Instrukcja obsługi Tel Sell Climb Trek

Tel Sell Rower treningowy Climb Trek

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Tel Sell Climb Trek (5 stron) w kategorii Rower treningowy. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/5
Mi Air Humidier
01 Overview
Lid
Lid handle
Hole for steam outlet
Water tank Water level indicator
Safety cover of built-in
antibacterial UV lamp
Ball, indicating water
level
Plate, spraying
a steam
Air outlet hole
Bactericidal UV lamp
The unit base
(base)
Power button / switch
modes
Mode indicator
Water volume indicator/
Status of the device
Adaptor
АС power cable
02 Setting
Installing the main unit
Three parts of the humidier
(lid handle, cover and base unit
(base)) collected, when marks,
shown in the rear of the device
are aligned.
Wi-Fi indicator
Light adjusting button
Air input hole
DC power cable
03 Usage
Proper device positioning
Place the humidier on exposed
surfaces. The humidier should
be located away from walls,
furniture, appliances, etc., things
would not accumulate
moisture.
Adding a water
Open the lid and pour a water into the tank.
Please do not spill water, and do not pour too
much water (water should not exceed the MAX
mark).
The water used: household water, mineral water,
puried water. Do not use distilled water.
maximum water
level
04 Usage
Connecting power adapter
It is necessary to distinguish between DC power
cable and AC cable. By connecting the DC cable
to AC adapter, be guided by side with the image
of the negative pole.
Cnnecting АС cable
Connect AC cable to power
supply.
Light management
To operate a light you need
to press the button on a
rear side of the humidier.
Each press of the button
allows you to control light
switch lighting modes:
continuous light, ashing
light, turn o the light.
Connecting to mobile App
To install «Mi Home» app, scan
the QR-Code. Open the app, click
on icon «My Device» and add «Mi
Air Humidier» to your list. After
successfully adding a humidier,
you will nd it in «Smart Devices»
list.
This device is already in a list of Mi Smart Home devices, supports MIUI system and can
interface and interact with other Mi Smart Home devices.
To nd out more information about operation of this device or to purchase other smart
devices, register in Mi Smart Home APP.
05 Usage
On-O/ mode switching
- Turning on
Press the button to turn humidier on.
Mi Air Humidier remembers a mode, established
after last use of the device. When rst using the
device, a default is 1st mode.
Note: If no water in the tank, the humidier does not
turn on. Please add water rst, and then use the
device.
- Mode switching
Click on the button to switch a mode.
Each time you press the button you switch 1st, 2nd,
3rd mode.
- Shutdown
Press and hold the button for 3 seconds to turn o
the device.
Note: If the humidier is over water, it is
automatically switched o.
- Maximum mode
IWhen the device is o, press and hold the button for 5 seconds to activate maximum
mode. The humidier can work 4.5 hours by default. If water is over the device, it switches
o automatically. Click on the button to turn on 1st mode.
Mode O mode 1 mode 2 mode 3 mode Low
energy
Indicators
Indicators status
Indicators lit Indicator o Indicators ashing
Volume of water / LED status of the device
Mode O mode Work mode Low
water
level
Water is over
Indicators
Indicators lit Indicators o Indicators ashing
06 Maintenance
Draining
After using the device in a timely manner, drain a water from the tank and the base of the
humidier to prevent increase and spread of a possible bacteria, micro-organisms and to
prevent air pollution.
Disconnect the device from a power supply, then water can be drained.
Drain water from the tank
Click and hold on the valve, which is located under the tank to drain remaining water.
Drain water from the base of the humidier
It is strongly recommended to drain water from the device in a place where there is a
corresponding image and inscription, to prevent water from entering the air outlet hole and
to avoid damage to the device.
07 Maintenance
Reset Wi-Fi
If the humidier is not connected to your phone,
press and hold the Power button and Light control
Button for 5 seconds until you hear a beep, indicating
of successful reset Wi-Fi settings.
Power button
Light operating button
Cleaning the humidier
To clean the humidier base and tank, you can use
pure water or neutral detergent, followed by a wipe
with a dry cloth. Do not use a hair dryer or other
heating devices to dry the humidier. Avoid direct
sunlight.
In the case of regular use of a humidier is recommended to clean it once a week.
Presence of toxic and hazardous substances
Main characteristics
Warranty time
Note: The warranty applies only to companies in China.

Specyfikacje produktu

Marka: Tel Sell
Kategoria: Rower treningowy
Model: Climb Trek

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Tel Sell Climb Trek, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Rower treningowy Tel Sell

Tel Sell

Tel Sell iWalk Instrukcja

4 Lipca 2024
Tel Sell

Tel Sell Ab Circle Pro Instrukcja

3 Lipca 2024
Tel Sell

Tel Sell FlexShaper Instrukcja

1 Lipca 2024
Tel Sell

Tel Sell Climb Trek Instrukcja

1 Lipca 2024

Instrukcje Rower treningowy

Najnowsze instrukcje dla Rower treningowy

Kettler

Kettler Elyx 3 Instrukcja

14 Stycznia 2025
Schwinn

Schwinn 470i Instrukcja

12 Stycznia 2025
Elite

Elite Direto XR Instrukcja

12 Stycznia 2025
Schwinn

Schwinn AD2 Instrukcja

12 Stycznia 2025
VirtuFit

VirtuFit Power Tower Instrukcja

12 Stycznia 2025
VirtuFit

VirtuFit Power Tower Deluxe Instrukcja

12 Stycznia 2025
Horizon Fitness

Horizon Fitness Ti 51 HRC Instrukcja

11 Stycznia 2025
Finnlo

Finnlo Roton Stressless 3166 Instrukcja

11 Stycznia 2025
Body Solid

Body Solid GCEC-340 Instrukcja

11 Stycznia 2025
Horizon

Horizon Comfort 4.0 Instrukcja

10 Stycznia 2025