Instrukcja obsługi Lanaform Heating Blanket S2

Lanaform Niesklasyfikowane Heating Blanket S2

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Lanaform Heating Blanket S2 (52 stron) w kategorii Niesklasyfikowane. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/52

Blanket

Heating Blanket S2

Constante warmteChaleur constanteConstant heat

EN INTRODUCTION

Thank you for choosing the LANAFORM® “S2 Heating Blanket” heating pad.

LANAFORM’s “S2 Heating Blanket” heating pad has undergone the rigorous testing required under current European

standards.Furthermore, the double heating pad has individual phased temperature control that lets you warm yourself in

winter and in damp weather.

PLEASE READ ALL THE INSTRUCTIONS BEFORE USING YOUR “S2 HEATING BLANKET”, ESPECIALLY THIS BASIC

SAFETY INFORMATION:

To prevent the risk of burns, electrocution, fire or injury:

• Only use this device according to the instructions given in this manual.

• This device is not intended for use by people (including children) with reduced physical, sensory or mental capabilities,

or persons with lack of experience or knowledge, unless a person responsible for their safety can supervise or instruct

them beforehand on how to use the device.Children should be supervised to make sure they do not play with the device.

• Do not use accessories that are not recommended by LANAFORM® or that are not supplied with this device.

• If the power cable is damaged, it must be replaced by a special or similar cable available from the supplier or its after

sales department.

• Do not use this device if the power plug is damaged, if the device is not working properly, has been dropped on the floor

or if it is damaged or has been dropped into water.Have the device examined and repaired by the supplier or its after-

sales department.

• Do not carry this device by its power cable or use the cable as a handle.

• Always unplug the device after use or before cleaning.

• Unplug a device that has fallen into water immediately before retrieving it.

• An electrical device must never remain plugged in without supervision.Unplug it when you are not using it.

• Use your heating pad only with the electrical plug provided.

• Do not fold the power cable and do not use the heating pad when it is creased, rolled up or folded.

• Never use this device in a room where aerosols (sprays) are used or in a room or where oxygen is being administered.

• To disconnect the device, turn the button to the «OFF» position, then remove the plug from the mains.

• Do not use safety pins, do not scratch the heating pad with a sharp object and do not beat it with a blunt object.Do not

attach the device with pins or other metal objects.Never let anything drop or insert any object into any openings.

• Do not expose your heating pad to the sun and do not iron it.This will prevent damage to the insulation of the electrical

circuit.

• This device is not intended to be used in a hospital environment, but for use in the home only.

• Do not use the heating pad with other heating devices or to heat other devices (hot-water bottle, electric blanket, etc.).

• If you are concerned about your health, consult a doctor before using this appliance.

• If you experience any pain when using this device, stop using it immediately and consult your doctor.

• Never use this device on a body part that is swollen or inflamed or if you have a skin rash.

• The control must remain within reach, do not leave the switch hidden under a pillow or any other object.

• Do not wash the heating pad too often to avoid excessive wear and tear.The heating pad should not be washed in the

washing machine more than 5 times during its life.

• Do not use the device when it is damp and do not turn it on to dry it.

• When storing your heating pad for a long period, store it in a dry place. Carefully check its condition before operating it

again for the first time.If the power cable appears damaged, do not operate the device and take it back to the supplier

or its after-sales department.

• This device should not be used by young children, people who are insensitive to heat or on animals.

• The device should not be used on a folding bed or on a bed, a section of which can be adjusted.

• Examine the device frequently to check for any signs of damage to the product or signs of wear.If you notice signs of

wear or damage, stop using this product immediately and take it back to the supplier or the its after-sales department.

USING THE HEATING PAD

Diagram and description:

1) OFF button

2) Position “1” (1st setting)

3) Position “2” (2nd setting)

4) Position “3” (3rd setting)

5) Display screen

Operating the heating pad:

• Put the pad down flat on the bed.The light side of the heating pad should be against the mattress.The end of the pad

without the controller should be placed at the foot of the bed.

• Only put a sheet or fine cotton mattress over the pad so that you can feel the heat.

• Connect each plug to one of the two sockets on each side of the pad and the other end

to an electricity supply (AC220-240V).Make sure that there is a power socket nearby and

that the power cable is not in a position where the user may trip over it.

• To pre-heat the pad, select the third setting for 15 minutes.The temperature will

gradually rise.

• After pre-heating, get on to your heating pad and turn the control button to the heat

setting you require.If you use the pad for a long time or if you’re going to sleep, select the

first setting.It will take about 15 minutes for the pad to reach the required temperature.

• To turn the device off, turn the button to the “Off” position.

Note:The heating pad is set to run continuously for three hours.If you wish to extend that time, it is

advisable to let the heating pad cool down first for 5 minutes before using it again.

CLEANING AND MAINTENANCE

When you are not using the heating pad and before cleaning it, follow the instructions below:

- Make sure the control button is in the “Off» position.

- Disconnect the power supply.

- Disconnect the plug linking the control to the device.

- Leave the pad to cool before cleaning.

Heating Blanket S2 3

Specyfikacje produktu

Marka:	Lanaform
Kategoria:	Niesklasyfikowane
Model:	Heating Blanket S2

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Lanaform Heating Blanket S2, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje Niesklasyfikowane Lanaform

Lanaform Breva Instrukcja

5 Października 2024

Lanaform Air Purifier Instrukcja

5 Października 2024

Lanaform Rapid Patch Instrukcja

5 Października 2024

Lanaform Vegetal Beauty Instrukcja

5 Października 2024

Lanaform Heating Blanket S2 Instrukcja

5 Października 2024

Lanaform New Baby Scale Instrukcja

5 Października 2024

Lanaform Samoa Instrukcja

5 Października 2024

Lanaform Aroma Diffuser Instrukcja

5 Października 2024

Lanaform Deluxe Mass Instrukcja

5 Października 2024

Lanaform Fidji Instrukcja

5 Października 2024

Instrukcje Niesklasyfikowane

Najnowsze instrukcje dla Niesklasyfikowane

Black Diamond BD1121530000ALL1 Instrukcja

15 Października 2024

Husqvarna K 970 SmartGuard Instrukcja

15 Października 2024

Stihl HT 70 Instrukcja

15 Października 2024

Ernesto H14270 Instrukcja

15 Października 2024

Uniden BT MIC KIT Instrukcja

15 Października 2024

Vaude Omnis Bike 26 Instrukcja

15 Października 2024

ART ProChannel II Instrukcja

15 Października 2024

Aukey DR02J Instrukcja

15 Października 2024

Master Lock 653EURD Instrukcja

15 Października 2024

Roland FR-18 Diatonic Instrukcja

15 Października 2024