Instrukcja obsługi Rain Bird ESP-TM2

Rain Bird Kontroler ESP-TM2

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Rain Bird ESP-TM2 (11 stron) w kategorii Kontroler. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/11
Rain+Birdt
ESP-TM2 Controller User Manual
1 0220
MI NUTESHOU RSTATION
RE I NINMA G
RU N T IME
Introduction 2 .........................................
Welcome to Rain Bird 2 .............................................
Controller Features 2 .................................................
Installation 2 ...........................................
Mount Controller 2 .....................................................
Wiring Connections 3 ................................................
Connect Valves ...................................................................3
Connect Master Valve (optional) 3 ..................................
Connect Pump Start Relay (optional) 3 .........................
Connect Rain/Freeze Sensor (optional) 4 .....................
Connect Custom Wiring (optional) 4 .............................
Controls and Indicators 5 ........................
Special Features 5 ...................................
Basic Programming 6 ..............................
1. Set Date and Time 6 ............................................
2. Set Watering Start Times ................................6
3. Set Station Run Times 6 .....................................
4. Set Watering Days ............................................6
Custom Days of the Week 6 ...............................................
Manual Watering Options 7 ....................
Test All Stations........................................................ 7
Run a Single Station 7 ...............................................
Run a Single Program 7 .............................................
Normal Operation 7 ................................
AUTO RUN 7 .................................................................
OFF 7 ..............................................................................
Advanced Programming 8 ......................
Odd or Even Calendar Days 8 ..................................
Cyclic Days 8 ................................................................
Rain Sensor 8 ...............................................................
Seasonal Adjust 8 .......................................................
Delay Watering ......................................................... 8
Permanent Days Off................................................ 9
Options 9 ................................................
Reset Button 9 .............................................................
Remote Accessories 9 ................................................
Troubleshooting 10 .................................
Watering Issues 10 ......................................................
Electrical Issues 10 ......................................................
ESP-TM2 Controller
2
Introduction
Welcome to Rain Bird
Thank you for choosing Rain Bird’s ESP-TM2 controller. In this
manual are step by step instructions for how to install and
operate the ESP-TM2.
1 0220
MI NUTESHOURSTAT ION
RE ININMA G
RUN TI ME
Controller Features
Feature Description
Maximum Stations 12
Simultaneous Stations 1 plus master valve
Start Times 4
Programs 3
Program Cycles Custom Days, Odd, Even
and Cyclic
Permanent Days O Per program
Master Valve Control On/O per station
Rain Delay Supported
Rain/Freeze Sensor Supported
Rain Sensor Control Global or by station
Seasonal Adjust Global or by program
Manual Station Run Yes
Manual Program Run Yes
Manual Test All Stations Yes
Station Advance Yes
Short Detect Yes
Delay Between Stations Yes
Accessory Port Yes (5 pin)
Save & Restore Programming Yes
Installation
Mount Controller
A
Drive a mounting screw into the wall, leaving an 1/8 inch
gap between the screw head and the wall surface (use the
supplied wall anchors if necessary), as shown.
B
Locate the keyhole slot on back of the controller unit and
hang it securely on the mounting screw.
1/8 IN.
12
C
Remove the wiring bay cover on the lower part of the
controller unit, and drive a second screw through the open
hole inside the controller and into the wall, as shown.
CONNECT
120 CVA
RESE T
ACCESSORY
1 2 3 4 5 6 7 8
24VAC SENS C M
9 10 11 12
3
NOTE: Choose a suitable mounting location close to a
120 VAC wall outlet.
ESP-TM2 Controller
3
Wiring Connections
Connect Valves
A
Route all eld wires through the opening at the bottom
of the unit, or through the knock-out in back of the unit.
Attach conduit if desired, as shown.
B
Connect one wire from each valve to one of the numbered
station terminals (1-12) on the controller, as shown.
C
Connect a eld common wire (C) to the common terminal
(C) on the controller. Then connect the remaining wire
from each valve to the eld common wire, as shown.
NOTE: The ESP-TM2 controller supports one valve
solenoid per station terminal.
CONNECT
120 CVA
RESET
ACCESSORY
12345678
24VAC SENS C M
9 10 11 12
1
2
4
MASTER
VALVE
C
MV
1
2
S
3
Connect Master Valve (optional)
D
Connect a wire from the master valve (M) to the master
valve terminal (M) on the controller. Then connect the
remaining wire from the master valve to the eld common
wire, as shown.
Connect Pump Start Relay (optional)
The ESP-TM2 can control a pump start relay, to turn the
pump on and off as needed.
A
Connect a wire from the pump start relay (PSR) to the
master valve terminal (M) on the controller. Then connect
another wire from the pump start relay to the eld
common wire, as shown.
B
To avoid the possibility of damage to the pump, connect
a short jumper wire from any unused terminal(s) to the
nearest terminal in use, as shown.
CONNECT
120 CVA
RESET
ACCESSORY
12345678
24VAC SENS C M
9 10 11 12
NOTE:
Connection
to pump
and external
power not
shown. Refer
to pump
installation
instructions. 1
PUMP START
RELAY
2
C
PSR
1
2
NOTE: The ESP-TM2 controller DOES NOT provide
power for a pump. The relay must be wired according to
manufacturer instructions.
Only the following Rain Bird pump start relay models are
compatible with the ESP-TM2:
Description Model # Volts
Universal Pump Relay PSR110IC 110V
Universal Pump Relay PSR220IC 220V

Specyfikacje produktu

Marka: Rain Bird
Kategoria: Kontroler
Model: ESP-TM2

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Rain Bird ESP-TM2, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Kontroler Rain Bird

Rain Bird

Rain Bird ESP-LXME2 Instrukcja

2 Września 2024
Rain Bird

Rain Bird ESP-TM2 Instrukcja

2 Września 2024
Rain Bird

Rain Bird ESP-RZXe Instrukcja

8 Sierpnia 2024

Instrukcje Kontroler

Najnowsze instrukcje dla Kontroler

Thrustmaster

Thrustmaster Ferrari GT Experience Instrukcja

13 Października 2024
Razer

Razer Wolverine V3 Pro Instrukcja

9 Października 2024
Axor

Axor Citterio E 36771001 Instrukcja

9 Października 2024
Hori

Hori Force Feedback Truck Control System Instrukcja

9 Października 2024
Balam Rush

Balam Rush Kontrol Glow G595 Instrukcja

9 Października 2024
Krom

Krom Kumite Instrukcja

9 Października 2024
Krom

Krom Kenzo Instrukcja

9 Października 2024
Canon

Canon imagePRESS V700 Instrukcja

8 Października 2024
Valcom

Valcom V-1094A Instrukcja

8 Października 2024
Valcom

Valcom V-2994 Instrukcja

8 Października 2024