Instrukcja obsługi American DJ DP-DMX20L

American DJ Kontroler DP-DMX20L

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla American DJ DP-DMX20L (6 stron) w kategorii Kontroler. Ta instrukcja była pomocna dla 12 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/6
User Instructions
DP-DMX20L
4 CHANNEL DMX
DIMMER PACK
©2018 ADJ Products, LLC all rights reserved. Information,
specications, diagrams, images, and instructions herein are
subject to change without notice. ADJ Products, LLC logo and
identifying product names and numbers herein are trademarks
of ADJ Products, LLC. Copyright protection claimed includes all
forms and matters of copyrightable materials and information
now allowed by statutory or judicial law or hereinafter granted.
Product names used in this document may be trademarks or
registered trademarks of their respective companies and are
hereby acknowledged. All non-ADJ Products, LLC brands and
product names are trademarks or registered trademarks of their
respective companies.
ADJ Products, LLC and all aliated companies hereby disclaim
any and all liabilities for property, equipment, building, and electrical
damages, injuries to any persons, and direct or indirect economic
loss associated with the use or reliance of any information contained
within this document, and/or as a result of the improper, unsafe,
unsucient and negligent assembly, installation, rigging, and
operation of this product.
Europe Energy Saving Notice
Energy Saving Matters (EuP 2009/125/EC)
Saving electric energy is a key to help protecting the enviroment.
Please turn o all electrical products when they are not in use. To
avoid power consumption in idle mode, disconnect all electrical
equipment from power when not in use. Thank you!
Date Document
Version Notes
DOCUMENT VERSION
Please check www.adj.com for the latest revision/update of this guide.
02/07/18 1 Updated Release
Introduction:
Thank you for purchasing the DP-DMX20L™ 4 channel dimmer pack
from ADJ®. To optimize the performance of this product, please read
these operating instructions carefully and familiarize yourself with the
basic operations of this unit. The ADJ DP-DMX20L,®™ is a four channel,
DMX dimmer pack. This unit has been tested at the factory before
being shipped to you. There is no assembly required.
The ADJ DP-DMX20L™ is controlled via a standard DMX controller. ®
This unit allows you to control special eect lighting, that normally
could not be controlled, by a DMX controller. With this revision to our
popular DP-DMX20™ we have eliminated confusing dip switches and
replaced them with an easy to use digital switching device that incorporates
the use of an easy to read LCD display.
Customer Support:
ADJ Products, LLC provides a toll free customer support line, to provide
help and to answer any question should you encounter problems
during your set up or initial operation. You may also visit us on the web
at www.adj.com for any comments or suggestions. Service Hours are
Monday through Friday 8:00 a.m. to 4:30 p.m. Pacic Standard Time.
Voice: (323) 582-2650
Fax: (323) 582-2941
E-mail: support@americandj.com
Warning!
To prevent or reduce the risk of electrical shock or re, do not expose
this unit to rain or moisture.
Caution!
There are no user serviceable parts inside this unit. Do not attempt any
repairs yourself, doing so will void your manufactures warranty. In the
unlikely event your unit may require service, please contact your nearest
ADJ dealer.®
ADJ Products, LLC® - www.adj.com - DP-DMX20L Instruction Manual Page 2
Power Supply: Before plugging your unit in be sure the source voltage
in your area matches the required voltage for your ADJ® DP-DMX20L.™
The DP-DMX20L™ is available in a 115v and 230v version. Because
line voltage may vary from venue to venue, you should be sure to plug
your power supply into a matching wall outlet before attempting to
operate you controller.
Data Cable (DMX Cable) Requirements:
Your unit and your DMX controller require an approved DMX-512 110
Ohm Data cable for data input and data output (Figure 1). We recommend
Accu-Cable DMX cables. If you are making
your own cables, be sure to use standard
110-120 Ohm shielded cable (This cable may
be purchased at almost all professional sound
and lighting stores). Your cables should be
made with a male and female XLR connector on
either end of the cable. Also remember that
DMX cable must be daisy chained and cannot
be split.
Notice: Do not use the ground lug on
the XLR connector. Do not connect the
cable’s shield conductor to the ground lug or allow the shield conductor
to come in contact with the XLR’s outer casing. Grounding the shield
could cause a short circuit and erratic behavior.
Figure 1
Figure 2
ADJ Products, LLC® - www.adj.com - DP-DMX20L Instruction Manual Page 3
Figure 3
XLR MALE SOCKET
1 EARTH 2 COLD
3 HOT
XLR FEMALE SOCKET
1 EARTHCOLD 2
3 HOT
XLR Pin Configuration:
Pin 1 = Shield
Pin 2 = Data Compliment (negative)
Pin 3 = Data ue (positive)Tr
DP-DMX20L DMX Set Up DP-DMX20L General Information
DMX512 IN
3-PIN XLR
1
2
3
1
2
3
DMX +
DMX -
COMMON
DMX512 OT
3-PIN XLR
1. Mode Button - This button will change the power packs operate
mode between DMX and chaser.
2. Menu Button - This button will activate the dierent functions in
DMX and chase modes.
3. Up Button - This button will increase the displayed value in the
LCD display.
4. Down Button - This button will decrease the displayed value in the
LCD display.
5. POWER OUTPUT - 3-prong grounded Edison output sockets. 8
total output sockets. Each channel has an output maxiimum of 6.3
amps. The unit has an output maximum of 15 amps
6. GREEN L.E.D. Indicators - These LEDs will indicate their relevant
channel activity.
7. LCD Display - This multifunction display will detail all chase and
program activity that pertains to the current operating mode of the
pack.
ADJ Products, LLC® - www.adj.com - DP-DMX20L Instruction Manual Page 5
Figure 5
1 42 3
2 4 3
7
6
5
1
Special Note: Line Termination.
When longer runs of cable are used, you may need to use a terminator on
the last unit to avoid erratic behavior. A terminator is a 90 - 120 ohm 1/4
watt resistor which is connected between pins 2 and 3 of a male XLR
connector (DATA + and DATA -). This unit is inserted in the female XLR
connector of the last unit in your daisy chain to terminate the line. Using
a cable terminator will decrease the possibilities of erratic behavior.
Product Description:
The DP-DMX20L,™ is 1, 2, or 4 channel DMX Dimmer Pack.
This pack can serve as a stand alone chaser or a DMX dimmer
pack. This pack is designed for zero-crossing circuitry which
protects against inductive loads, so it is safe for use with all
lighting eects that include transformers such as pin spots.
Each channel comes with two 3-prong Edison sockets inputs
for a total of eight. This unit features XLR female and male connection
for DMX compatibility. Each channel is equipped with a fuse for
each channel, and a maximum output load of 6.3A per chan-
nel or 15A total. This revision of our popular DP-DMX20™ has
a great new case design that makes it great for permanent or
mobile applications.
ADJ Products, LLC® - www.adj.com - DP-DMX20L Instruction Manual Page 4
DP-DMX20L Functions & Controls - Front Panel DP-DMX20L DMX Set Up
1
2
3
Termination educes signalr errors and
avoids signal transmission problems
and interference. It is always advisable
to connect a DMX terminal, (Resistance
120 Ohm 1/4 W) between PIN 2 (DMX-)
and PIN 3 (DMX +) of the last fixture.
Figure 4

Specyfikacje produktu

Marka: American DJ
Kategoria: Kontroler
Model: DP-DMX20L

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z American DJ DP-DMX20L, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Kontroler American DJ

American DJ

American DJ STAGE SETTER-8 Instrukcja

30 Marca 2025
American DJ

American DJ DP-DMX20L Instrukcja

30 Marca 2025

Instrukcje Kontroler

Najnowsze instrukcje dla Kontroler

Sonance

Sonance VC60R Instrukcja

2 Kwietnia 2025
Trust

Trust Mylox GXT 735G Instrukcja

30 Marca 2025
Trust

Trust Mylox GXT 735 Instrukcja

30 Marca 2025
Visual Productions

Visual Productions TimeCore Instrukcja

30 Marca 2025
PCE Instruments

PCE Instruments PCE-RE22T Instrukcja

28 Marca 2025
Turtle Beach

Turtle Beach Recon Instrukcja

27 Marca 2025
Metronic

Metronic Zap 3 495383 Instrukcja

26 Marca 2025
Deltaco

Deltaco GAM-103 Instrukcja

2 Marca 2025
AMX

AMX MU-3300 Instrukcja

26 Lutego 2025
PowerA

PowerA Enhanced Wireless Controller Instrukcja

26 Lutego 2025