Instrukcja obsługi MyMix RX-2

MyMix edytor RX-2

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla MyMix RX-2 (8 stron) w kategorii edytor. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/8
OWNER’S MANUAL
INTRODUCTION
TABLE OF CONTENT
The RX-2 is a networkable audio mixer for the myMix system. It is designed for
remote configuration using the myMix Control interface. Like a myMix can it select
audio channels from the network and create a stereo mix. The optional RM-RX
rackmount kit allows for installations in 19" racks.
Introduction
Safety Information
Warnings & Caution
Declaration of Conformity (USA)
Information for Users on Collection and Disposal of Old Equipment
Limited Warranty
Hardware
Installation
Operation
Specifications
Firmware Update
RX-2
1
2
3
4
5
5
6
6
7
8
8
1
2
SAFETY INSTRUCTIONS
IMPORTANT! Read the following before operating myMix
1. Read all safety and operating instruction before using myMix.
2. Keep these instructions in a safe place for future reference.
3. Heed all warnings and follow all instructions.
4. Do not use the unit near water, e.g. a bathtub, or swimming pool. myMix
5. Clean only with dry cloth, and keep moisture away from the unit.
6. Do not block any ventilation openings. Install and use only in accordance with the
manufacturers instructions.
7. Do not install or use near any heat sources such as radiators, heat registers,
stoves, or other apparatus (including power amplifiers) that produce heat.
8. Protect the power cord from being walked on or pinched. Replace the power supply
it if the power cord or power supply shows signs of damage.
9. Only use attachments and accessories specified by the manufacturer.
10. The unit should only be used with a power supply as specified from the myMix
manufacturer. If the provided plug of the power supply does not fit in your outlet,
consult your local dealer for the appropriate outlet.
11. Do not handle the power supply and other power cables with wet hands or on wet
floor to avoid the risk of electric shock.
12. Unplug the unit during lightning storms. myMix
13. Refer all servicing to qualified service personnel. Do not attempt to open the unit
yourself. Servicing is required when the myMix unit has been damaged in any way,
liquid has been spilled or objects fallen into the unit, the unit has been exposed to
water or moisture, does not operate normally, or has been dropped.
14. Exchanging the internal battery for memory should only be done by qualified
personnel. Note that exchanging the battery will return the unit in factory default
settings. Refer to your local dealer or the tech support if in doubt. myMix
15. Do not place any objects filled with liquids such as cups and glasses on the unit.
16. Excessive sound pressure level from earphones, headphones and speakers can
cause hearing damage and even hearing loss.
17. If anything drops into the media card slot, remove it after unplugging the power
supply or Ethernet cable (when using Power over Ethernet), or consult your
technical representative.
3
WARNINGS
Do not locate myMix
in a place subject to excessive heat or in direct sunlight. This could
be a fire hazard.
Do not place myMix
in a place subject to excessive humidity or dust. This could be a fire
and electrical shock hazard.
Connect the supplied AC power supply only to an AC outlet of the type stated in this
Owner’s Manual or as marked on the main unit. Failure to do so is a fire and electrical
shock hazard.
Do not place heavy objects on the power cord. A damaged power cord is a potential fire
and electrical shock hazard.
If the power cord is damaged (i.e., cut or a bare wire is exposed), ask your dealer for a
replacement. Using myMix
in this condition is a fire and shock hazard.
Hold the AC power supply when disconnecting from an AC outlet. Never pull the cord.
Damaging the power cord in this way is a potential fire and electrical shock hazard.
Do not place small metal objects on top of . Metal objects inside myMix myMix
are a fire
and electrical shock hazard.
Do not block the myMix ventilation holes. myMix
has ventilation holes at the front and
the rear to prevent the internal temperature from rising. Blocked ventilation holes can
damage the unit and are a fire hazard.
Do not try to modify myMix. This could be a fire and electrical shock hazard.
Do not use
myMix
in an environment outside of the
temperature range
between 5°C and
35°C (41°F and 95°F).
CAUTION
Turn off all audio devices and speakers when connecting to
myMix
.
Refer to the owner’s
manual for each device. Use the correct cables and connect as specified.
myMix
is a precision device. Handle it with care.
If you notice any abnormality—such as smoke, odor, or noise, turn off myMix
immediately. Remove the AC power cord from the AC outlet. Confirm that the
abnormality is no longer present. Consult your dealer for repair. Using myMix
in this
condition is a fire and shock hazard.
If a foreign object or water gets inside , turn it off immediately. Remove the AC myMix
power supply from the AC outlet. Consult your dealer for repair. Using myMix
in this
condition is a fire and electrical shock hazard.
If you plan not to use myMix
for a long period of time (such as when you are on
vacation), remove the AC power supply from the AC outlet. Leaving myMix
connected is
a fire hazard.


Specyfikacje produktu

Marka: MyMix
Kategoria: edytor
Model: RX-2

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z MyMix RX-2, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą