Instrukcja obsługi Maytag MJD2005AAW

Maytag ZMYWARKI MJD2005AAW

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Maytag MJD2005AAW (17 stron) w kategorii ZMYWARKI. Ta instrukcja była pomocna dla 8 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/17
User instructions
MJD 2005
DISHWASHER
3
SAFETY INSTRUCTIONS
There are certain basic safety rules
which are valid for any domestic
appliance.
Installation
■Make sure that the plug fitted to the
machine is compatible with the power
supply socket. If it is not, get a suitably
qualified person to fit the correct type,
and to make sure that the cables to the
mains socket are able to cope with the
power rating of the appliance.
■Ensure that the dishwasher does not
crush power cables.
■In general it is not advisable to use
adaptors, multiple plugs and/or extension
cables.
■Should it be necessary to replace the
supply cord, call the After Sales Service
Centre.
Safety
■Never touch the appliance when your
hands or feet are wet or damp.
■Do not use when your feet are bare.
■Do not remove the plug from the mains
supply socket by pulling the mains cable
or the machine itself.
■Do not leave the appliance exposed to
the elements (rain, sun etc).
■This appliance is not intended for use by
young children or infirm persons unless
they have been adequately supervised
by a responsible person to ensure that
they can use the appliance safely.
Young children should be supervised to
ensure that they do not play with the
appliance.
■Water left in the machine or on the
dishes at the end of the wash programme
should not be swallowed.
■The door should not be left in the open
position since this could present a potential
hazard ( es. tripping ).
■Leaning or sitting on the open door of
the dishwasher could cause it to tip over.
WARNING !
Knives and other utensils with sharp
points must be loaded in the basket
with their points down or placed in a
horizontal position.
Daily use
■This appliance should only be used for
domestic purposes.
■The dishwasher is designed for normal
kitchen utensils.
Objects that have been contamined by
petrol, paint, traces of steel or iron,
corrosive chemicals, acids or alkalis
must not be washed in the dishwasher.
■If there is a water softening device installed
in the home there is no need to add
salt to the water softener fitted in the
dishwasher.
■Cutlery is washed best if it is placed in
the basket with the handles downwards.
■If the appliance breaks down or stops
working properly, switch it off, turn off the
water supply and do not tamper with it.
Repair work should only be carried out
by an approved service agent and only
genuine spare parts should be fitted. Any
failure to follow the above advice may
have serious consequences for the safety
of the appliance.
Disposal
■The dishwasher has been made from
materials which can be recycled so that it
can be disposed of in an environmentally
friendly way.
■If you wish to dispose of an old dishwasher
be careful to remove the door to
eliminate the risk of children becoming
trapped inside it.
2
CONTENTS
Safety advice
Setting up, installation
Water softener unit
Adjusting the upper basket
Loading the dishes
Information for test laboratories
Half load washing
Loading the detergent and rinse aid
Cleaning the filters
Some practical hints
Routine cleaning and maintenance
Description of the control panel
Technical data
Programme selection and special functions
Programme guide
The Watercontrol system
Identifying minor faults
pag. 3
pag. 4
pag. 8
pag. 10
pag. 11
pag. 13
pag. 14
pag. 15
pag. 17
pag. 18
pag. 19
pag. 20
pag. 20
pag. 21
pag. 24
pag. 26
pag. 27
Please read the instructions in this booklet carefully because they contain important
information on how to install, use and maintain your dishwasher safely as well as
containing useful tips on how to make the most of it.
Keep this booklet safe for future reference.
Fig. A
32
1
4
5
Water connection
IMPORTANT
The appliance must be connected to
the water mains using new hose-sets.
The old hose-sets should not be reused.
■The inlet and drain hoses can be directed
to left or right.
IMPORTANT
The dishwasher can be connected to
either cold or hot water, as long as it
is no hotter than 60 °C.
■Water pressure must be between
0,08 MPa and 0,8 MPa. If the pressure is
below the minimum consult our service
department for advice.
■The inlet hose must be connected to a
tap so that the water supply can be cut
off when the machine is not in use
(fig. 1 B).
■The dishwasher is fitted with 3/4" threaded
connector (fig. 2).
■Connect inlet hose “A” “B”to water tap
with a 3/4" attachment making sure that
it has been properly tightened.
■If it is necessary, the inlet pipe can be
lengthened up to 2,5 m. The extension
pipe is available from the Service
Department.
■If the dishwasher is connected to new
pipes or to pipes which have not been in
use for a long time run water through for
a few minutes before connecting the
inlet hose. In this way no deposits of
sand or rust will clog up the water inflow
filter.
1
2
5
4
INSTALLATION
(Technical notes)
■After unpacking, adjust the height of the
dishwasher. For the dishwasher to work
correctly it must be level. Adjust the feet
so that the machine does not tilt by more
than 2 degrees.
■If it you need to move the machine after
removing the packaging, do not try to lift
it by the bottom of the door. Follow the
instructions in the figure below. Open the
door slightly and lift the machine by
holding on the top.
IMPORTANT
When the appliance is located on a
carpet floor, attention must be paid to
ensure that there is no obstruction to
the bottom vents.
Make sure that the plug on the
appliance remains accessible after
installation.
Use only new water hoses with any
new appliance. Discard old water
hoses.
Electrical connection
This appliance complies with international
safety standards, and is fitted with a 3 pin
plug with earth connection to ensure
complete earthing of the product.
Before connecting the appliance to the
mains supply it is important to ensure:
1. that the supply socket is properly
earthed;
2. that your electricity supply is capable of
meeting the consumption requirements
listed on the rating plate of your
appliance.
IMPORTANT
This appliance is suitable for connection
to a 230 V AC 50 Hz.
Supply:
this appliance should be used only
on a socket with a rating of 10 Amps.
WARNING!
This appliance must be earthed.
In the absence of adequate earthing
you will notice that when touching
the metal parts of your appliance an
electrical dispersion can be felt, due
to the presence of a radio interference
suppressor.
Manufacturer declines all responsibility
for any damage due to non-earthing of
the machine.

Specyfikacje produktu

Marka: Maytag
Kategoria: ZMYWARKI
Model: MJD2005AAW

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Maytag MJD2005AAW, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje ZMYWARKI Maytag

Maytag

Maytag MDB5969SDH Instrukcja

14 Października 2024
Maytag

Maytag 7602 Instrukcja

5 Lipca 2024
Maytag

Maytag MDB7979SHZ Instrukcja

5 Lipca 2024
Maytag

Maytag MJD2005AAW Instrukcja

4 Lipca 2024
Maytag

Maytag 6402 Instrukcja

3 Lipca 2024

Instrukcje ZMYWARKI

Najnowsze instrukcje dla ZMYWARKI

Sharp

Sharp QW-AT13S47E-DE Instrukcja

15 Października 2024
Zanker

Zanker GW 3752 B Instrukcja

15 Października 2024
Teco

Teco TDW14SA Instrukcja

15 Października 2024
Amana

Amana ADB3500AWS41 Instrukcja

15 Października 2024
Defy

Defy DDW 173 Instrukcja

15 Października 2024
Junker

Junker JS15VX91 Instrukcja

15 Października 2024
Blomberg

Blomberg DWT 25100 B Instrukcja

15 Października 2024
Equator

Equator WP818 Instrukcja

15 Października 2024
Amana

Amana ADB2500AWS40 Instrukcja

15 Października 2024
Teka

Teka DFI 76950 Instrukcja

15 Października 2024