Instrukcja obsługi Kindermann UHBX-R-PSE

Kindermann przedłużacz AV UHBX-R-PSE

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Kindermann UHBX-R-PSE (12 stron) w kategorii przedłużacz AV. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/12

User’s Manual

HDMI Video Extender with

Bidirectional IR, and RS232

Send HDMI, IR, , and PoH full-duplex RS232 Power

500 ft (150 m) on a single Cat6 cable

Model numbers covered in this User’s Manual:

UMA1215 Rev n/c

Individual Ends

UHBX-S- PSE HDMI+RS232+IR+PoH UTP Sender with Power Supply (PSE)

UHBX PD-S- HDMI+RS232+IR+PoH UTP Sender Remotely Powered (PD)

UHBX-R- PSE HDMI+RS232+IR+PoH UTP Receiver with Power Supply (PSE)

UHBX PD-R- HDMI+RS232+IR+PoH UTP Receiver Remotely Powered (PD)

Kits

UHBX P1- HDMI+RS232+IR+PoH UTP Extender, Sender (PSE) powers Receiver (PD)

UHBX P2- HDMI+RS232+IR+PoH UTP Extender, Receiver (PSE) powers Sender (PD)

1 - - 163 Warner Ave Tustin, CA 92780, Ph: (714)641 6607, Fax (714)641 6698

HDMI Extender with Power, IR, and RS- 232

Table of Contents

1.0 Introduction ...................................................................................... 3

2.0 Features ............................................................................................. 4

3.0 Model numbers covered in this Manual .......................................... 4

4.0 Setup .................................................................................................. 5

4.1 Package Contents .......................................................................... 5

4.2 Sender Connections ...................................................................... 5

4.3 Receiver Connections ................................................................... 8

4.4 Setting the Distance Mode ............................................................ 9

4.5 LED indicators .............................................................................. 9

5.0 Troubleshooting ............................................................................... 10

6.0 Specifications .................................................................................... 11

T RADEMARKS USED IN THIS MANUAL

Hall Research and its logo are trademarks of Hall Research. Any other trademarks

mentioned in this manual are acknowledged as the property of the trademark owners.

FCC RADIO FREQUENCY INTERFERENCE STATEMENT

This equipment generates, uses, and can radiate radio frequency energy and if not installed and

used properly, that is, in strict accordance with the manufacturer’s instructions, may cause

interference to radio communication. It has been designed to comply with the limits for a Class

A computing device in accordance with the specifications in Subpart B of Part 15 of FCC rules,

which are intended to provide reasonable protection against such interference when the

equipment is operated in a commercial environment. Operation of this equipment in a

residential area is likely to cause interference, in which case the user at their own expense will

be required to take whatever measures may be necessary to correct the interference.

Changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

UHBX- Series

1.0 Introduction

This manual covers a few of the UHBX series of HDMI extenders by Hall

Research. These products are comprised of individual sender and receiver

modules that can send HDMI, bidirectional IR, full-duplex RS232, and PoH

(power over HDBaseT) over distances of up to 150 meters (500 feet) using a

single Cat6 cable.

The products can extend - HDMI or single link DVI video of virtually any

resolution to, a maximum distance of 500 ft (150 m). Two user selectable

distance modes are available: Standard and These modes are Long Reach.

explained further in section 4.4 of this manual.

The extenders comply with Power- -over HDBaseT or PoH, hence only one

end requires a power supply. The end identified as PSE (power sourcing

equipment) injects power on to the Cat6 cable and the side identified as PD

(powered device) powered through the Cat6 cable.is

The PSE side requires connection of an AC adapter that supplies 5v DC,

while the PD side is simply powered through the RJ45 connector from the

opposite side.

Senders and Receivers are available in both PSE and PD versions. Prior to

placing an order, i which scenario t is important to determine works best for a

given ince setup s the direction of power flow is determined by the model

numbers ordered and cannot be reversed in the field.

Figure 1 – Block Diagram for power sent from Sender to Receiver

Figure 2 – Block Diagram for power sent from Receiver to Sender

Specyfikacje produktu

Marka:	Kindermann
Kategoria:	przedłużacz AV
Model:	UHBX-R-PSE

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Kindermann UHBX-R-PSE, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą

Twoje imię*

Twój email*

Napisz tutaj swoje pytanie

Instrukcje przedłużacz AV Kindermann

Kindermann UHBX-R-PSE Instrukcja

26 Września 2024

Kindermann Multishare 31 Instrukcja

26 Września 2024

Kindermann 1 Port HDBT Input Card Multimatrix 8 Instrukcja

26 Września 2024

Instrukcje przedłużacz AV

Najnowsze instrukcje dla przedłużacz AV

StarTech.com STUTPRXWAL Instrukcja

9 Października 2024

StarTech.com STUTPTXWAL Instrukcja

9 Października 2024

StarTech.com CPNTUTPWALLA Instrukcja

9 Października 2024

StarTech.com STUTPWALL Instrukcja

9 Października 2024

StarTech.com ST121UTPDVGB Instrukcja

9 Października 2024

StarTech.com ST121RGB Instrukcja

9 Października 2024

StarTech.com ST121UTP232 Instrukcja

9 Października 2024

StarTech.com ST121REU Instrukcja

9 Października 2024

StarTech.com STHDBTRX Instrukcja

9 Października 2024

StarTech.com ST122UTPAEU Instrukcja

9 Października 2024