Instrukcja obsługi Pyle PWD701

Pyle system alarmowy PWD701

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Pyle PWD701 (10 stron) w kategorii system alarmowy. Ta instrukcja była pomocna dla 10 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/10

Standard Features:

Two 4-Button Remote Transmitters

Status indicator (LED)

Valet / override switch

Multi-tone siren

Dual stage impact detector

Remote panic

Remote chirp mute

Remote sensor bypass

Active or passive arming

Optional Features:

Starter disable

Flashing parking lights

Keyless entry

Remote trunk or hatch release

Illuminated entry

Anti-Carjacking

Hood and trunk protection

Remote auto start

Power window roll up

Back-up battery w/charging circuit

Glass break sensor

Note: Some features may require additional

parts and labor, and may not be appropriate

for certain vehicles. Consult your authorized

dealer.

Sy astem Oper tion

ARMING OPERATION

To arm the system press transmitter button 1:

• The siren will chirp once.

• The parking lights will flash once.*

• The doors will lock.*

• The LED will turn solid for 10 seconds

then start flashing slowly. After 10

seconds the system is armed.

After Arming, if the system detects a bad

sensor or an open zone, the siren will chirp

and the parking lights will flash 4 times to

indicate a zone is open. The system will

ignore that input, but keep all other areas

protected.

While Armed, the system will trigger if:

• The doors are opened.

• The shock sensor detects an impact

to the vehicle.

• The hood or trunk is opened*.

When triggered, the siren will sound, the

horn will honk*, and the parking lights will

flash* for 30 seconds.

If the same input triggers the system 3 times

during a single arming cycle, the system will

bypass that input, keeping the other zones

protected, until the next time the system is

armed.

If the shock sensor detects a light impact to

the vehicle, the siren will chirp and the

parking lights will flash 5 times* to warn

away the potential intruder.

*Optional Feature

1R / 4-BUTTON SERIES

VEHICLE SECURITY SYSTEM

Button

PASSIVE ARMING

The passive arming feature automatically

arms the system after closing all doors.The

Passive Arming feature requires the ignition

to have been on for at least 10 seconds

prior to exiting the vehicle. This enables the

key to be turned on then off quickly to

avoid passive arming in the event of

refueling, washing the vehicle, etc. The

Passive Arming feature may be enabled

during installation.

To arm the system passively:

1. Turn the ignition key off (make sure

ignition was on for at least 10

seconds).

2. Exit the vehicle and close all doors.

• Siren will chirp 1 time when last

door is closed.

• The LED flashes rapidly indicating

that the system is preparing to arm.

(The system can be armed any time

by pressing transmitter button 1.)

• If the optional countdown feature is

programmed, the siren will chirp

every 2 seconds until armed.

• The siren will chirp 30 seconds after

the last door is closed to indicate

the system is armed. NOTE: Opening

a door resets the passive arming

timer.

• The doors will lock.†*

† If Passive Locking was enabled during installation.

DISARMING OPERATION

To disarm the system press transmitter

button 2.

• The siren will chirp twice.

• The parking lights will flash twice.*

• The doors will unlock.*

• The dome light will turn on for 30

seconds.*

TWO STAGE DISARM

If the alarm has been triggered

• Press button 2 will turn off siren/horn,

but alarm will remain armed.

• Press button 2 again.

• The siren will chirp 3 times.

• The parking will flash 3 times.*

• The doors will unlock.*

• The Dome light will turn on for 30

seconds.*

TAMPER ALERT

If the alarm was triggered while away from

the vehicle, the siren will chirp 3 times and

the parking lights will flash 3 times on

disarming for tamper indication.

AUTO REARM

The Auto Rearm feature allows the system to

automatically re-arm and lock the doors* in

the event the system is disarmed and a door

is not opened within 30 seconds. This

programmable feature may be enabled during

installation.

SILENT ARMING/DISARMING

Press transmitter button 3 to silently Arm or

Disarm the system for one-time operation.

The system can also be programmed for full-

time silent operation during installation.

IGNITION LOCK*

The ignition locking feature automatically

locks the doors 5 seconds after the ignition

key is turned on, and automatically unlocks

when the ignition key is turned off. To avoid

locking keys in the vehicle, the ignition

locking feature will be cancelled if a door is

open when the ignition is turned on. This

feature may be enabled during installation.

REMOTE PANIC

In the event of an emergency (PANIC)

situation, the system’s siren can be triggered

for 30 seconds to attract attention. To

activate the Panic Feature, press transmitter

button 1 for 2 seconds:

• The siren will sound.

• The horn will honk*

• The parking lights will flash*.

Press button 1 to exit panic mode and

rearm the system. Press button 2 to exit

panic mode and disarm system. The Panic

Feature will not operate when the ignition

is on.

*Optional feature

EMERGENCY OVERRIDE

If the transmitter becomes lost or fails to

operate, the system can be disarmed by

using the emergency override feature.

To override the system:

1. Enter the vehicle.

• The alarm will trigger.

2. Turn on the ignition key.

3. Press the Valet switch for 3 seconds.

• The siren will stop sounding.

• The starter defeat will be bypassed.

• The system will enter valet mode.

VALET MODE

When the system is placed into the Valet

Mode the security system will be disabled.

However, the optional keyless entry and

trunk release features will still function if

installed. The valet feature may be accessed

using the valet switch or using the remote

transmitter.

To enter or exit valet mode using the

switch:

1. Be sure the system is disarmed.

2. Turn the ignition key on.

3. Press and hold the valet switch for 3

seconds.

• The siren will chirp once to enter

valet or twice for exit.

• The LED will turn on solid indicating

the system is in valet mode, or turn

off indicating valet mode exit.

To enter or exit valet mode using the

remote:

1. Be sure the ignition key is off.

2. Press transmitter button 2 then button

1 and hold for 3 seconds.

• The siren will chirp once to enter

valet or twice for exit.

• The LED will turn on solid indicating

the system is in Valet Mode, or turn

off indicating Valet Mode exit.

OPTIONAL TRUNK RELEASE

Press button 4 for approximately 2 seconds

to open the trunk.

OPTIONAL TRUNK DISARM

The trunk disarm feature allows the alarm

to disarm automatically whenever

transmitter button 4 is used to activate the

optional trunk release. This eliminates

having to first disarm the alarm before

activating the trunk release. This feature

may be programmed during installation.

Optional Auxiliary 2 output

This programmable output can be used to

activate other accessories in your vehicle

(remote engine start, turn on headlights,

window roll up).

Pressing transmitter button 1 will arm the

system and activate 30 second output.

Press and Hold buttons 3 and 4 will activate

Auxiliary 2 output for as long as the buttons

are depressed

This feature may be programmed during

installation, and may require additional

parts, and labor.

REMOTE SENSOR BYPASS

To arm the system and bypass the shock

sensor, press button 1 to arm, then within 2

seconds press button 4. The siren will chirp

once and sensors will be ignored until the

system is disarmed and rearmed.

ANTI HIJACKING MODES*

You may select from 1-3 options:

1. Ignition Activated Anti Hijack Mode

Specyfikacje produktu

Marka:	Pyle
Kategoria:	system alarmowy
Model:	PWD701

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Pyle PWD701, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje system alarmowy Pyle

Pyle PWD901 Instrukcja

16 Sierpnia 2024

Pyle PWD701 Instrukcja

6 Lipca 2024

Instrukcje system alarmowy

Najnowsze instrukcje dla system alarmowy

Indexa MA80P Instrukcja

11 Grudnia 2024

Hager S261-22F Instrukcja

8 Grudnia 2024

Hager RLD464F Instrukcja

8 Grudnia 2024

Hager RLA176X Instrukcja

8 Grudnia 2024

Hager RLF660X Instrukcja

8 Grudnia 2024

Hager RLD454F Instrukcja

8 Grudnia 2024

Hager RLD414X Instrukcja

8 Grudnia 2024

Hager S121-22X Instrukcja

8 Grudnia 2024

Hager RLF001X Instrukcja

8 Grudnia 2024

Hager S272-22F Instrukcja

8 Grudnia 2024