Instrukcja obsługi SoundTube SA502

SoundTube odbiornik SA502

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla SoundTube SA502 (4 stron) w kategorii odbiornik. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/4
Install Instructions For:
SA502
© 2012 SoundTube Ente tainment,r Inc. All rights rese ved.r PN INS-SA502 ev01.27.12R
1.435.647.9555
|
800.647.TUBE
|
www.soundtube.com
Faceplate
Faceplate screws (4)
Front Rear
SA502
SA502 amplifier
Four-pin Euroblock
Four-pin Euroblock
Mounting bracket
Two-pin jumper block
Three-pin
Euroblock (3)
Three-pin Euroblock (3)
Six-pin jumper block
Box Contents
1- Amplifier (Input Voltage 30-32VDC)
(UL 60065 compliant)
1- Stereo RCA to mini adapter
1- Power adaptor: Input 100VAC-240VAC, 50/60 Hz
Output 30-32VDC, 3.75A
2- Four-pin Euroblock connectors
3- Three-pin Euroblock connectors
1- Mounting bracket
Avis
Les produits SoundTube doit être installé par un installateur professionnel audio/contractuer.
Pour plus de sûreté et pour des performances audio optimales, l'installateur doit suivre toutes
les instructions émises par SoundTube.
Warning
SoundTube products must be installed by ofessional audio installer/contracto For safety a pr r.
and for optimum audio performance, installer must follow all directions issued by SoundTube.
1. Unpack amplifier.
Note: Follow steps 2-5 if
using the mounting adapter.
If not skip to step 6.
2. Attach mounting bracket
to a secure pole or surface
using screws or metal
strapping.
7b. In mono mode, the left
and right inputs are
combined internally and
fed to both channels of the
amp. The left and right
channels both output the
summed signal.
7a. In stereo mode, the left
and right channels remain
separate. The amp operates
as a normal stereo amp.
6. Select stereo, bridged or
mono mode with the
included jumper.
3. To attach mounting
bracket, remove all faceplate
screws from one side. Lift
faceplate and set aside.
4. Slide mounting bracket
into groove on bottom of
amplifer enclosure.
8b. Bridged: connect single
pair of speaker wire to the
center + and - terminals of 4
pin Euroblock. DO NOT use
outside terminals.
8a. Stereo and Mono:
connect speaker wires to 4
pin Euroblock.
7c. In bridged mode, the
amp becomes a mono block
amp with just one input
(left), and one output. The
bridged amp is capable of
90w in to 4 ohms.
Install Instructions For:
SA502
SA502
SA502
STEREO
Left line in
Right line in
Amp
(left)
Amp
(right)
SA502
Left line in
Right line in
Amp
(left)
Amp
(right)
MONO
SA502
Left line in Amp
(left)
Amp
(right)
BRIDGED
BRIDGED
STEREO or MONO
9. Connect speaker
Euroblock to the SA502.
5. Replace faceplate and
screws.
12. The SA502 can be
powered either by the hard
wired Euroblock connector,
or via barrel connector with
the included power supply
(shown above). Use a safety
approved (UL/ETL, etc...) 32V
3.75A power supply.
11. Select desired input via
input selector switch located
on the front of the SA502.
10. The SA502 accepts audio
sources via stereo mini,
balanced Euroblock, or high
level Euroblock on the front of
the unit.
Install Instructions For:
SA502
SA502
13a. The SA502 can be
turned on and off with an
external 12v-32v DC
trigger. To enable, move
the jumper to “on.”
Note: Amp comes equipped
with auto- sensing circuit that
idles down after 10 minutes
without input signal. Unit
powers back up when a signal
is detected.
15. Adjust volume with knob
on front of amplifier. Inner
knob controls left channel
and outer knob controls right
channel.
14. If desired, use the
high-pass filter to remove
low-end frequencies and
increase intelligibility when
using small speakers.
13b. If using external
trigger, run the trigger
positive wire into “T” and
the trigger negative wire
into “-” using the 3 pin
Euroblock. Note: If using
both external trigger and
hard wired power, both
negative wires will share
the “-” Euroblock input.
16. Done

Specyfikacje produktu

Marka: SoundTube
Kategoria: odbiornik
Model: SA502

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z SoundTube SA502, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje odbiornik SoundTube

SoundTube

SoundTube MCA10004t Instrukcja

31 Stycznia 2025
SoundTube

SoundTube MCA2004t Instrukcja

28 Stycznia 2025
SoundTube

SoundTube MCA7004t Instrukcja

28 Stycznia 2025
SoundTube

SoundTube IPD-Hub 2 DSP Instrukcja

28 Stycznia 2025
SoundTube

SoundTube MA501T Instrukcja

28 Stycznia 2025
SoundTube

SoundTube SB335 Instrukcja

28 Stycznia 2025
SoundTube

SoundTube SA502 Instrukcja

28 Stycznia 2025
SoundTube

SoundTube SA202-II Instrukcja

28 Stycznia 2025
SoundTube

SoundTube WLL-TR-1p-II Instrukcja

28 Stycznia 2025
SoundTube

SoundTube WLL-RX1p-II Instrukcja

28 Stycznia 2025

Instrukcje odbiornik

Najnowsze instrukcje dla odbiornik

QSC

QSC SPA-Qf 60x2 Instrukcja

1 Kwietnia 2025
Streacom

Streacom TL1 Instrukcja

30 Marca 2025
Graupner

Graupner GR-8 Instrukcja

30 Marca 2025
MB Quart

MB Quart FA2-2000.1 Instrukcja

29 Marca 2025
MB Quart

MB Quart FA2-1500.1 Instrukcja

29 Marca 2025
MB Quart

MB Quart FA2-1000.1 Instrukcja

29 Marca 2025
MB Quart

MB Quart FA2-400.4 Instrukcja

29 Marca 2025
MB Quart

MB Quart FA2-900.5 Instrukcja

29 Marca 2025
Pro-Ject

Pro-Ject Stereo Box DS Instrukcja

29 Marca 2025
Futaba

Futaba R7108SB Instrukcja

28 Marca 2025