Instrukcja obsługi SkyRC e430

SkyRC Ładowarka baterii e430

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla SkyRC e430 (4 stron) w kategorii Ładowarka baterii. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/4
Thank you for your choice of the SKYRC e430, 100-240V AC balance charger. This unit is simple to use
but its operation does require some knowledge on the part of the user. Please read this entire operating
manual completely and attentively before using this product, as it covers a wide range of information on
operating and safety.
SKYRC e430 Charger is an economic, high quality 100-240V AC balance charger, designed for charging
LiPo and LiFe batteries from 2-4 cells in balance mode. The circuit power is 30W and max charge current
can reach to 3A. There are three kinds of charge current 1A/2A/3A that can be selected. You could select
the proper charge current according to battery capacity.
INSTRUCTION MANUAL
INTRODUCTION
CHARGE PROCEDURES
SKYRC e430 comes with the built in power supply. You can connect the AC power cord to the AC socket (100-240V AC)
directly.
Insert the AC power cord into the charger.
Insert the AC cord into a wall socket (100-240V). All LEDS will light for 1 second and the charge status LED will flash
green which indicates the charger is ready to charge.
Select the battery type LiPo/LiFe by the slide switch.
Select the proper charging current 1A/2A/3A by the slide switch.
Connect the battery main charge lead to battery socket which is in the front side of the charger and battery balance
wire to balance port which is in the right side of the charger.
The charger starts charging. The charge status LED and the cell status LED will glow constant red. If the battery
pack is 2-cell, Cell 1 and Cell 2 LEDs will glow constant red; if the battery pack is 3-cell, Cell 1, Cell 2 and Cell 3
LEDs will glow constant red; and so on.
During the charging progress, when the charge status LED glows constant red, the charger is charging in CC mode;
when the charge status LED glows constant orange, the charger is charging in CV mode;
When the cell LED is flashing, this cell is discharging
for balancing.
When the battery is fully charged, the charge status
LED will glow constant green.
Unplug the battery from the charger and the charge
status LED will flash green which indicates the
charger is ready to charge another battery.
Please refer to following steps to charge the battery,
1)
2)
3)
4)
5)
6)
7)
8)
9)
- - - -1 2
SPECIFICATION
AC Input
Battery Type
Cell Count
Charge Current
Cell Terminate Voltage
Circuit Power
Current Drain for Balancing
Dimension
Weight
100-240V
LiPo/LiFe
2-4 cells
1A/2A/3A ± 10%
LiPo: 4.2V ± 0.02V / LiFe: 3.6V ± 0.02V
30W
200mA
69.4x110.7x40.5mm
193g
SK-100107
This diagram shows the correct way to connect
your battery.
Failure to connect as shown in this diagram will
damage this charger.
CAUTION:
10)
Battery Type Switch
Cell 2 LED Indicator
Cell 1 LED Indicator
Cell 4 LED Indicator
Cell 3 LED Indicator
Battery Socket
AC 100-240V
Power Jack
Charge Current Switch
Charge Status LED Indicator
Balance Socket
EXPLANATION OF LED STATUS
If there is an error, the charge status LED and one of the cell LED will blink in sequence.
* Error Message
LED green blinking
LED glows constant red
LED glows constant orange
LED glows constant green.
LED glows constant red.
LED flashes red
The charger is ready to charge.
The charger is charging in CC mode.
The charger is charging in CV mode.
The charging process finishes.
The cell is charging.
The cell is discharging.
Charge Status LED
Cell Status LED
In this case, please disconnect the power cord from the wall socket and unplug the battery from the charger.
Charge Status LED + Cell 1 LED
Charge Status LED + Cell 2 LED
Charge Status LED + Cell 3 LED
The voltage difference among cells is too big (more than 300mV)
Wrong connection
Low Voltage Protection(≤2.5V)
LED Status Error Message
CONNECTION DIAGRAM
LiPo
TO 100-240V AC
Socket
Cell LED will blink simultaneously
Charge Status Cell 1+2+3+4 LED
Cell 1+2 LED
The whole charging process exceeds 5 hours.
Battery type changed while charging.
7504-0851-02
Manufactured by
SKYRC TECHNOLOGY CO LTD  ., .
www skyrc com. .
- - - -3 4
THE SET CONTAINS
WARNING AND SAFETY NOTES 
WARRANTYAND SERVICE
We guarantee this product to be free of manufacturing and assembly defects for a period of one year from the time of
purchase. The warranty only applies to material or operational defects, which are present at the time of purchase. During
that period, we will repair or replace free of service charge for products deemed defective due to those causes.
You will be required to produce proof of purchase (invoice or receipt). This warranty is not valid for any damage or
subsequent damage arising as a result of misuse, modification or as a result of failure to observe the procedures
outlined in this manual.
LIABILITY EXCLUSION
This charger is designed and approved exclusively for use with the types of battery stated in these Instruction Manual.
SKYRC accepts no liability of any kind if the charger is used for any purpose other than that stated. We are unable to
ensure that you follow the instructions supplied with the charger, and we have no control over the methods you employ
for using, operating and maintaining the device. For this reason we are obliged to deny all liability for loss, damage or
costs which are incurred due to the incompetent or incorrect use and operation of our products, or which are connected
with such operation in any way. Unless otherwise prescribed by law, our obligation to pay compensation, regardless of
the legal argument employed, is limited to the invoice value of those SKYRC products which were immediately and
directly involved in the event in which the damage occurred.
SkyRC e430 Charger
AC Power Cord
18AWG Wire Charging Cable
CONFORMITY DECLARATION
SKYRC e430 satisfies all relevant and mandatory CE directives and FCC Part 15 Subpart B: 2014.
The product has been tested to meet the following technical standards:
This marking indicates that this product should not be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable reuse of material resources. To return your used device,
please use the return and collection systems or contact the retailer where the product was purchased.
They can take this product for environmental safe recycling.
Conform
Conform
Conform
CE-EMC
FCC-VOC 47 CFR Part 15
Test Standards Title Result
Radio frequency devices
Conform
Conform
EN60335-2-29
CE-LVD
Household and similar electrical appliances –. Safety –.
Part 2-29: Particular requirements for battery chargers.
Conform
This charger is not intended for use by persons (include children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do
not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similar qualified persons
in order to avoid a hazard.
This charger is suitable for charging rechargeable LiPo/LiFe batteries. Do not attempt to recharge non-rechargeable
batteries. Charging other types of batteries may cause fire or explosion.
Never leave the charger unattended when it is connected to its power supply.
The allowable AC input voltage is 100-240V AC. Never connect it to any other voltage.
Protect charger from dust, dirt and damp.
Never place the charger and batteries connected to it on any form of flammable surface. Never operate the charger
in the vicinity of inflammable material or gas.
During charging, the battery must be placed in a well ventilated area . Never place the charger on a carpet or similar
surface.
Take great care to maintain correct battery polarity, and avoid shot-circuit. Read the battery manufacturer's
instructions and adhere to them strictly.
The charger must only be plugged into an earthed socket-outlet (for portable class 1 battery chargers for outdoor
use)
The connection to the supply mains is to be in accordance with the national wiring rules when battery chargers for
installation in caravans and similar vehicles.
Note:
The warranty service is valid in China only.
If you need warranty service overseas, please contact your dealer in the first instance, who is responsible for
processing guarantee claims overseas. Due to high shipping cost, complicated custom clearance procedures to
send back to China. Please understand SkyRC can't provide warranty service to overseas end user directly.
If you have any questions which are not mentioned in the manual, please feel free to send email to info@skyrc.cn
1.
2.
3.
EN61000-3-3
Electromagnetic compatibility (EMC) - Part 3-3: Limitation
of voltage supply systems for equipment with rated
current 16 A.≤
EN61000-3-2
Electromagnetic compatibility (EMC) –
Part 3-2: – Limits for harmonic current emissions (equipment
input current up to and incelding 16 A per phase)
EN55014-1
Electromagnetic compatibility – Requirements for
household appliances, electric tools and similar  
apparatus – Part 1 Emission :
EN55014-2
Electromagnetic compatibility – Requirements for
household appliances, electric tools and similar  
apparatus – Part 2 Immunity Product Family Standard :
RECOMMENDED ACCESSORIES
Tamiya charging cable
5201-0030-01
Crocodile clip
charging cable
5201-0031-01
EC3 charging cable
5201-0034-01
Dean charging cable
520 -00 -013 16
JST/BEC charging cable
5201-0043-01
EN 60335-1: 2012
+A11: 2014
Household and similar electrical appliances - Safety - Part 1:
General requirements
EN 62233: 2008 Measurement methods for electromagnetic fields of household
appliances and similar apparatus with regard to human exposure
Conform
Conform

Specyfikacje produktu

Marka: SkyRC
Kategoria: Ładowarka baterii
Model: e430

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z SkyRC e430, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Ładowarka baterii SkyRC

SkyRC

SkyRC B6AC+ V2 Instrukcja

17 Września 2024
SkyRC

SkyRC SK-100059-01 Instrukcja

17 Września 2024
SkyRC

SkyRC B6 nano Instrukcja

16 Września 2024
SkyRC

SkyRC e680 Instrukcja

15 Września 2024
SkyRC

SkyRC iMAX B6mini Instrukcja

13 Września 2024
SkyRC

SkyRC e430 Instrukcja

13 Września 2024
SkyRC

SkyRC D260 Instrukcja

13 Września 2024
SkyRC

SkyRC e450 Instrukcja

13 Września 2024
SkyRC

SkyRC E6 Instrukcja

13 Września 2024
SkyRC

SkyRC NC2600 Instrukcja

12 Września 2024

Instrukcje Ładowarka baterii

Najnowsze instrukcje dla Ładowarka baterii

Graupner

Graupner Ultramat 12 Instrukcja

13 Stycznia 2025
Graupner

Graupner ULTRA DUO PLUS 30 Instrukcja

13 Stycznia 2025
Fuxtec

Fuxtec FX-E1LG1A Instrukcja

13 Stycznia 2025
Voltcraft

Voltcraft Charge Manager 410 Instrukcja

11 Stycznia 2025
Nitecore

Nitecore UHX1 PRO Instrukcja

11 Stycznia 2025
Envivo

Envivo ENV-1597 Instrukcja

11 Stycznia 2025
Xblitz

Xblitz XC1 Instrukcja

10 Stycznia 2025
Jackery

Jackery Explorer 240 v2 Instrukcja

7 Stycznia 2025
Jackery

Jackery Explorer 1000 v2 Instrukcja

7 Stycznia 2025
Schwaiger

Schwaiger LSET500 513 Instrukcja

7 Stycznia 2025