Instrukcja obsługi Maytag W10915235


Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Maytag W10915235 (9 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 7 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/9
HIGH ALTITUDE KIT INSTALLATION INSTRUCTIONS
To convert range for elevations above 6,560 ft (1999.5 m)
INSTRUCTIONS D’INSTALLATION POUR TROUSSE
D’UTILISATION EN HAUTE ALTITUDE
Pour la conversion dune cuisinière à une altitude
supérieure à 6 560 pi (1999,5 m).
Natural Gas (NG) High Altitude Kit Contains:
1 - Orifice spud, oven bake
1 - Instruction sheet
Propane Gas (LP) High Altitude Kit Contains:
1 - Orifice spud, oven bake
1 - Instruction sheet
Lensemble pour utilisation de gaz naturel en haute
altitude comprend :
1 - Gicleur, cuisson au four
1 - Fiche d’instruction
Lensemble pour utilisation de gaz propane en haute
altitude comprend :
1 - Gicleur, cuisson au four
1 - Fiche d’instruction
GAS CONVERSION SAFETY
W10915212A
3
GAS CONVERSIONS
IMPORTANT: Gas conversions must be done by a qualified
installer. Before proceeding with the conversion, shut off the gas
supply to the range prior to disconnecting the electrical power.
LP Gas Conversion
1. Turn the manual shut-off valve to the closed position.
2. Unplug range or disconnect power.
To Convert Gas Pressure Regulator (LP Gas)
See the “Gas Conversion Instructions” section in the Installation
Instructions provided with the range for proper regulator
conversion.
To Convert Surface Burners (LP Gas)
Surface burners do not need conversion for high altitude. Only
adjust surface burner valve. See the “Adjust Flame Height”
section.
WARNING
This conversion kit shall be installed by a
qualified service agency in accordance
with the manufacturer's instructions and
all applicable codes and requirements of
the authority having jurisdiction. If the
information in these instructions is not
followed exactly, a fire, explosion or
production of carbon monoxide may
result causing property damage, personal
injury or loss of life. The qualified service
agency is responsible for the proper
installation of this kit. The installation is
not proper and complete until the
operation of the converted appliance is
checked as specified in the
manufacturer's instructions supplied with
this kit.
WARNING
Explosion Hazard
Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure
gas pressure does not exceed 14" (36 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death
or serious burns to children and adults.
A
B
C
A. Gas supply line
B. Manual shut-off valve closed position
C. To range
4
To Convert Oven Bake Burner (LP Gas)
Only the bake orifice needs to be converted for high altitude.
1. Remove the oven racks and the oven door. See the “Oven
Door” section in the Installation Instructions.
2. Remove 2 screws and washers at the rear of the oven
bottom.
3. Lift the rear of the oven bottom up and back until the front
of the panel is away from the front frame. Remove from
oven and set it aside on a covered surface.
4. Remove 2 screws from the bake burner.
5. Slide the front of the bake burner to the side to remove
tab from front of oven. Lift the back of the bake burner
off the oven orifice, and set the bake burner aside. Do
not disconnect the wire.
6. Apply masking tape to the end of a 3/8" (1 cm) nut driver
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice spud
and remove by turning the Natural gas bake burner orifice
spud counterclockwise to remove.
7. Replace the current spud with a “107” spud. Install the LP
gas bake burner orifice spud, turning it clockwise until snug.
IMPORTANT: Do not overtighten.
8. Position the back of the bake burner over the oven orifice,
and then align the holes for the screws.
9. Reattach the bake burner with 2 screws.
10. Position the front of the oven bottom panel toward the front
frame, and then lower the rear of the oven bottom panel into
the oven.
11. Reattach the oven bottom panel with 2 screws and
2 washers.
A
B
A. Screws
B. Oven bottom
A
B
A. Bake burner
B. Screws
A
A. Oven orifice
A
A. Orifice spud


Specyfikacje produktu

Marka: Maytag
Kategoria: Niesklasyfikowane
Model: W10915235

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Maytag W10915235, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje Niesklasyfikowane Maytag

Maytag

Maytag WHP0400VW Instrukcja

15 Października 2024
Maytag

Maytag MMMS4230PZ Instrukcja

26 Września 2024
Maytag

Maytag MOES6030LZ Instrukcja

25 Września 2024
Maytag

Maytag MGDP586KW Instrukcja

25 Września 2024
Maytag

Maytag MTUC7500AF Instrukcja

25 Września 2024
Maytag

Maytag W10748976 Instrukcja

25 Września 2024
Maytag

Maytag W10915235 Instrukcja

25 Września 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Stihl

Stihl HT 70 Instrukcja

15 Października 2024
Ernesto

Ernesto H14270 Instrukcja

15 Października 2024
Uniden

Uniden BT MIC KIT Instrukcja

15 Października 2024
Vaude

Vaude Omnis Bike 26 Instrukcja

15 Października 2024
ART

ART ProChannel II Instrukcja

15 Października 2024
Aukey

Aukey DR02J Instrukcja

15 Października 2024
Master Lock

Master Lock 653EURD Instrukcja

15 Października 2024
Roland

Roland FR-18 Diatonic Instrukcja

15 Października 2024