Instrukcja obsługi Pyle PLMRCMR50

Pyle kamera PLMRCMR50

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Pyle PLMRCMR50 (6 stron) w kategorii kamera. Ta instrukcja była pomocna dla 6 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/6
PLMRCMR50
7'' Digital Marine Camera & Monitor System
RV Camera, Water-Resistant with Built-in Microphone,
150 Degree Rear View Camera (White)
WARNING: Failure to read and follow these warnings and instructions may result in
serious injury, including damaged property, so please pay close attention and exhibit
the utmost care.
The Digital Backup Camera is designed as an aid to the driver in detecting potentially
hazardous driving conditions, obstructions, and large stationary objects. You, the
driver, must also remember to drive safely and properly. Use of the Digital Backup
Camera is not a substitute for safe, proper and legal driving practices.
Never back up while looking only at your connected monitor display screen.
You should always check behind and around the vehicle when backing up just as you
would if the vehicle did not have the Digital Backup Camera. Always make sure your
driving area is clear. Always back up slowly and with caution.
Never depend on the Backup Camera entirely when backing up. The image on the
monitor display screen may be slightly dierent from actual and real‐time conditions.
Objects viewed in the rear view monitor dier from actual distances because a wide‐
angle lens is used. So use the camera as an aid and always follow intended driving
practices to properly judge distances from objects.
The Backup Camera's assisted low lux lighting performance feature is also an aid to a
driver. Always use your own eyes to conrm the vehicle’s surroundings, as the displayed
image may be not well lit or not entirely visible. Always proceed with caution and
perform double‐checks before proceeding.
The area displayed by the Backup Camera is limited. It does not display objects that
are close to or just below the bumper, underneath the vehicle, or objects out of the
cameras view. The camera's view can change according to your vehicle's orientation
on the road or changing road conditions.
Be sure to check the camera is properly functioning, is properly positioned and
securely mounted, every time you operate your vehicle.
Make sure your trunk or hatch operates correctly, as intended, before and after
installation.
Proceed with caution when cleaning your vehicle around the camera. Avoid excess
water exposure around the camera especially with spraying or a power washer.
Please make sure to keep the camera clean and unobstructed from any debris.
Follow all trac laws and motor vehicle regulations.
www.PyleUSA.com
2
Please read all of the installation instructions carefully before installing the
product. Improper installation will void manufacturer’s warranty.
The installation instructions do not apply to all types of vehicles, and are written
as guidelines to assist in installing the system. Please consult an experienced
technician if you are not comfortable installing the product. Prior to using and
installing the Backup Camera System, please read the safety information provided
in this user manual. Be sure to use the product as outlined in this user manual.
Altercation or modications carried out without appropriate authorization may
invalidate the user's right to operate the equipment.
Consult local laws and regulations for any restrictions on installation or use.
Using a Backup Camera System is not adequate enough to completely eliminate a
vehicles blind spot. Always remember to drive with caution, following all trac laws.
System Installation and Wiring
Note: Camera System installation on diesel vehicles may require a slightly dierent
wiring install.
Caution: Connecting to other types of electrical systems will cause damage to your
vehicle. Please contact the manufacturer if you are unaware of the system type in your
vehicle. Refer to the model's power requirements prior to connection and installation.
Quick Installation
This rearview backup camera system comes with camera and installation wiring.
When installing, the camera is preferably to be mounted in the rear of your vehicle
(just above the license plate).
This kit includes necessary wiring and cable connector accessories sucient for typical
connections. However, additional accessory cables and installation materials may be
necessary for completely secure and operational backup camera performance.
Camera Connection
Connect the camera to the using the included DC 12V power cable. Connect the DC
12V power cable to the positive 12V reverse tail light in the rear of your vehicle.
Then, connect the black wire, of the DC 12V power cable, and ground properly.
This connected power and ground cable then connects to the camera, and will supply
power to the camera directly.
Next, use the included yellow RCA video connector cable, and run that cable from the
yellow RCA video connector jack of the camera, to the yellow video connector of your
compatible display monitor.
The yellow RCA cable when connected, automatically retrieves the video signal when
activated (when your vehicle is switched into the reverse gear).
Installation Transcript
1. Locate the reverse taillight wiring behind your vehicle's reverse light.
You may need to remove an interior panel, or other cover, in order to locate the
wiring. Connect the included power 12V DC power cable to the reverse light.
Connect the power cable's Red wire to your vehicle's reverse light positive wire.a.
Connect the power cable's Black wire to your vehicle's reverse light negative wire.b.
2. Connect the camera to this 'reverse light' connection installation, then mount the
camera in the desired location.
3. Run the RCA video cable from the camera to your compatible video displa monitor.
www.PyleUSA.com 3


Specyfikacje produktu

Marka: Pyle
Kategoria: kamera
Model: PLMRCMR50

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Pyle PLMRCMR50, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje kamera Pyle

Pyle

Pyle PLMRCMR50 Instrukcja

6 Grudnia 2024
Pyle

Pyle PLCM11 Instrukcja

10 Września 2024
Pyle

Pyle PLCM26 Instrukcja

8 Września 2024
Pyle

Pyle PLMRCT43WT Instrukcja

7 Września 2024
Pyle

Pyle PWFI23 Instrukcja

6 Września 2024
Pyle

Pyle PLCM4565 Instrukcja

4 Września 2024
Pyle

Pyle PLMRC76WT Instrukcja

3 Września 2024
Pyle

Pyle PSCNPHO32 Instrukcja

2 Września 2024

Instrukcje kamera

Najnowsze instrukcje dla kamera

Canon

Canon WFT-E9 Instrukcja

13 Stycznia 2025
Mamiya

Mamiya C330 Instrukcja

12 Stycznia 2025
Pentax

Pentax Optio S40 Instrukcja

11 Stycznia 2025
Pentax

Pentax Optio S5i Instrukcja

11 Stycznia 2025
Elmo

Elmo MA-1 Instrukcja

11 Stycznia 2025
Leica

Leica M11-D Instrukcja

5 Stycznia 2025