Instrukcja obsługi Milwaukee 48-59-1200

Milwaukee Ładowarka baterii 48-59-1200

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Milwaukee 48-59-1200 (20 stron) w kategorii Ładowarka baterii. Ta instrukcja była pomocna dla 12 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/20

Cat. No. / No de cat.

48-59-1801

2710-20

OPERATOR'S MANUAL

MANUEL de L'UTILISATEUR

MANUAL del OPERADOR

WARNING To reduce the risk of injury, user must read and understand operator's manual.

AVERTISSEMENT An de réduire le risque de blessures, l'utilisateur doit lire et bien

comprendre le manuel.

ADVERTENCIA Para reducir el riesgo de lesiones, el usuario debe leer y entender el manual.

Cat. No. / No de cat.

48-11-1815

48-11-1820

Cat. No. / No de cat.

48-11-1828

48-11-1840

48-11-1850

48-11-1860

48-11-1890

New batteries must be charged before

rst use.

Les batteries neuves doivent être

chargées avant leur utilisation initiale.

Las baterías nuevas se deben cargar

antes de usarlas por primera vez.

CAT.

M18™ LI-ION BATTERY CHARGERS

M18™ LI-ION BATTERY PACKS

CHARGEURS AU LITHIUM-ION M18™

BLOC DE PILES AU LITHIUM-ION M18™

CARGADORS PARA BATERÍAS DE IONES DE LITIO DE M18™

PAQUETE DE BATERÍA DE IONES DE LITIO DE M18™

SAVE THESE INSTRUCTIONS - THIS OP-

ERATOR’S MANUAL CONTAINS IMPORTANT

SAFETY AND OPERATING INSTRUCTIONS

FOR MILWAUKEE LI-ION BATTERY PACKS

AND THE MILWAUKEE LI-ION CHARGER.

2. BEFORE USING THE BATTERY PACK AND

CHARGER, READ THIS OPERATOR’S MAN-

UAL, YOUR TOOL OPERATOR’S MANUAL,

AND ALL LABELS ON THE BATTERY PACK,

CHARGER AND TOOL.

CAUTION

TO REDUCE THE RISK OF IN-

JURY, CHARGE MILWAUKEE

LI-ION PACKS ONLY IN THEIR MILWAUKEE

LI-ION CHARGER. Other types of chargers may

cause personal injury or damage. Battery pack

and charger are not compatible with V™-technology

or NiCd systems. Do not wire a battery pack to a

power supply plug or car cigarette lighter. Battery

packs will be permanently disabled or damaged.

4. USE MILWAUKEE LI-ION PACKS ONLY ON

COMPATIBLE MILWAUKEE LI-ION TOOLS.

Battery pack and charger are not compatible with

V™-technology or NiCd systems. Use with other

tools may result in a risk of re, electric shock or

personal injury.

5. AVOID DANGEROUS ENVIRONMENTS. Do not

charge battery pack in rain, snow, damp or wet

locations. Do not use battery pack or charger in

the presence of explosive atmospheres (gaseous

fumes, dust or flammable materials) because

sparks may be generated when inserting or remov-

ing battery pack, possibly causing re.

6. CH

ARGE IN A WELL VENTILATED AREA. Do not

block charger vents. Keep them clear to allow proper

ventilation. Do not allow smoking or open ames near

a charging battery pack. Vented gases may explode.

7. MAINTAIN CHARGER CORD. When unplugging

charger, pull plug rather than cord to reduce the risk

of damage to the electrical plug and cord. Never car-

ry charger by its cord. Keep cord from heat, oil and

sharp edges. Make sure cord will not be stepped

on, tripped over or subjected to damage or stress.

Do not use charger with damaged cord or plug.

Have a damaged charger replaced immediately.

8. DO NOT USE AN EXTENSION CORD UNLESS IT

IS ABSOLUTELY NECESSARY. Using the wrong,

damaged or improperly wired extension cord could

result in the risk of re and electrical shock. If an

extension cord must be used, plug the charger

into a properly wired 16 gauge or larger extension

cord with pins that are the same number, size and

shape as the pins on the charger. Make sure that

the extension cord is in good electrical condition.

CHARGER 48-59-1801 IS RATED FOR 120 VOLT

AC ONLY. CHARGER 2710-20 IS RATED FOR

12 VOLT DC AND 120 VOLT AC. Charger must

be plugged into an appropriate receptacle.

10. USE ONLY RECOMMENDED ATTACHMENTS.

Use of an attachment not recommended or sold

by the battery charger or battery pack manufac-

turer may result in a risk of re, electric shock or

personal injury.

11. UNPLUG CHARGER when not in use. Remove

battery packs from unplugged chargers.

12. TO REDUCE THE RISK OF ELECTRIC SHOCK,

always unplug charger before cleaning or mainte-

nance. Do not allow water to ow into AC/DC plug.

Use a Ground Fault Circuit Interrupter (GFCI) to

reduce shock hazards.

13. DO NOT BURN OR INCINERATE BATTERY

PACKS. Battery packs may explode, causing per

sonal injury or damage. Toxic fumes and materials

are created when battery packs are burned.

14. DO NOT CRUSH, DROP, OR DAMAGE battery

pack. Do not use a battery pack or charger that

has received a sharp blow, been dropped, run

over, or damaged in any way (e.g., pierced with

a nail, hit with a hammer, stepped on).

15. DO NOT DISASSEMBLE. Incorrect reassembly

may result in the risk of electric shock, re or

exposure to battery chemicals. If it is damaged,

take it to a MILWAUKEE service facility.

16. BATTERY CHEMICALS CAUSE SERIOUS

BURNS. Never allow contact with skin, eyes, or

mouth. If a damaged battery pack leaks battery

chemicals, use rubber or neoprene gloves to dis-

pose of it. If skin is exposed to battery uids, wash

with soap and water and rinse with vinegar. If eyes

are exposed to battery chemicals, immediately

ush with water for 20 minutes and seek medical

attention. Remove and dispose of contaminated

clothing.

17. DO NOT SHORT CIRCUIT.

A battery pack will short

circuit if a metal object makes a connection between

the positive and negative contacts on the battery

pack. Do not place a battery pack near anything

that may cause a short circuit, such as coins, keys

or nails in your pocket. Do not allow uids to ow into

battery pack. Corrosive or conductive uids, such as

seawater, certain industrial chemicals, and bleach or

bleach containing products, etc., can cause a short

circuit. A short circuited battery pack may cause

re, personal injury, and product damage.

18. STORE YOUR BATTERY PACK AND CHARGER

in a cool, dry place. Do not store battery pack

where temperatures may exceed 120°F (50°C)

such as in direct sunlight, a vehicle or metal build-

ing during the summer.

19. ALWAYS USE A SIDE HANDLE when using a

9.0 Ah or higher capacity battery pack; the output

torque of some tools may increase. If your drill/

driver did not come with a side handle, visit www.

milwaukeetool.com for the appropriate accessory

handle.

READ AND SAVE

ALL INSTRUCTIONS

FOR FUTURE

REFERENCE.

IMPORTANT SAFETY INSTRUCTIONS

WARNING

READ AND UNDERSTAND ALL INSTRUCTIONS. Failure to follow all

instructions listed below, may result in electric shock, re and/or serious personal injury.

SAVE THESE INSTRUCTIONS

SYMBOLOGY

Volts

Direct Current

Alternating Current

Double Insulated

Properly Recycle Batteries

Hertz

Amps

C US

UL Listing for Canada and U.S.

FUNCTIONAL

DESCRIPTION

CAT.

1. Contacts

2. Release buttons

3. Fuel Gauge button

4. Fuel Gauge

5. Electrical contacts

6. Bay

7. Serial Number (on bottom of charger)

8. Vents

9. Light indicators - when a battery pack is inserted

into the charger, the light will indicate the following:

Continuous red: Charging

Continuous green light: Charging is complete

Flashing red: Battery is too hot/cold - Charging will

begin when battery reaches correct

charging temperature

Flashing red/green: Damaged or faulty battery pack

SPECIFICATIONS

Cat. No. 48-59-1801 ...............................................

Input Volts 120 AC ....................................................

Input Amps 2.1 AC....................................................

Output Volts 18 DC ..................................................

Output Amps ................................................ 3.1 DC

Cat. No. 2710-20 ....................................................

Input Volts 120 AC ....................................................

Input Amps 2.1 AC....................................................

Input Volts 12 DC .....................................................

Input Amps 6.5 DC...................................................

Output Volts 18 DC ..................................................

Output Amps ................................................ 3.1 DC

Battery Cat. No.................................... 48-11-1815