips
- filtr do wody GE
- filtr do wody BRITA
- filtr do wody Hyundai
- filtr do wody Fisher & Paykel
- filtr do wody Fiap
- filtr do wody Grohe
- filtr do wody Juwel
- filtr do wody Ecowater
- filtr do wody Franke
- filtr do wody Eheim
- filtr do wody Flama
- filtr do wody Ionmax
- filtr do wody PUR
Najnowsze instrukcje dla filtr do wody
2 Października 2024
29 Września 2024
24 Września 2024
11 Września 2024
22 Sierpnia 2024
7 Sierpnia 2024
18 Czerwca 2024
27 Maja 2024
26 Maja 2024
25 Maja 2024