Instrukcja obsługi Milwaukee 48-59-0255

Milwaukee Ładowarka baterii 48-59-0255

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Milwaukee 48-59-0255 (11 stron) w kategorii Ładowarka baterii. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/11
SPECIAL NOTE: New battery packs are not fully charged.
Charge your battery pack before using it for the first time and
follow the charging instructions in your charger manual.
NOTE SPÉCIALE: Les batteries neuves ne sont pas
entièrement chargées. Chargez la batterie avant de vous en
servir la première fois en suivant les instructions de recharge
dans le manuel qui accompagne cet outil.
NOTA ESPECIAL: Las batterias, cuando son nuevas, no están
totalmente cargadas. Cargue su bateria antes de usarla por
primera vez siga las instrucciones de carga que vienen en el
manuel de la herramienta.
OPERATOR'S MANUAL
MANUEL de L'UTILISATEUR
MANUAL del OPERADOR
TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND
OPERATOR'S MANUAL.
AFIN DE RÉDUIRE LE RISQUE DE BLESSURES, L'UTILISATEUR DOIT LIRE ET
BIEN COMPRENDRE LE MANUEL DE L'UTILISATEUR.
PARA REDUCIR EL RIESGO DE LESIONES, EL USUARIO DEBE LEER Y
ENTENDER EL MANUAL DEL OPERADOR.
FPO
Catalog No.
No de Cat.
Catálogo No.
48-59-0255
12 V - 18 V NiCd CHARGER
CHARGEUR NiCd 12 V - 18 V
CARGADOR NiCd DE 12V - 18V
2 3
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This manual contains important safety and operating instructions for battery chargers.
Before using the battery charger, read this manual as well as any labels on the charger,
battery pack and tool.
1. CAUTION! To reduce the risk of injury, charge only MILWAUKEE 12, 14.4 and 18 Volt
battery packs in this charger. Other types of batteries may explode, causing personal
injury or damage.
2. AVOID DANGEROUS ENVIRONMENTS. Do not use charger in rain, snow, damp or
wet locations. Do not use battery pack or charger in the presence of explosive
atmospheres (gaseous fumes, dust or flammable materials) because sparks may be
generated when inserting or removing battery pack, possibly causing fire.
3. CHARGE IN A WELL VENTILATED AREA. Do not block charger vents. Keep them
clear to allow proper ventilation. Do not allow smoking or open flames near a charging
battery pack. Vented gases may explode.
4. MAINTAIN CHARGER CORD. When unplugging charger, pull plug rather than cord to
reduce the risk of damage to the electrical plug and cord. Never carry charger by its
cord. Keep cord from heat, oil and sharp edges. Make sure cord will not be stepped
on, tripped over or subjected to damage or stress. Do not use charger with damaged
cord or plug. Have a damaged cord replaced immediately with identical replacement
parts (see Maintenance).
5. DO NOT USE CHARGER OR BATTERY PACK IF it has received a sharp blow, been
dropped or damaged in any way. Do not disassemble. Incorrect reassembly may
result in the risk of electric shock, fire or exposure to battery fluids. If it is damaged,
take it to a MILWAUKEE service facility.
6. CHARGER IS RATED FOR 120 VOLT AC ONLY. Charger must be plugged into an
appropriate receptacle.
7. USE ONLY RECOMMENDED ATTACHMENTS. Use of an attachment not recommended
or sold by the battery charger manufacturer may result in a risk of fire, electric shock
or personal injury.
8. DO NOT USE AN EXTENSION CORD UNLESS IT IS ABSOLUTELY NECESSARY.
Using the wrong, damaged or improperly wired extension cord could result in the risk
of fire and electrical shock. If an extension cord must be used, plug the charger into
a properly wired 16 gauge or larger extension cord with pins that are the same
number, size and shape as the pins on the charger. Make sure that the extension cord
is in good electrical condition.
9. DO NOT BURN, MUTILATE OR DISASSEMBLE BATTERY PACK. The battery pack
can explode in a fire. Mutilation may expose battery fluids, causing burns.
10. BATTERY FLUIDS CAUSE SERIOUS CHEMICAL BURNS. Never allow contact with
skin or eyes. If a damaged battery pack leaks battery fluids, use rubber or neoprene
gloves to dispose of it. If skin is exposed to battery fluids, wash with soap and water
and rinse with vinegar. Remove and dispose of contaminated clothing. If eyes are
affected, immediately flush with water for 15 minutes and seek medical attention.
11. DO NOT SHORT CIRCUIT. A battery pack will short circuit if a metal object makes a
connection between the positive and negative contacts on the battery pack. Do not
place a battery pack near anything that may cause a short circuit, such as coins or
keys in your pocket. A short circuited battery pack may cause fire and personal injury.
12. UNPLUG CHARGER when not in use.
13. TO REDUCE THE RISK OF ELECTRIC SHOCK, always unplug charger before clean-
ing or maintenance, turning off controls will not reduce this risk. Use a Ground Fault
Circuit Interrupter (GFCI) to reduce shock hazards.
14. STORE YOUR BATTERY PACK AND CHARGER in a cool, dry place. Do not store
battery pack where temperatures may exceed 120°F (50°C) such as in a vehicle or
metal building during the summer. Charger will charge the battery when the tempera-
ture is between 41°F (5°C) and 113°F (45°C). When the battery temperature is outside
that range, charging will not occur.
FUNCTIONAL DESCRIPTION
READ AND SAVE ALL INSTRUCTIONS FOR
FUTURE REFERENCE.
1. Red control light
Light off indicates: Charger is ready for operation.
Battery pack is charged
Maintenance charging
Continuous light indicates: Charging (Fast, if battery temperature is between
41°F (5°C) and 113°F (45°C)
Flashing light indicates: Battery pack is too hot or too cold
(Charging will begin automatically when battery
reaches correct charging temperature)
2. Instruction label
3. Electrical contacts
4. Battery pack port
5. Vents
6. Nameplate (on back of charger)
7. Key hole slots: Mounts charger vertically
(on bottom of charger)
8. Cord wrap: Stores excess cord
(on bottom of charger)
1
234
5
6
7
8
4 5
When to charge the battery pack
Charge your battery pack before you use
your tool for the first time and when your
tool no longer performs with the power
and torque needed for the job. Never com-
pletely discharge the battery pack.
New battery packs reach full loading ca-
pacity after 4-5 chargings and
dischargings. Battery packs which have
not been used for some time should be
recharged before use.
Standard charging times
Standard charging time is approximately
one hour. Charging time varies depending
on the battery temperature, charge needed
and the type of battery pack being
charged. For example, if the battery pack
does not require a full charge, the charg-
ing time will be less than one hour.
Effects of temperature on charging
Battery packs are affected by temperature.
The charger will sense battery temperature
and will charge the battery at the most rapid
rate when its temperature ideal (between
41°F (5°C) and 113°F (45°C). When the
battery temperature is outside of this range,
the charger will supply enough current to
keep the battery pack in its current state to
prevent damage to battery.
OPERATION
Charge only MILWAUKEE 12, 14.4 and 18 Volt battery packs in
this charger. Other types of batteries may explode causing
personal injury and damage.
WARNING!
Connect Charger to AC
Power Source
Light Off
Insert Battery
Flashing Light
Charge pending until
battery temperature is
below 113°F (45°C).
Battery temperature
41°F - 113°F (5°C - 45°C)
Charging
Continuous Light
Battery too cold
less than 41°F (5°C)
Flashing Light
Battery too hot
over 113°F (45°C)
Charge pending until
battery temperature is
above 41°F (5°C).
Charger Ready
Light Off
Battery is charged/
Maintenance charging
Automatic start
When a hot or cold battery pack is inserted
into the charger, charging will begin auto-
matically if the battery reaches the correct
charging temperature.
Maintenance charge
Batteries discharge at a rate of about 1%
per day. The Maintenance Charge feature
keeps the battery pack fully charged when
the battery pack is stored in a charger that
is plugged in. The Maintenance Charge
automatically begins after the battery pack
is fully charged. During Maintenance
Charge,the control light will be off.
Charging the Battery Pack

Specyfikacje produktu

Marka: Milwaukee
Kategoria: Ładowarka baterii
Model: 48-59-0255

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Milwaukee 48-59-0255, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Ładowarka baterii Milwaukee

Milwaukee

Milwaukee 48-59-1202 Instrukcja

15 Września 2024
Milwaukee

Milwaukee 48-59-1812 Instrukcja

6 Września 2024
Milwaukee

Milwaukee 2510-20 Instrukcja

2 Września 2024
Milwaukee

Milwaukee 48-59-1204 Instrukcja

31 Sierpnia 2024
Milwaukee

Milwaukee 48-59-2002 Instrukcja

29 Sierpnia 2024
Milwaukee

Milwaukee 48-59-2001 Instrukcja

27 Sierpnia 2024
Milwaukee

Milwaukee 48-59-1806 Instrukcja

26 Sierpnia 2024
Milwaukee

Milwaukee 48-59-0255 Instrukcja

26 Sierpnia 2024
Milwaukee

Milwaukee 48-59-1811 Instrukcja

21 Sierpnia 2024
Milwaukee

Milwaukee 48-59-1808 Instrukcja

20 Sierpnia 2024

Instrukcje Ładowarka baterii

Najnowsze instrukcje dla Ładowarka baterii

Graupner

Graupner Ultramat 12 Instrukcja

13 Stycznia 2025
Graupner

Graupner ULTRA DUO PLUS 30 Instrukcja

13 Stycznia 2025
Fuxtec

Fuxtec FX-E1LG1A Instrukcja

13 Stycznia 2025
Voltcraft

Voltcraft Charge Manager 410 Instrukcja

11 Stycznia 2025
Nitecore

Nitecore UHX1 PRO Instrukcja

11 Stycznia 2025
Envivo

Envivo ENV-1597 Instrukcja

11 Stycznia 2025
Xblitz

Xblitz XC1 Instrukcja

10 Stycznia 2025
Jackery

Jackery Explorer 240 v2 Instrukcja

7 Stycznia 2025
Jackery

Jackery Explorer 1000 v2 Instrukcja

7 Stycznia 2025
Schwaiger

Schwaiger LSET500 513 Instrukcja

7 Stycznia 2025