Instrukcja obsługi Panasonic TY-SP50P8WK

Panasonic Głośniki TY-SP50P8WK

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Panasonic TY-SP50P8WK (28 stron) w kategorii Głośniki. Ta instrukcja była pomocna dla 9 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/28
TQZH663
Monteringsanvisningar
Högtalare för plasma-monitor
Innan arbetet påbörjas ska du noga läsa dessa anvisningar och
bruksanvisningen som medföljer plasmaskärmen för att försäkra att arbetet
utförs på rätt sätt.
(Bevara dessa anvisningar. Du kan behöva anlita dem på nytt för underhåll
eller flyttning av hållaren.)
Monteringsvejledning
Højttalere til plasmaskærm
Før arbejdet påbegyndes, skal De omhyggeligt læse disse instruktioner og
betjeningsvejledningen til plasmaskærmen for at sikre at opsætningsarbejdet
udføres korrekt.
(Gen disse instruktioner. De kan få brug for dem ved vedligeholdelse, eller
hvis ophænget skal flyttes.)
Instrucciones de instalación
Altavoces para Pantalla de Plasma
Antes de empezar el trabajo, lea atentamente estas instrucciones y el manual
de la pantalla de plasma para asegurar una instalación correcta.
(Guarde estas instrucciones. Podrá necesitarlas cuando haga trabajos de
mantenimiento o mueva el soporte.)
Instructions d’installation
Enceintes pour écran Plasma
Avant de commencer le travail, lisez attentivement ces instructions ainsi que le
mode d’emploi de l’écran large à plasma de manière à réaliser un montage
convenable.
(Conservez soigneusement les présentes instructions. Vous pouvez en avoir
besoin pour effectuer un entretien ou si vous désirez déplacer l’applique.)
Instruzioni per I’installazione
Altoparlanti per lo Schermo al Plasma
Prima di iniziare il montaggio leggere attentamente queste istruzioni ed il
manuale dello schermo al plasma allargato per poter procedere al montaggio
in modo corretto.
(Conservare poi queste istruzioni che si renderanno necessarie per la
manutenzione e l’eventuale spostamento della staffa.)
Installatiehandleiding
Luidsprekers voor Plasmadisplay Monitor
Lees deze installatiehandleiding en de bedieningshandleiding voor het
plasmascherm zorgvuldig door voordat u begint, zodat de
montagewerkzaamheden op de juiste wijze worden uitgevoerd.
(Bewaar deze handleiding. U hebt de handleiding weer nodig wanneer u de
bevestigingssteun verwijdert of verplaatst.)
Installationsanleitung
Lautsprecher für Plasmadisplay
Vor der Ausführung lesen Sie bitte diese Anleitung und die
Bedienungsanleitung für das Plasmadisplay sorgfältig durch, damit die
Anbringung richtig ausgeführt wird.
(Bitte bewahren Sie diese Anleitung auf. Sie kann bei der Wartung oder der
erneuten Anbringung der Halterung benötigt werden.)
Installation Instructions
Speakers for Plasma Display
Before commencing work, carefully read these Instructions and the Manual for
the plasma display to ensure that fitting is performed correctly.
(Please keep these instructions. You may need them when maintaining or
moving.)
EnglishDeutschNederlandsItalianoFrançaisEspañolSvenskaDansk
TY-SP37P8W-K
TY-SP37P8W-S
TY-SP42P8W-K
TY-SP42P8W-S
TY-SP50P8W-K
TY-SP50P8W-S
MODEL No.
2
English
CAUTION
After installing the speakers, do not hold or move the display by lifting the speakers.
• The mounting brackets may get damaged, and personal injury may result.
Do not suspend the speakers.
• Personal injury may result if the speakers fall off. Take particular care to ensure the safety of children.
These speaker are for use with the Plasma Display.
• If connecting them to some other amplifier, make sure that the maximum input is within the rated level(8W). If the
input level is exceeded , fire may result.
Make sure that all screws are tightened securely during installation.
• Ensure that the installation is carried out correctly to prevent the speakers from becoming detached, and possibly
causing possible personal injury.
Safety Precautions
Mounting bracket
(right) .......................2
Mounting bracket
(left) .........................2
Bracket mounting
screw .....................12
Sponge ....................2 Speaker cable
(20 cm) ...................2
Accessories
• Attach the sponges to the surfaces which are in
contact with the Display.
• Clean the surfaces before attaching the sponges.
• Attach the sponge along the rib on the speaker.
1. Attach the sponges to the
speakers.
2. Attach the mounting
brackets to the speakers.
Installation Installing to the Plasma Display
For right For left
Mounting
brackets
(right)
Mounting
brackets
(left)
Bracket mounting
screws
Bracket mounting
screws
Speaker (Ieft)
Speaker (right)
Trim
Sponges
rib
Side of the
speaker
• Secure the top and bottom mounting bracket by
tightening the bracket mounting screw.
• As shown in the enlarged views, adjust the
speakers so that there is some clearance between
them and the display by sliding the right speaker
to the right, and the left speaker to the left, and
then secure the bracket mounting screws.
• Securely tighten the bracket mounting screws.
3
English
1. If connecting to an external amplifier that exceeds the
rated input for the speakers, keep the amplifier volume
suitably low to protect the speakers from damage. If any
problems occur with speaker operation, disconnect the
mains lead of the amplifier and consult a qualified service
technician.
2. Do not place the speakers in the following places:
• Areas that are exposed to direct sunlight
• Near heaters or other heat sources
• Areas subject to high humidity
3. This set is equipped with magnetic resistant speakers.
However be careful not to place it near a CRT as it may
cause color patches.
4. To clean the speakers, wipe them with a soft cloth. If
they are extremely dirty, wipe them with a cloth that has
been soaked in a small amount of household detergent,
and then wipe them dry with a separate cloth.
• Do not use solvents such as alcohol or thinner.
• If using chemically-treated cloths, follow the
instructions supplied with the cloth packaging.
Notes on use
• Secure the top and bottom mounting brackets by
tightening the bracket mounting screws.
• Secure the left speaker in the same way.
• To change the amount of clearance between the
speakers and the display, loosen the bracket
mounting screws, make adjustments as desired,
and then tighten the screws.
• Tighten the bracket mounting screws securely so
that the speakers are not loose and do not rattle.
4. Secure the speakers in
place.
• Insert the hooks and pin on the top and bottom
mounting brackets simultaneously into the slots at
the rear of the plasma display, and then lower the
speaker into place.
• Attach the left speaker in the same way.
3. Attach the speakers to the
Plasma Display.
• After preparing the ends of the speaker cables, connect them as shown.
•
The red cable is for the (+) side and the black cable is for the (-) side. Do not connect the cables to the wrong sides.
• When connecting the speaker cable, make sure that the core of the cord does not short.
5. Connect the speaker cables.
Hook
Slot
Bracket mounting
screw
Rear of
Plasma Display
Rear of Plasma Display
1. Press down on the lever.
2. Insert the
cable.
3. Release the lever.
1. Push down the lever.
3. Return the lever to its
normal position.
2. Insert
the cable.
Preparing the ends of the
speaker cables
Remove while
twisting

Specyfikacje produktu

Marka: Panasonic
Kategoria: Głośniki
Model: TY-SP50P8WK

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Panasonic TY-SP50P8WK, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Głośniki Panasonic

Panasonic

Panasonic TY-SP50P8WK Instrukcja

9 Sierpnia 2024

Instrukcje Głośniki

Najnowsze instrukcje dla Głośniki

Steren

Steren SPK-1100BL Instrukcja

15 Października 2024
Pyle

Pyle PBMSPG6 Instrukcja

14 Października 2024
Marshall

Marshall Tufton Instrukcja

14 Października 2024
Sunstech

Sunstech SPUBT780 Instrukcja

14 Października 2024
Definitive Technology

Definitive Technology Mythos XTR-50 Instrukcja

14 Października 2024
Wharfedale

Wharfedale Diamond 8.2 Pro Instrukcja

14 Października 2024
Bang & Olufsen

Bang & Olufsen BeoLab Penta Instrukcja

13 Października 2024
Marquant

Marquant 002-222 Instrukcja

13 Października 2024
Naxa

Naxa NAS-3060 Instrukcja

13 Października 2024
Philips

Philips SPA1301 Instrukcja

13 Października 2024