Instrukcja obsługi Smanos SR1000

Smanos Bezpieczeństwo SR1000

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Smanos SR1000 (15 stron) w kategorii Bezpieczeństwo. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/15
© 2016 SMANOS HOLDING LTD. All Rights Reserved. Ver: SR1000-UM-ML-V1.0
Printed in China
SR1000
Plug-in Wireless Signal Repeater
MULTILINGUAL
USER MANUAL
EN DE ESFR PTNL IT
ENEN
Introduction
The repeater is a wireless signal relay transmission device.
With MCU technology, it can decode the signal in the air and
strengthen the transmitting power to extend the transmission
distance range. Failure to receive signal to panel from wireless
accessories is frequently happened due to the long distance range
when the remote controlling or wireless alarm systems are applied
to large scale of commercial tall buildings, villa, and industrial
areas. This wireless signal repeater could solve this problem and
further distance range signal transmitting could be achieved.
Product Overview
Antenna Power ON/OFF
Interface for
External Antenna
Learning Button
Note: Please pull out the antenna for optimal performance.
LED Indication
Green LED on: working status
Blue LED ashes once: signal transmitting
Green and blue LEDs ash alternatively: in connect status
Adding and Deleting Accessories
Before adding and deleting accessories, make sure SR1000 repeater
has been activated to 'connect status'. To activate connect status,
you need to turn 'power' button to 'ON'; if it is already in 'ON' mode,
reboot the repeater from 'OFF' to 'ON'. Indicator light will then
alternately ash between green and blue. Choose following options
to add or delete accessories:
Extend Transmission Distance between Accessories and Control Panel
First, press the 'Learning Button' upon the repeater, you will hear a
short beep. After that, you can trigger any accessory you wish to pair
to the repeater, for example, separates two components of door/
window contact; if the repeater is successfully paired, a two-second
length “beep” will sound with blue light on, and light will alternately
shining between blue and green. You may add more accessories by
repeating the steps above.
Note: If the repeater does not receive any signal within one minute, the pairing
process will be canceled, it would sound beep twice meanwhile. If the repeater
exits the connect status, switch off and then switch on the repeater to re-enter the
connect status. Then repeat the above operation to add more accessories.
ENEN
Workow:
Signal transmitting
Trigger contact/detector or
activate remote control
Max. distance
(in open area) ≤ 80m
Max. distance
(in open area) ≤ 120m
Repeater receives
signals
Control panel receives
signals
Signal transmitting
Extend Transmission Distance between Control Panel and Siren
First, press the 'Learning Button' upon the repeater, you will hear
a short beep. After that, press SOS button or 'Arm' the control
panel; if it is successfully paired, a two-second length 'beep' will
sound with blue light on, and light will alternately shining between
blue and green. Transmission distance between control panel and
siren is therefore extended.
If the repeater does not receive any signal within 1 minute, the
pairing process will be canceled, it would sound beep twice
meanwhile.
Workow:
Signal transmitting
Control panel arm/
disarm/alarm
Max. distance
(in open area) ≤80m
Max. distance
(in open area) ≤ 120m
Repeater receives
signals Siren receives
signals
Signal transmitting
Deleting Accessories
To remove all paired accessories, you only need to press and hold
'Learning Button' upon the repeater for ve seconds; indicator
light would turn blue, wait two seconds until the light turns green
with three times beeps, then you would successfully remove all
accessories.
Specications
Power Supply: AC 110V-240V, 50/60Hz
Wireless Transmitting Range: < 150m
Wireless Receiving Range: < 80m
Radio Frequency: 868MHz (±75KHz)
Static Current: < 20.5mA
Transmitting Current: < 330mA
Maximum Accessories Supportable: 40 PCS
Back-up Battery: 3.7V 600mAh Lithium Battery, 2.22Wh
Housing Material: ABS plastic
Operating Condition:
Temperature: 0°C ~ +55°C
Relative Humidity: < 80% (non-condensing)
Dimension (L x W x H): 140 x 86 x 87mm

Specyfikacje produktu

Marka: Smanos
Kategoria: Bezpieczeństwo
Model: SR1000

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Smanos SR1000, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Bezpieczeństwo Smanos

Smanos

Smanos FD2000 Instrukcja

28 Września 2024
Smanos

Smanos SR1000 Instrukcja

28 Września 2024
Smanos

Smanos DS8600 Instrukcja

28 Września 2024
Smanos

Smanos Q300 Instrukcja

28 Września 2024
Smanos

Smanos VD8000 Instrukcja

28 Września 2024
Smanos

Smanos PR2600 Instrukcja

28 Września 2024
Smanos

Smanos FD2100 Instrukcja

28 Września 2024
Smanos

Smanos GB1260 Instrukcja

28 Września 2024
Smanos

Smanos S105 Instrukcja

28 Września 2024
Smanos

Smanos MD8000 Instrukcja

28 Września 2024

Instrukcje Bezpieczeństwo

Najnowsze instrukcje dla Bezpieczeństwo

NetworX

NetworX NX-595E IP Communication Module Instrukcja

5 Października 2024
Geemarc

Geemarc SOS-PRO 295 Instrukcja

2 Października 2024
One2track

One2track Safety Angel Instrukcja

28 Września 2024
Sygonix

Sygonix SY-3851632 Instrukcja

28 Września 2024
Sygonix

Sygonix 1326052 Instrukcja

28 Września 2024
Sygonix

Sygonix 43588A WLAN Camera Instrukcja

28 Września 2024
Sygonix

Sygonix 43176S LAN Camera Instrukcja

28 Września 2024
Sygonix

Sygonix SY-3181234 Instrukcja

28 Września 2024
Sygonix

Sygonix Touch IP65 Instrukcja

28 Września 2024
Sygonix

Sygonix 1882082 Instrukcja

28 Września 2024