Instrukcja obsługi Underwater Kinetics UK4AA Xenon Twist Bezel

Underwater Kinetics Flesz UK4AA Xenon Twist Bezel

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Underwater Kinetics UK4AA Xenon Twist Bezel (1 stron) w kategorii Flesz. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/1
Limited Lifetime Warranty
Underwater Kinetics prod-
ucts are engineered for maxi-
mum performance and dura-
bility. All products carry a
Limited Lifetime Warranty to
the original retail purchaser to
be free from defective material
and workmanship under nor-
mal and intended use. In addi-
tion, the Underwater Kinetics
Limited Warranty covers mate-
rials used in its products to the
original purchaser, from the
date of purchase, as follows:
plastics for 10 years; rubber
for 3 years, LED and electron-
ics for 1 year, rechargeable
batteries for 90 days and
In the event the original retail
purchaser detects a defect in
the material or workmanship,
the product along with proof
of purchase date should be
returned to an authorized
Underwater Kinetics dealer or
directly to Underwater
Kinetics with the postage pre-
paid. Underwater Kinetics
agrees to repair or replace at
Underwater Kinetics' sole dis-
cretion any product found to
be defective in material or
workmanship within the time
period specified above. For the
complete Limited Lifetime
Warranty write to Underwater
Kinetics or go to the web site
www.underwaterkinetics.com.
Address all correspondence
and returns to:
Underwater Kinetics
13400 Danielson Street
Poway, CA 92064
Battery Installation
To install batteries, hold the
case in the position shown.
Drop the batteries one by
one into the case in the order
shown. Make sure that the
(+) end of the battery is down
for 1 and 2 and up for batter-
ies 3 and 4. Next insert the
lamp module into the case.
Place the bezel over the lamp
module and screw it onto the
case.
O-Ring Seal
Lightly lubricate the O-ring
with silicone grease. Do not
use tools to remove the O-
ring.
Pressure Equalizing Vent
Air and gas from battery
leakage can pass freely in
and out of the UK4AA
through a vent in the rear of
the light. Do not allow dirt or
grease to accumulate on the
vent or it will not operate
properly.
Thank you for purchasing
this UK all environment work
and outdoor light! It is tough
enough for use in rain, snow,
smoke, dust or hazardous
locations (see listing). The
high intensity xenon lamp
outperforms lights many
times its size
Batteries can vent hydrogen
gas and possibly cause an
explosion if they are (1)
installed without the proper
polarity, (2) not the same
type, brand name and age
or (3) completely
discharged.
> Load batteries according
to the diagram.
> Discard all batteries as
soon as they are drained
or no longer produce
light.
> Do not mix batteries of
different type, brand or
age.
Care and Maintenance
Keep area around the O-
ring clean.
For longer lamp life, turn
the light on for several min-
utes after loading fresh bat-
teries to “age” the batteries.
If the light floods, empty it
immediately, rinse with fresh
water and dry completely
before reassembly.
Replace the reflec-
tor/lamp, which contains a
hydrogen absorbing cata-
lyst, if it gets wet.
Do not store batteries in
the light for long periods of
time; they may leak and
damage the light.
Bezel
14801
Xenon Lamp Module
4 Alkaline AA-cell batteries
O-Ring
UK4AA-AN2 Case
Vent
2
1
3
4
Note: The UK4AA
will not light if the
batteries are not
inserted with the
polarity as shown.
UK4AA XENON LIGHT Model Number: UK4AA-AN2
Instructions & Important Information
©2010 Underwater Kinetics P/N 400880
lamps for 30 days.
CL I, DIV 2, GP A, B, C, D,
CL II, DIV 2 GP G,
CL III, DIV 2 T2A
CL I, DIV 2 GP A, B, C, D,
T2 CLII, DIV 2, GP F, G,
CLIII, DIV 2, T3C
Certifications
This equipment is suitable for
use in Class I, Division 2
Groups A, B, C, D: Class II,
Division 2, Group G; Class III
Division 2, or Non-Hazardous
Locations Only.
Use only with 14801 Lamp
and 4 Duracell
MN1500/PC1500, Energizer
E91/EN91 or Rayovac
AL-AA/815 1.5 V size AA
Alkaline batteries.
Explosion Hazard
Do Not disconnect
Equipment Unless Power
Has Been Seitched Off Or
The Area Is Known To Be
Non-Hazardous
Explosion Hazard
Substitution of Components
May Impair Suitability For
Class I, Division 2.
ON/OFF
To operate the UK4AA turn
the bezel clockwise until the
lamp comes ON. Turn the
light OFF by turning the bezel
at least 1 1/2 turns counter-
clockwise.


Specyfikacje produktu

Marka: Underwater Kinetics
Kategoria: Flesz
Model: UK4AA Xenon Twist Bezel

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Underwater Kinetics UK4AA Xenon Twist Bezel, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Flesz Underwater Kinetics

Instrukcje Flesz

Najnowsze instrukcje dla Flesz

Ledlenser

Ledlenser P9R Core LEP Instrukcja

15 Października 2024
LED Lenser

LED Lenser P5R Instrukcja

11 Października 2024
Brennenstuhl

Brennenstuhl TL 1201 AF Instrukcja

9 Października 2024
Brennenstuhl

Brennenstuhl TL 601 AF Instrukcja

9 Października 2024
Klein Tools

Klein Tools KHH56308 Instrukcja

9 Października 2024
Brennenstuhl

Brennenstuhl HL 400 AC Instrukcja

9 Października 2024
Nitecore

Nitecore MH40 Pro Instrukcja

8 Października 2024
Nitecore

Nitecore HU2000 Instrukcja

8 Października 2024
AccuLux

AccuLux UniLux PRO Instrukcja

8 Października 2024
AccuLux

AccuLux SL6 LED Instrukcja

8 Października 2024