Instrukcja obsługi Saro FINN 330-1090

Saro Niesklasyfikowane FINN 330-1090

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Saro FINN 330-1090 (4 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/4
Operating Instructions
Heated Display
Model FINN order no. 330-1090
CONTENTS
1. General Information
2. Safety Notes
3. Transportation and Placement
4. Operation
5. Cleaning
6. Technical Data and Special Features
7. Circuit Diagram
8. Waste Disposal
Page 1
Operating Instructions Heated Display Model FINN
1. General Information
• Carefully read these operating instructions through as they contain important information
for the safe and correct use of the appliance.
• It is advisable to keep the operating instructions in a place where you have them always
ready to hand.
• If you pass the appliance to a third party, these operating instructions should be handed
over.
• Dispose the packing material according to the local regulations. All the packaging items
(plastic bags, cardboard, polystyrene foam, nails, etc.) must not be left within reach of
children, in that they are potential sources of danger.
• As soon as you have unpacked the heated display, check whether everything is in a
faultless condition. Should anything be damaged, do not connect the appliance as such,
but inform your dealer.
• The heated display must only be used for the intended purpose, like showing or storage
of hot products/food. Improper use can cause damages and lead to the loss of the
warranty.
• The plastic-coated grids are adjustable.
• In case of fault and/or malfunction, pull the power plug from the socket and inform your
dealer. He will carry out the repair with original spare parts
.
• The manufacturer/dealer cannot be made responsible for damages which arise through
not observing these operating instructions. Apart from this, if these instructions are not
observed, the safety of the heated display is no longer guaranteed.
2. Safety Notes
• Connect the heated display to a properly installed and grounded single power socket. Do
not connect any other appliance to the same outlet.
• The outlet must be easily accessible, so that the plug can easily be removed in the case
of emergency.
• If you pull the plug from the socket, always pull at the plug and never at the cable.
• The cable must not come into contact with water or hot parts.
• Do not touch the cable and the plug with moist or wet hands.
• Regularly check the cable. If it is damaged, it must be exchanged by a specialist.
• Do not block the air intake openings in the heated display. They have to be cleaned from
time to time, because dirt and dust can block the slots.
• Do not place any heavy objects on top of the heated display.
• Never put dangerous products (inammable and explosive) nearby the heated display.
• The heated display is to be used indoors only.
• Repairs may only be undertaken by a qualied specialist using original spare parts.
• Do not attempt to repair the heated display by yourself.
• Ensure that children do not play with heated display respectively the door.
• Before each cleaning or repair pull the power plug out of the socket.
• Do not use a wet rag (only moist), high pressure cleaner or a jet of water.
• If you do not need the heated display for a long time, pull the plug from the socket and
clean everything (see point 5 “Cleaning”).
Page 2
Operating Instructions Heated Display Model FINN
3. Transportation and Placement
• Please be careful during the transportation or moving of the heated display.
• Take good care of the glass panes to prevent breakage.
• Dispose the packing material according to the local regulations. All the packaging items
(plastic bags, cardboard, polystyrene foam, nails, etc.) should not be left within reach of
children, in that they are potential sources of danger.
• Place the heated display on a stable, dry and even surface.
• The distance from both sides and back of the heated display to wall must be at least 10
cm.
• Keep the heated display out of direct sun or other heat sources to ensure correct tempe-
ratures can be achieved.
• Do not block the air intake openings in the headted display.
4. Operation
• Clean the heated display and the grids with a moist cloth and a mild cleaning detergent.
Dry everything carefully. Do not use aggressive detergents, steel wool or high pressure
cleaner or a jet of water. (See also under point 5 “Cleaning”)
• Remove the water bowl and then ll the bowl with water and put it into the appliance.
• Put the grids into the heated display.
• Put the plug into the plug socket.
• The distance of the grids should suit the products height.
• Place the products in a proper way into the heated display, so that nothing falls out, if you
open the door.
• Place not too much into the heated display, because of the air circulation.
• Avoid unnecessary opening of the door.
• Ensure the door is properly closed at all times.
• During power failure open the door rarely and for short time only. Do not insert further
food.
• The heated display has on the back above an analog temperature display. Here you can
see the desired indoor temperature.
• On the back there is a temperature display also, which allows you to set the desired
temperature between 30° and 90° C.
5. Cleaning
• Clean the heated display regularly.
• Before each cleaning pull the power plug from the socket.
• Clean the exterior surfaces and the grids with a soft, damp, warm cloth and a commercial
detergent. Wipe o and dry everything carefully.
• The water bowl has to be descaled from time to time and the glass panes can be cleaned
with a cleaning detergent for windows.
• The glass panes can be cleaned with a cleaning detergent for windows.
• Do not use aggressive detergents, steel wool or abrasive sponges. The heated display
may not be hosed down with water.
• Brush o from time to time the dirt from the slots in the interior of the heated display. Use
at the same time a vacuum cleaner.
• If you do not need the heated display for a long time, pull the plug from the socket and
clean everything as described above.
Page 3

Specyfikacje produktu

Marka: Saro
Kategoria: Niesklasyfikowane
Model: FINN 330-1090

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Saro FINN 330-1090, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Niesklasyfikowane Saro

Saro

Saro GENUA 172-3070 Instrukcja

2 Października 2024
Saro

Saro COROLLA 1G Instrukcja

29 Września 2024
Saro

Saro ISOD 12 Instrukcja

21 Września 2024
Saro

Saro ESP 006 Instrukcja

2 Września 2024
Saro

Saro VERONA 172-3072 Instrukcja

28 Sierpnia 2024
Saro

Saro Romeo Instrukcja

22 Sierpnia 2024
Saro

Saro Henry Instrukcja

16 Sierpnia 2024
Saro

Saro COROLLA 2G Instrukcja

14 Sierpnia 2024
Saro

Saro Clyde Instrukcja

5 Lipca 2024
Saro

Saro FINN 330-1090 Instrukcja

4 Lipca 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024
Husqvarna

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024
Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024