Instrukcja obs艂ugi TRENDnet TEW-690AP

Przeczytaj poni偶ej 馃摉 instrukcj臋 obs艂ugi w j臋zyku polskim dla TRENDnet TEW-690AP (45 stron) w kategorii Access point. Ta instrukcja by艂a pomocna dla 8 os贸b i zosta艂a oceniona przez 2 u偶ytkownik贸w na 艣rednio 4.5 gwiazdek

Strona 1/45
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
z Reorient or relocate the receiving antenna.
z Increase the separation between the equipment and receiver.
z Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
z Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The availability of some specific channels and/or operational frequency bands are country
dependent and are firmware programmed at the factory to match the intended destination.
The firmware setting is not accessible by the end user.
European Union Notice:
Radio products with the CE marking comply with the R&TTE Directive (1999/5/EC), the EMC
Directive (89/336/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission
of the European Community.
Compliance with these directives implies conformity to the following European Norms:
z EN 60950 Product Safety
z EN 300 328 Technical requirement for radio equipment
z EN 301 489-1/-17 General EMC requirements for radio equipment
Trademark recognition
All product names used in this manual are the properties of their respective owners and are
acknowledged.

Specyfikacje produktu

Marka: TRENDnet
Kategoria: Access point
Model: TEW-690AP

Potrzebujesz pomocy?

Je艣li potrzebujesz pomocy z TRENDnet TEW-690AP, zadaj pytanie poni偶ej, a inni u偶ytkownicy Ci odpowiedz膮




Instrukcje Access point TRENDnet

Instrukcje Access point

Najnowsze instrukcje dla Access point

Intellinet

Intellinet 500500 Instrukcja

17 Wrze艣nia 2024
IP-COM

IP-COM EW12 Instrukcja

17 Wrze艣nia 2024
IP-COM

IP-COM CPE12 Instrukcja

17 Wrze艣nia 2024
IP-COM

IP-COM AP325 Instrukcja

17 Wrze艣nia 2024
Steren

Steren COM-819 Instrukcja

17 Wrze艣nia 2024
IP-COM

IP-COM AP345 Instrukcja

17 Wrze艣nia 2024
IP-COM

IP-COM EP9 Instrukcja

17 Wrze艣nia 2024
IP-COM

IP-COM CPE6 Instrukcja

17 Wrze艣nia 2024
IP-COM

IP-COM EW9 Instrukcja

17 Wrze艣nia 2024
IP-COM

IP-COM CPE3 Instrukcja

17 Wrze艣nia 2024