Instrukcja obsługi Sencor SSS WM10


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Sencor SSS WM10 (5 stron) w kategorii Zatyczka do uszu. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/5
SSS WM20 dual model
SSS WM10 single model
EN Wireless voice microphoneUser Manual
EN Uživatelská příručka Bezdrátový hlasový mikrofon
SK Používateľská príručka Bezdrôtový hlasový mikrofón
HU Felhasználói kézikönyv Vezeték nélküli hangmikrofon
PL Podręcznik użytkownika Mikrofon bezprzewodowy
EN - 2
The SSS WM10 single-channel wireless microphone and the SSS WM20 dual/two-channel
microphone set are radio microphones primarily for voice capture for non-professional, home use.
We reserve the right to make corrections, changes and translations in this user's manual without
prior notice. We encourage you to visit our website for more extensive and up-to-date information.
SAFETY AND OPERATING INSTRUCTIONS
Read this user's manual. Follow his instructions. Use the device in a temperate climate
zone. Have all repairs carried out by qualied personnel.
Protect the device from shocks, drops, impacts, vibrations, dust, moisture and
condensation. Protect the device from getting wet, splashing or spilling any liquid. Do not
use or leave the device near an open ame, in direct sunlight, or near heat sources such as
radiators, stoves, or other heat-producing devices (including ampliers).
Do not tamper with, modify, or replace the device antennas. Reception range is up to 40
m. Do not use the device near computers, strong magnetic elds such as transformers or
speaker magnets.
Use good quality AA batteries for the microphone. For the receiver, use only the supplied
cell (Lithium-ion 3.7 V, 600 mAh, type 18650). Check the batteries regularly for cleanliness
and state of charge. Remove damaged or dead batteries from the device. Replace BOTH
batteries with new full capacity batteries for operation. Remove the batteries from the
device when not in use for an extended period of time. Charge lithium batteries only in the
receiver. Charge the lithium rechargeable cells before storage. Keep the microphone and
connector contacts clean.
Use the microphone only with the supplied receiver. Do not use more than one of the same
or similar devices at the same time. Do not confuse microphones or receivers from di󰀨erent
sets with each other.
Before allowing children to use the device, they must be informed about the correct and
safe use of the device appropriately to their age.
Use only accessories determined by the manufacturer. Do not use gasoline or other
solvents or abrasive cleaners for cleaning. Clean the device only with a dry cloth. Neither
the manufacturer nor the vendor of the device under no condition takes responsibility for
any direct or indirect damages caused by not adhering to instructions for installation, setup,
use, service or cleaning of this device as described in this user's manual.
MICROPHONE AND RECEIVER DESCRIPTION
1
2
3
4 5
EN - 3
Microphone with radio transmitter:
1. Cover with microphone insert: speak towards this place.
2. Display (with frequency): lights up when the microphone is switched on.
3. Power switch: switches the microphone and transmitter on and o󰀨.
4. Battery cover: when unscrewed, it reveals the battery compartment.
5. Battery compartment: insert 2 AA size batteries according to the correct polarity – minus
pole into the spring.
 
VHF radio receiver (single channel for SSS-WM10, dual channel for SSS-WM20):
1. Audio output: jack 1/4" (6.3 mm) unbalanced signal
2. Power switch: moving left (ON) turns the receiver on, moving right (OFF) turns the
transmitter o󰀨. Operating time: approx. 7 hours.
3. Power indicator light: white light on when the receiver is switched on, red light on during charging.
4. Charging connector: charge with a normal USB cable from a 5 V/500 mA power supply. It
takes 2–3 hours to charge the receiver when it is switched o󰀨.
5. Microphone indicator light: When the microphone receives a signal, the signal indicator
lights up.
5a. For a single-channel receiver, the indicator light is always green.
5b. For a two-channel receiver, one microphone lights up green for one microphone and red for
the other.
6. Receiving antenna: for receiving the signal from the transmitter.
7. Battery cover: there is a replaceable 18650 rechargeable battery in the battery
compartment.
PREPARATION AND OPERATION
1. Use only one microphone per radio channel. If you need two microphones, use a dual/two-
channel set with one receiver to capture two independent microphones into one microphone
input. The frequency of the carrier signal is indicated on the receiver and in the battery
compartment of the microphone, depending on the model: 186.2 MHz; 214.2 MHz.
2. Turn the microphone switch to the down position, OFF. Insert 2 new batteries into the
battery compartment of the microphone. Make sure the batteries are in the correct polarity,
with the minus pole facing the spring. Charge or check the rechargeable lithium battery in
the receiver. Use your own 5 V/500 mA USB adapter for charging.
3. Set the MANUAL input level of your amplier to MINIMUM. Ampliers or Bluetooth speakers
with automatic level control are not suitable. Switch on the receiver (white indicator light will
come on) and insert into the desired microphone input.
4. Switch on the microphone, the receiver indicator light turns green, or red for the second
microphone of the double set.
5. Do not leave the microphone near the speaker, and slowly increase the volume of the
microphone input to a suitable level.


Specyfikacje produktu

Marka: Sencor
Kategoria: Zatyczka do uszu
Model: SSS WM10

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Sencor SSS WM10, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Zatyczka do uszu Sencor

Sencor

Sencor SSS WM10 Instrukcja

27 Stycznia 2025
Sencor

Sencor SEP GRIM Instrukcja

24 Grudnia 2024
Sencor

Sencor SEP 540BT Instrukcja

6 Października 2024
Sencor

Sencor SEP 500BT Instrukcja

29 Sierpnia 2024
Sencor

Sencor SEP 510BT Instrukcja

15 Sierpnia 2024
Sencor

Sencor SEP 710BT Instrukcja

15 Sierpnia 2024

Instrukcje Zatyczka do uszu

Najnowsze instrukcje dla Zatyczka do uszu