Instrukcja obsługi Megger AVO410

Megger multimetr AVO410

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Megger AVO410 (18 stron) w kategorii multimetr. Ta instrukcja była pomocna dla 2 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/18
mM
AVO410
Digital multimeter
Digitale Multimeter
Multimèter numérique
Multímetro digitales
Digitale multimeter
User manual
Bedienungsanleitung
Manuel utilisateur
Guía del usuario
Gebruikershandleiding
2
G SAFETY WARNINGS
Safety warnings must be read and understood before instrument is used.
The following safety information must be observed to insure maximum
personal safety during the operation of this meter:
Do not use in wet environments.
Measurements beyond the maximum selected range must not be attempted.
Extreme care must be taken when measuring above 50 V, especially on live
bus-bars.
To measure voltage, the instrument must not be switched to a current or
resistance range, or to the diode check or buzzer position.
Circuits must be de-energised and isolated before carrying out resistance
tests.
The rotary selector switch must only be turned after removing test
connections.
All external voltages must be disconnected from the instrument before
removing the battery.
Test leads and prods must be in good order, clean, and with no broken or
cracked insulation.
UK Safety Authorities recommend the use of fused test leads when measuring
voltage on high energy systems.
Replacement fuses must be of the correct type and rating.
The instrument must not be used if any part of it is damaged.
Check for correct instrument operation by testing a known voltage before
and after use. Do not use if misleading results are obtained.
Warnings and precautions must be read and understood before an instrument
is used. They must be observed during the operation of this instrument.
CAT IV - Measurement category IV: Equipment connected between the origin
of the low-voltage mains supply and the distribution panel.
CAT III - Measurement category III: Equipment connected between the
distribution panel and the electrical outlets.
CAT II - Measurement category II: Equipment connected between the
electrical outlet and the user’s equipment.
Note
This instrument must only be used by suitably trained and competent persons
3
Safety warnings 2 ............................................................................................
Symbols used on instrument 3 ........................................................................
Introduction 4 .................................................................................................
Operation 5 .....................................................................................................
Specifications 10 .............................................................................................
Manual de l’utilisateur 16 ...............................................................................
Bedienungsanleitung 30 .................................................................................
Manual del usuario 44 ....................................................................................
Gebruikershandleiging 56 ...............................................................................
Symbols used on the instrument are:
F Caution: risk of electric shock
G Caution: refer to accompanying notes
t Equipment protected throughout by Double Insulation (Class II)
c Equipment complies with current EU directives.
END OF LIFE DISPOSAL
The crossed out wheeled bin placed on the Megger products is a
reminder not to dispose of the product at the end of its product life
with general waste.
Megger is registered in the UK as a Producer of Electrical and Electronic
Equipment. The Registration number is WEE/HE0146QT.
BATTERIES
Should the display fail to illuminate then change the battery. For the purpose of
end of life disposal and battery replacement, removing the two screws on the
base of the unit accesses the battery.
The crossed out wheeled bin placed on the battery is a reminder not to dispose
of it with general waste at the end of its life.
This product contains 1 x PP3 / 6F22 alkaline battery.
Do not use rechargeable batteries.
The battery fitted in this instrument is classified as a Portable Battery and
should be disposed of in the UK in accordance with Local Authority
requirements.
For disposal of batteries in other parts of the EU contact your local distributor.
Megger is registered in the UK as a Producer of Batteries. The registration
number is BPRN00142.
Contents


Specyfikacje produktu

Marka: Megger
Kategoria: multimetr
Model: AVO410

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Megger AVO410, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje multimetr Megger

Megger

Megger AVO830 Instrukcja

21 Września 2024
Megger

Megger AVO835 Instrukcja

21 Września 2024
Megger

Megger AVO210 Instrukcja

20 Września 2024
Megger

Megger AVO410 Instrukcja

17 Września 2024

Instrukcje multimetr

Najnowsze instrukcje dla multimetr

Voltcraft

Voltcraft PMM 3005-20 Instrukcja

9 Października 2024
Bearware

Bearware 306998 Instrukcja

9 Października 2024
Bearware

Bearware 307001 Instrukcja

9 Października 2024
Fluke

Fluke 283 FC Instrukcja

9 Października 2024
Noyafa

Noyafa NF-5330C Instrukcja

9 Października 2024
Noyafa

Noyafa NF-5310B Instrukcja

9 Października 2024
Emos

Emos M3216 Instrukcja

8 Października 2024
Uni-T

Uni-T UT121B Instrukcja

7 Października 2024
Maxwell

Maxwell MX-25103 Instrukcja

6 Października 2024
Velleman

Velleman DVM840 Instrukcja

5 Października 2024