Instrukcja obsługi Truetone mA meter

Truetone nieskategoryzowany mA meter

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Truetone mA meter (2 stron) w kategorii nieskategoryzowany. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/2

mA meter

More information a

bout power

ing

guitar pedals:

What are milliamps anyway? They’re just like Watts, but it’s just another way of talking about

power consumption like how inches and millimeters are two different ways of talking about

measurement.

The important thing to remember is that your pedals will only take the amount of power they

need. So, if you plug an overdrive pedal that only uses 10mA into a 1 SPOT Pro output with

a “500mA” label, it’s OK. The pedal will only take what it needs. The “500mA” label is the

maximum that output can give although, with the 1 SPOT Pro, the outputs can actually

give even more than they say.

Instructions

To measure the current draw of your pedal, plug the pedal’s power supply to the DC IN jack

on the mA Meter. Plug one end of the included short DC cable into the DC OUT jack on the

mA Meter, and the other end into your pedal. You can also plug the short DC cable into the

daisy-chain cable from a 1 SPOT to measure the total current draw of all your pedals.

Measuring DC Current:

9V-24Vdc IN

(DC only; no AC)

OUT to Pedal

Read display for current

draw in milliamps (mA).

What happens if my pedal

draws more than 999mA?

Don’t worry, nothing will break. The display will tell you that you’re over 999mA, by

showing this readout:

Having said that, there are very few DC powered pedals that use more than 999mA. However,

if you’re measuring the current draw of your whole pedalboard, it might be over 999mA.

What if I plug in a 9Vac power supply by accident?

Again, nothing will break on the mA Meter, so relax.

The display will show this:

Just make sure you don’t plug an AC power supply into a DC pedal, ever. Bad things happen.

Using the Cable Tester:

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

— Reorient or relocate the receiving antenna.

— Increase the separation between the equipment and receiver.

— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

— Consult the dealer or an experienced radio/TV technician for help.

Need more great guitar tools? Go t

Truetone.com

9V-24Vdc IN

¼” (6.35mm) mono

guitar cable

LED on = Good cable; LED off = Bad cable

To test a guitar cable, plug both ends into the ¼” (6.35mm) jacks on the front of the mA