Instrukcja obsługi Quadral All

Quadral Głośniki All

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Quadral All (23 stron) w kategorii Głośniki. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/23
USER INSTRUCTIONS
BEDIENUNGSANLEITUNG
NOTICE D´UTILISATION
MANUAL DE INSTRUCCIONES
ENGLISH · DEUTSCH · FRANÇAIS · ESPAÑOL
2
ENGLISH
3
Contents/Inhalt/Sommaire/Índice
Safety notes 3-4
Setting up 5-6
Stands and wall mounts 6
Connecting up your amplifier 6-9
Beware of clipping 10
Tips for better acoustics 10
Care of loudspeakers 11
What to do if your speakers don‘t sound right ? 12
Sicherheitshinweise 13-14
Aufstellung 15-16
Stative und Wandhalterungen 16
Anschluss an den Verstärker 16-19
Vorsicht Clipping 20
Tipps für eine bessere Akustik 20
Pflege der Lautsprecher 21
Was tun in Störungsfällen ? 22
Sécurité 23-24
Installation 25-26
Pieds et supports muraux 26
Raccordement 26-29
Attention au «clipping» 30
Conseils pour une meilleure acoustique 30
Nettoyage des haut-parleurs 31
Que faire en cas d’anomalies ? 32
Seguridad 33-34
Disposición 35-36
Soportes de pie y de pared 36
Conexión al amplificador 36-39
Cuidado con el Clipping 40
Consejos para una mejor acústica 40
El mantenimiento de las cajas acústicas 41
¿Qué hacer en caso de avería? 42
ENGLISH
FRANÇAIS
ESPAÑOL
DEUTSCH
First of all, thank you for deciding on quadral loudspeakers.
It is to satisfy the high expectations of music lovers and connoisseurs
such as you that we build loudspeakers of a class that is well above
average. Even though you may already be familiar with them, we list
below a few ground rules that will enable you to make optimal use of
your loudspeakers.
Safety advice for passive loudspeakers
Please take time to read through the manual carefully and follow all the steps describing
how to set up and operate the loudspeakers. Keep the manual somewhere you can
quickly access it should you have any questions later on.
• The stability of loudspeakers (especially large units) depends on the nature of the
surface on which they stand. Carpets are often very poor for stability. Even an
average bump can cause a loudspeaker to fall over and be a hazard for persons
or pets in the vicinity. Stability can be significantly improved by using “spikes”, but
care should be taken during assembly as the sharp points can cause injury and the
spikes can damage the floor. On smooth floors, the loudspeakers can be stabilised
with Velcro or double-sided tape. Loudspeakers should never be used as a seat or as
a substitute for a ladder!
• Use only wheeled furniture, stands or wall mounting systems and other devices for
attaching and installing the products, which are available from the manufacturer and
are sold for or with the product. To avoid damage or injury through tipping over,
please be careful when moving table devices or stands on which the speakers are
mounted. If wall-mounting the product, take special care that all components are
securely screwed! Additional securing equipment (chains, etc.) should be fitted.
• The location for the loudspeakers should be dry and not too cold. Constant high
humidity or strong sunlight (UV radiation) can cause your loudspeakers to age
prematurely and consequently affect their functioning.
• Very high volume levels for long periods of time are not only annoying for your
neighbours, but can also be harmful to the health of the user!
• When loudspeakers are overloaded with very high volume levels, there is a risk
of individual components in crossover circuits or individual speakers burning out.
In particularly bad cases, it is even possible for fire to break out inside a speaker.
Speakers operated at these extremes should therefore not be left unattended.
• At high volumes, voltage levels of 30–50 V can be present at speaker terminals and
components. Be very careful not to touch uninsulated terminal contacts of speakers
4
ENGLISH
5
Setting up
To obtain optimal sound results, it is generally necessary to try out different set-ups.
Since the room conditions have a major effect on sound reproduction, we suggest below
a few useful approaches for positioning your quadral loudspeakers.
Main speakers (front)
Where the speakers are positioned in the listening space has a decisive effect on their
sound. Placing the speakers near the corners of the room will essentially give you loud
bass reproduction but with little outline. On the other hand, speakers positioned well
away from the walls sound precise, but also very bright and thin. The best solution is to
place the speakers with at least 30 cm between their backs and the nearest wall. To avoid
loud wall reflections, the distance from the side walls of the room can even be 50 cm or
more. Bookshelf speaker units sound best on a speaker stand or shelf, with the tweeters
arranged at ear height. The cases should be angled and slightly tilted to achieve this.
Ss far as possible, the speakers should be equidistant from the listening position, while
the distance of the speakers from each other can be rather less than the distance from
the listener.
Front centre speaker
Due to the proliferation of plasma and
LCD TVs, these speakers are no longer
shielded magnetically. This causes colour
and geometrical errors and can occur
on older TVs with picture tubes. Since
it can’t be placed on the TV set, the
center speaker can be set lying down
underneath it. The speaker should be at
least 30 cm from the television, and a
minimum of 20 cm from the floor. Apart
from the above, we recommend angling
the center speaker so that the tweeter is
aimed at the listener in order to enjoy its
full sound potential.
when in operation. To avoid injury, never put hands or arms into sound outlets (bass
reflex tubes). Children and pets, in particular, are at risk from this.
• For safety reasons, we generally forbid the opening of loudspeaker cabinets when in
operation or connected since, as explained in the above paragraph, voltages of up
to 50 volts can be present inside.
• Improper handling of mains voltage can cause fatal injury!
Passive loudspeakers must on no account be connected to the electricity supply!
Speaker terminals may only be connected to the appropriate output terminals of
the amplifier. You should never connect these terminals to the electricity supply
(230 V/115 V) in any way since that will otherwise also immediately destroy the
loudspeaker and all connected products. Avoid fitting plugs to ends of speaker cables
that could even remotely be confused with mains supply plugs.
• Loudspeakers that are not magnetically shielded can affect the colour of the TV picture
or cause distortion. A distance of 50 cm is generally sufficient to avoid problems of
this kind. Avoid placing items such as credit cards, diskettes, audio or video cassettes
or other magnetic media on the loudspeaker. This could destroy the information stored
on them. Similarly, avoid operating magnetic tape devices in the immediate vicinity.
CENTER
FRONT
TV
FRONT
SUBWOOFER
REAR
REAR
50 cm
>
–
REAR
CENTER

Specyfikacje produktu

Marka: Quadral
Kategoria: Głośniki
Model: All

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Quadral All, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Głośniki Quadral

Quadral

Quadral All Instrukcja

27 Września 2024
Quadral

Quadral AURUM 9 PASSIV Instrukcja

27 Września 2024
Quadral

Quadral AURUM active Instrukcja

27 Września 2024
Quadral

Quadral Subwoofer Instrukcja

27 Września 2024
Quadral

Quadral Breeze Instrukcja

27 Września 2024

Instrukcje Głośniki

Najnowsze instrukcje dla Głośniki

Steren

Steren SPK-1100BL Instrukcja

15 Października 2024
Pyle

Pyle PBMSPG6 Instrukcja

14 Października 2024
Marshall

Marshall Tufton Instrukcja

14 Października 2024
Sunstech

Sunstech SPUBT780 Instrukcja

14 Października 2024
Definitive Technology

Definitive Technology Mythos XTR-50 Instrukcja

14 Października 2024
Wharfedale

Wharfedale Diamond 8.2 Pro Instrukcja

14 Października 2024
Bang & Olufsen

Bang & Olufsen BeoLab Penta Instrukcja

13 Października 2024
Marquant

Marquant 002-222 Instrukcja

13 Października 2024
Naxa

Naxa NAS-3060 Instrukcja

13 Października 2024
Philips

Philips SPA1301 Instrukcja

13 Października 2024