Instrukcja obsługi Snow Joe SJ626E-RM
Snow Joe
pług wirnikowy
SJ626E-RM
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Snow Joe SJ626E-RM (14 stron) w kategorii pług wirnikowy. Ta instrukcja była pomocna dla 9 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/14
© 2021 by Snow Joe
®, LLC
All rights reserved. Original instructions. SAVE THESE INSTRUCTIONS
1
A Division of Snow Joe
®, LLC Model SJ626E-RM Form No. SJ-SJ626E-RM-880E-M-V1
OPERATOR’S MANUAL
ELECTRIC SNOW THROWER
22-INCH | 14.5-AMP
R
4
5. Do not abuse the cord. Never pull the snow thrower by the
cord or yank the cord to disconnect it from the receptacle.
Keep the cord away from heat, oil, and sharp edges.
Personal Safety
1. Stay alert – Watch what you are doing and use common
sense when operating the snow thrower. Do not use the
machine when tired, ill, or under the inuence of drugs,
alcohol, or medication. A moment of inattention may result
in serious personal injury.
2. Wear proper clothing – Wearing rubber boots oers
additional protection from electric shock. Do not wear
loose clothing or jewelry that may become caught in the
machine. Wear protective headgear to keep hair away
from revolving parts of the machine. Safety glasses oer
better protection than everyday eyeglasses.
3. Moving parts present risks – Keep your face, hair,
clothing, hands, and feet away from moving parts.
All guards and safety attachments must be installed
properly before using the unit. Shut o and disconnect the
cord before touching any parts other than the handles and
the switch.
4. Surfaces – This snow thrower is intended for use on
paved surfaces. Do not use on gravel, stone, or other
unpaved surfaces unless the snow thrower is adjusted for
such surfaces according to the instructions given in this
operator’s manual.
5. Avoid accidental starting – Make sure the switch is in the
o position before plugging in the unit. Do not carry the
snow thrower with your nger on the switch.
6. Body position – Maintain proper footing and balance
at all times. Place heels rmly on the ground and tightly
grasp the handle bar. Watch for uneven surfaces and do
not overreach. In case you fall or collide with the snow
thrower, inspect the unit for any damage or cracks.
When stepping backwards, be careful to avoid obstacles
beneath your feet or behind you to avoid falling.
7. If the snow thrower strikes any object, immediately
stop the snow thrower, then inspect for damage –
Repair any damage before restarting and operating the
snow thrower.
Safety Instructions for Walk-Behind
Snow Throwers
• Readtheoperator’smanualcarefully–Learn your
snow thrower’s applications and limitations as well as the
specic potential hazards related to this machine. Do not
use this machine for any purpose other than the one for
which it was designed. Otherwise, it may cause mechanical
defaults, serious damage, or personal injury.
• Preliminaryunitinspection–Thoroughly inspect the unit
before use. Make sure all the parts are secure and installed
correctly. If you notice any abnormalities, do not use the
machine until it has been properly repaired.
Always perform a test run the rst time you use the snow
thrower or after replacing parts to ensure that the unit is
functioning properly.
• Preliminaryareainspection–Clear the area to be plowed
before each use. Remove all objects, such as rocks, broken
glass, nails, wire, or string, which can be thrown by or
become entangled in the snow thrower. Keep the area of
operation clear of all spectators, particularly children
and pets.
• Excessiveforce–The snow thrower was designed to
respond at a certain rate for various snow conditions for
optimum safety and performance. Do not force it; keep
pressure constant.
• Malfunctioningswitch–Do not use the snow thrower
if the switch does not turn it on and o. Any electrical
appliance that cannot be controlled by the switch is not
safe to use and must be repaired.
• Hittinganobject–If the snow thrower accidentally strikes
an object, follow these steps:
i) Stop the snow thrower and unplug the unit
ii) Inspect for damage
iii) Repair or replace any damaged part before restarting
and operating the snow thrower.
• Discharge chute safety – Never direct the snow discharge
chute at the operator, at bystanders, at vehicles, or at
windows. The discharged snow stream and foreign objects
accidentally picked up by the snow thrower can cause
serious damage and personal injury. Do not use your hands
to unclog the discharge chute. Stop the motor before
removing debris.
• Hand-heldoperatingposition–Operation of the snow
thrower in the hand-held position is unsafe.
• Abnormaloperation–If you notice the snow thrower
running in an unstable state or hear abnormal sounds from
the engine, immediately stop the machine, disconnect the
power, and contact an authorized Snow Joe® + Sun Joe®
dealer or the Snow Joe® + Sun Joe® customer service
center at 1-866-SNOWJOE (1-866-766-9563).
• Noisecontrol–When using the snow thrower, you must
respect local laws and regulations regarding noise control
and environmental protection. To avoid noise disturbance,
you should carefully decide upon an appropriate operation
time and consider the surrounding conditions.
• Whenworkiscompleted–Disconnect the snow
thrower from the power source when not in use, when
changing accessories, and before performing any
maintenance function.
6
Safety Symbols
The following table describes safety symbols that may appear on this product. Read, understand, and follow all instructions on
the machine before attempting to assemble and operate.
It is obligatory at all times to wear
goggles or a visor to protect the eyes
and face.
Disconnect the plug before
conducting maintenance or when it is
damaged or tangled.
Beware of stones and other objects
that could be thrown from the
appliance. Keep all bystanders and
domestic animals a safe distance
away from the work area.
Keep feet away from the moving
parts of the snow thrower. The
rotating parts can cause severe
bodily injury.
Keep hands and feet away from
the rotating parts.
Keep hands away from the moving
parts of the snow thrower. The
rotating parts can cause severe
bodily injury.
The rotating part will continuously
run for several seconds after you
turn o the machine.
Double insulation.
Keep the exible power supply cord
away from the cutting blades.
Always keep the power cable away
from heat sources, oils, or sharp
edges. Immediately remove plug
from the mains if the cable is
damaged or entangled.
Symbols Descriptions Symbols Descriptions
READ THE OPERATOR'S
MANUAL(S) – Read, understand,
and follow all instructions in the
user manual(s) before attempting
to assemble and operate.
SAFETY ALERT – Indicates
a precaution, a warning, or
a danger.
WARNING! Do not expose the unit
to rain or wet conditions. Keep dry.
Wear protective gloves and non-
slip footwear when using the
machine and handling debris.
CAUTION! Beware of stones and
other foreign objects that could
be thrown from the appliance.
DANGER! Cutting/dismemberment
hazard – Keep hands away from the
rotating auger. Do not use hands to
unclog rotor housing. Stop motor
before removing debris.
Specyfikacje produktu
| Marka: | Snow Joe |
| Kategoria: | pług wirnikowy |
| Model: | SJ626E-RM |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z Snow Joe SJ626E-RM, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje pług wirnikowy Snow Joe
18 Czerwca 2024
18 Czerwca 2024
18 Czerwca 2024
18 Czerwca 2024
18 Czerwca 2024
18 Czerwca 2024
18 Czerwca 2024
18 Czerwca 2024
18 Czerwca 2024
18 Czerwca 2024
Instrukcje pług wirnikowy
Najnowsze instrukcje dla pług wirnikowy
24 Września 2024
14 Maja 2024