Instrukcja obsługi Kicker S10L74

Kicker subwoofer S10L74

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Kicker S10L74 (11 stron) w kategorii subwoofer. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Strona 1/11
Owner’s Manual | English
Manual del Propietario | Español
SOLO-BARIC® ALTAVOZ PARA SONIDOS GRAVES
Benutzerhandbuch | Deutsch
SOLO-BARIC® TIEFTÖNER
Manuel d’utilisation | Française
SOLO-BARIC® HAUT-PARLEUR D’EXTRÊMES GRAVES
SOLO-BARIC® SUBWOOFER
S8L7 | S10L7 | S12L7 | S15L7
2
SPECIFICATIONS
WIRING
Solo-Baric L7 subwoofers are available with dual 2 (ohm) or dual 4 voice coils. Both coils must be  
connected to a source of amplifi cation. The dual 2 woofer will generate a 1 load if the coils are wired  
in parallel or a 4 load in series. The dual 4 woofer will provide a 2 load wired in parallel or 8 load  
wired in series. The terminals with the white dots are for the rst voice coil. The terminals with solid-red
and solid-black markings are for the second voice coil. See Figure 1.
SOLO-BARIC L7 SUBWOOFER
OWNER’S MANUAL
Authorized KICKER Dealer:
Purchase Date:
Speaker Model Number:
Speaker Serial Number:
Model S8L7 S10L7 S12L7 S15L7
Nominal Impedance [Zn], ohm 2 or 4 2 or 4 2 or 4 2 or 4
Resonance Frequency [fs], Hz 47.2 37.5 34 26.3
Power Handling Watts, Peak (RMS) 900 (450) 1200 (600) 1500 (750) 2000 (1000)
Sensitivity [SPLo], dB @ 1W, 1m 82.37 85.87 86.90 88.56
Effective Excursion [EXmax™], in (mm) .48 (12.2) .55 (13.9) .56 (14.1) .63 (16.1)
DC Resistance [Re], ohm 6.6 7.9 6.8 7.0
Mechanical Q-Factor [Qms] 8.828 9.791 9.488 11.868
Electrical Q-Factor [Qes] .802 .535 .571 .565
Total Q-Factor [Qts] .735 .507 .539 .539
Equivalent Volume [Vas], ft³ (L) .322 (9.127) 1.0 (28.347) 1.916 (54.274) 5.263 (149.048)
Outer Frame Diameter, in (cm) 8-3/16 (22.4) 10-11/16 (27.1) 12-5/8 (32) 15-5/8 (39.7)
Hole Cut-Out Diameter, in (cm) 7-1/4 (18.4) 9-5/16 (23.7) 11-1/16 (28.1) 13-3/4 (34.9)
Mounting Depth, in (cm) 4-3/4 (12.1) 6-1/4 (15.9) 6 13/16 (17.3) 8 11/16 (22.1)
S8L7 / S10L7 / S12L7 / S15L7Models:
Note: All specifi cations and performance gures are subject to change. Please visit www.kicker.com for the most
current information. To get the best performance from your new KICKER Subwoofer, we recommend using genuine
KICKER Accessories and Wiring. Please allow two weeks of break-in time for the subwoofer to reach optimum
performance.
Fig
Sound Check: Poor bass response? Check the system phasing by reversing the positive and negative
speaker connections on the subwoofer. If the bass improves, then the subwoofer was out of phase in
reference to the rest of the audio system.
4
Do not install a port opening against a solid surface, such as an internal brace, back-panel or trunk wall,
seat or interior panel of your vehicle. The port opening must remain unobstructed. Use the smallest
dimension of the rectangular port as the minimum amount of space between the port opening and any
solid surface to insure unrestricted air ow.
If you prefer an ultra-smooth bass response, you should loosely ll your L7 enclosure with poly-fi l
stuffi ng. Ported designs will require covering the end of the port (located inside the box) with grill cloth,
chicken wire, or expanded metal to prevent the poly-fi l from exiting the port. The use of poly-fi l will slightly
decrease effi ciency, but will deepen and extend the low frequency output.
For more advice on box building, refer to your Authorized Kicker Dealer, or click on the Support tab on
the Kicker homepage, www.kicker.com. Please e-mail support@kicker.com or call Technical Support at
(405) 624-8583 for specifi c or unanswered questions.
D
D D
Figure 3 Figure 4
D = 3” x 3” for S12L7, S15L7
D = 2” x 2” for S8L7, S10L7
SEALED ENCLOSURE APPLICATIONS
Model Volume ft3 (L) Panel A in. (cm) Panel B in. (cm) Panel C in. (cm)
S8L7 .5 (14.16) 11X11 (27.9X27.9) 11x9.5 (27.9x24.1) 9.5x9.5 (24.1x24.1)
S10L7 1 (28.32) 13.5X13.5 (34.3X34.3) 13.5x12 (34.3x30.5) 12x12 (30.5x30.5)
S12L7 1.25 (35.4) 14.5X14.5 (36.8X36.8) 14.5x13 (36.8x33) 13x13 (33x33)
S15L7 2 (56.64) 16.5x16.5 (42x42) 16.5x15 (42x38.1) 15x15 (38.1x38.1)
Model Volume ft3 (L) Power Handling
S8L7 .5 (14.16) 200W RMS
S10L7 1 (28.32) 600W RMS
S12L7 1.25 (35.4) 750W RMS
S15L7 2 (56.64) 1000W RMS
Model Volume ft3 (L) Power Handling
S8L7 .75 (21.24) 200W RMS
S10L7 1.25 (35.4) 600W RMS
S12L7 2 (56.64) 750W RMS
S15L7 6 (169.9) 1000W RMS
Panel Dimensions for Compact Sealed Enclosures using 3/4” (1.9cm) thick MDF (See Figure 5)
Sealed Compact Sealed SQ
The Solo-Baric generates more sound pressure

Specyfikacje produktu

Marka: Kicker
Kategoria: subwoofer
Model: S10L74

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Kicker S10L74, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą




Instrukcje subwoofer Kicker

Kicker

Kicker CompC 50VCWC122 Instrukcja

6 Października 2024
Kicker

Kicker 49PTRTP12 Instrukcja

20 Września 2024
Kicker

Kicker 48CWR122 Instrukcja

30 Sierpnia 2024
Kicker

Kicker 48CWR152 Instrukcja

22 Sierpnia 2024
Kicker

Kicker 48CWRT122 Instrukcja

21 Sierpnia 2024
Kicker

Kicker S10L74 Instrukcja

18 Sierpnia 2024
Kicker

Kicker CVR102 Instrukcja

18 Sierpnia 2024
Kicker

Kicker CWRT672 Instrukcja

17 Sierpnia 2024

Instrukcje subwoofer

Najnowsze instrukcje dla subwoofer