Instrukcja obsługi AuviTran AXC-AX4M
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla AuviTran AXC-AX4M (21 stron) w kategorii edytor. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/21
Version 1.2
2
AuviTran Audio ToolBox Instructions Manual
FCC INFORMATION (U.S.A)
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received including interference that may cause undesired operation.
NOTE: This product has been tested and found to comply with the limits for a Class B Digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to the operation of other radio communications.
Compliance with FCC regulations does not guarantee that interference will not occur in all installations.
If this product is found to be the source of interference, which can be determined by turning the unit “OFF” and “ON”, please
try to eliminate the problems by using one of the following measures:
Relocate either this product or the device that is being affected by the interference.
Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter(s).
In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead,
change the lead-in to co-axial type cable.
If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this
type of product
IMPORTANT: When connecting this product to accessories and/or another product, use only high quality shielded cables.
Cable/s supplied with this product MUST be used.
3
AuviTran Audio ToolBox Instructions Manual
PRECAUTIONS
Do not apply excessive pressure on connectors
or any other part of the board. Do not touch the
metallic sharp parts (pins) of the product.
This product is electrostatic sensitive; make
sure you check this before touching or using it.
The disconnect devices of the Audio ToolBox
unit are the appliance inlet of the auxiliary
power supply (option) and the appliance inlet
on the rear side of the unit. These must be
easily reachable.
To prevent electric shock, unplug the unit
before handling. The achievement of other
operations not mentioned in this document is
prohibited. Repairs can be performed only by a
technician trained and qualified.
Each connection must be Safety Extra Low
Voltage kind (SELV), and must stay inside
buildings.
Always use a power cable with a plug
according to the current standards in the
country of use
As Toolbox can have free slots , these slots
must always have a cover to close correctly the
unit (protection against fire)
FINLAND: "Laite on liitettävä suojamaadoitus-
koskettimilla varustettuun pistorasiaan"
NORWAY : "Apparatet må tilkoples jordet
stikkontakt"
SWEDEN : "Apparaten skall anslutas till jordat
uttag"
Rack Mounting
This product is designed to be rack-mounted. Be sure to
observe following installation rules of this kind of
equipmen t:
Do not block the vents. This device has ventilation
holes on the both side to prevent the internal
temperature from becoming too high. Inadequate
ventilation can result in overheating, possibly
causing damage to the device(s), or even fire.
Elevated Operating Ambient - If installed in a
closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment may
be greater than room ambient. Therefore,
consideration should be given to installing the
equipment in an environment compatible with the
maximum ambient temperature specified by the
manufacturer.
Reduced Air Flow - Installation of the equipment in
a rack should be such that the amount of air flow
required for safe operation of the equipment is not
compromised.
In some cases, to be sure to ensure sufficient airflow,
leave the rear and the front of the rack open, leave
sufficient space (>5cm) on each side of the rack, and
leave space above rack (>1cm).
Or it can be better to have appropriate fan kit in the multi-
unit rack
Mechanical Loading - Mounting of the equipment
in the rack should be such that a hazardous
condition is not achieved due to uneven mechanical
loading.
Circuit Overloading - Consideration should be
given to the connection of the equipment to the
supply circuit and the effect that overloading of the
circuits might have on over current protection and
supply wiring.
Appropriate consideration of equipment nameplate
ratings should be used when addressing this concern.
Reliable Earthing - Reliable earthing of rack-
mounted equipment should be maintained.
Particular attention should be given to supply
connections other than direct connections to the
branch circuit (e.g. use of power strips).
WARNING
DOUBLE POLE / NEUTRAL FUSING
Always follow the basic precautions listed below to avoid the possibility of serious injury or even death from electrical
shock, short-circuiting, damages, fire or other hazards.
These precautions include, but are not limited to, the following:
Specyfikacje produktu
| Marka: | AuviTran |
| Kategoria: | edytor |
| Model: | AXC-AX4M |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z AuviTran AXC-AX4M, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje edytor AuviTran
20 Lutego 2025
20 Lutego 2025
20 Lutego 2025
20 Lutego 2025
20 Lutego 2025
20 Lutego 2025
20 Lutego 2025
20 Lutego 2025
Instrukcje edytor
- edytor Yamaha
- edytor Lenovo
- edytor Hikvision
- edytor Fujitsu
- edytor Roland
- edytor Bose
- edytor Asus
- edytor Allen & Heath
- edytor Black & Decker
- edytor HP
- edytor Heritage Audio
- edytor Shure
- edytor Phoenix Gold
- edytor Alpine
- edytor Datapath
- edytor Digitus
- edytor LD Systems
- edytor DataVideo
- edytor Pyle
- edytor Zoom
- edytor Bogen
- edytor Alto
- edytor ART
- edytor TC Helicon
- edytor Vivolink
- edytor Eventide
- edytor DBX
- edytor Lindell Audio
- edytor Smart-AVI
- edytor Ashly
- edytor Atlas Sound
- edytor Gefen
- edytor SEADA
- edytor Radial Engineering
- edytor Arturia
- edytor Lectrosonics
- edytor Blackmagic Design
- edytor TOA
- edytor Neutrik
- edytor Tascam
- edytor SPL
- edytor BSS Audio
- edytor Chandler
- edytor KanexPro
- edytor Kopul
- edytor BZBGear
- edytor RGBlink
- edytor CEDAR
- edytor Rupert Neve Designs
- edytor AMX
- edytor Dangerous Music
- edytor Summit Audio
- edytor Matrox
- edytor Intel
- edytor Fredenstein
- edytor QSC
- edytor Golden Age Project
- edytor Noise Engineering
- edytor Sonifex
- edytor Solid State Logic
- edytor Black Lion Audio
- edytor Mathew Lane
- edytor Warm Audio
- edytor Drawmer
- edytor SIIG
- edytor Manley
- edytor MuxLab
- edytor Helix
- edytor Christie
- edytor Rane
- edytor AMD
- edytor Lexicon
- edytor Empirical Labs
- edytor AudioThing
- edytor Avenview
- edytor Audibax
- edytor FabFilter
- edytor Metric Halo
- edytor Henry Engineering
- edytor MyMix
- edytor Decimator
Najnowsze instrukcje dla edytor
19 Marca 2025
26 Lutego 2025
5 Lutego 2025
5 Lutego 2025
5 Lutego 2025
30 Stycznia 2025
30 Stycznia 2025
30 Stycznia 2025
30 Stycznia 2025
30 Stycznia 2025