Instrukcja obsługi Kenwood DDX418

Kenwood odtwarzacz DVD DDX418

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Kenwood DDX418 (20 stron) w kategorii odtwarzacz DVD. Ta instrukcja była pomocna dla 5 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/20
LVT2199-005A (KN/RN)© 2010 Kenwood Corporation All Rights Reserved.
DDX418
DDX4048BT
DDX318
DDX3048
MONITOR WITH DVD RECEIVER
INSTALLATION MANUAL
MONITEUR AVEC RÉCEPTEUR DVD
MANUEL D'INSTALLATION
MONITOR CON RECEPTOR DVD
MANUAL DE INSTALACIÓN
2 DDX418/DDX4048BT/DDX318/DDX3048
Accessories
1
..........1
2
..........1 (2m: 6.5 ft)
3
..........6
4
..........6
5
..........1
6
..........2
7*1
..........1 (3m: 9.8 ft)
*1 DDX418/ DDX4048BT
only.
Installation Procedure
1 To prevent a short circuit, remove the key
from the ignition and disconnect the -
battery.
2 Make the proper input and output wire
connections for each unit.
3 Connect the speaker wires of the wiring
harness.
4 Connect the wiring harness wires in the
following order: ground, battery, ignition.
5 Connect the wiring harness connector to
the unit.
6 Install the unit in your car.
7 Reconnect the - battery.
8 Press the reset button.
9 Perform the Initial Setup. (Refer to the
Instruction Manual.)
2WARNING
• If you connect the ignition wire (red) and the
battery wire (yellow) to the car chassis (ground),
you may cause a short circuit, that in turn may
start a fire. Always connect those wires to the
power source running through the fuse box.
• Do not cut out the fuse from the ignition wire
(red) and the battery wire (yellow). The power
supply must be connected to the wires via the
fuse.
After the Installation
After the installation, perform the Initial Setup
by referring to the instruction manual.
¤
• Mounting and wiring this product requires
skills and experience. For best safety, leave the
mounting and wiring work to professionals.
• Make sure to ground the unit to a negative 12V
DC power supply.
• Do not install the unit in a spot exposed to direct
sunlight or excessive heat or humidity. Also avoid
places with too much dust or the possibility of
water splashing.
• Do not use your own screws. Use only the screws
provided. If you use the wrong screws, you could
damage the unit.
• If the power is not turned ON ("Miswiring
DC Offset Error", "Warning DC Offset Error" is
displayed), the speaker wire may have a short-
circuit or touched the chassis of the vehicle and
the protection function may have been activated.
Therefore, the speaker wire should be checked.
• If your car’s ignition does not have an ACC
position, connect the ignition wires to a power
source that can be turned on and off with the
ignition key. If you connect the ignition wire to
a power source with a constant voltage supply,
such as with battery wires, the battery may be
drained.
• If the console has a lid, make sure to install the
unit so that the faceplate will not hit the lid when
closing and opening.
• If the fuse blows, first make sure the wires aren’t
touching to cause a short circuit, then replace the
old fuse with one with the same rating.
Accessories/ Installation Procedure
English 3
¤ CAUTION
Install this unit in the console of your
vehicle.
Do not touch the metal part of this unit
during and shortly after the use of the
unit. Metal part such as the heat sink and
enclosure become hot.
• Insulate unconnected wires with vinyl tape or
other similar material. To prevent a short circuit,
do not remove the caps on the ends of the
unconnected wires or the terminals.
• Connect the speaker wires correctly to the
terminals to which they correspond. The unit may
be damaged or fail to work if you share the -
wires or ground them to any metal part in the car.
• When only two speakers are being connected
to the system, connect the connectors either to
both the front output terminals or to both the
rear output terminals (do not mix front and rear).
For example, if you connect the connector +
of the left speaker to a front output terminal, do
not connect the connector to a rear output -
terminal.
• After the unit is installed, check whether the brake
lamps, blinkers, wipers, etc. on the car are working
properly.
• Mount the unit so that the mounting angle is 30°
or less.
• Do not press hard on the panel surface when
installing the unit to the vehicle. Otherwise scars,
damage, or failure may result.
• This unit has the cooling fan to decrease the
internal temperature. Do not mount the unit
in a place where the cooling fan of the unit are
blocked. Blocking these openings will inhibit the
cooling of the internal temperature and result in
malfunction.
Cooling fan
DDX418/ DDX4048BT only
• Install the Bluetooth adaptor (KS-UBT1) besides
the place enclosed by the metal.
Bluetooth adaptor (KS-UBT1)

Specyfikacje produktu

Marka: Kenwood
Kategoria: odtwarzacz DVD
Model: DDX418

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Kenwood DDX418, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje odtwarzacz DVD Kenwood

Kenwood

Kenwood DVF-5500-S Instrukcja

4 Października 2024
Kenwood

Kenwood DVF-5500-B Instrukcja

16 Września 2024
Kenwood

Kenwood DVF-3400-S Instrukcja

9 Września 2024
Kenwood

Kenwood DDX26BT Instrukcja

5 Września 2024
Kenwood

Kenwood Excelon DDX9906XR Instrukcja

4 Września 2024
Kenwood

Kenwood DDX418 Instrukcja

3 Września 2024
Kenwood

Kenwood KVT-514 Instrukcja

2 Września 2024
Kenwood

Kenwood DVF-3400-B Instrukcja

1 Września 2024
Kenwood

Kenwood DDX276BT Instrukcja

30 Sierpnia 2024
Kenwood

Kenwood DDX5707S Instrukcja

27 Sierpnia 2024

Instrukcje odtwarzacz DVD

Najnowsze instrukcje dla odtwarzacz DVD

AKAI

AKAI ad70h Instrukcja

14 Stycznia 2025
Qmedia

Qmedia QDVD-060 Instrukcja

14 Stycznia 2025
Medion

Medion LIFE P72022 (MD 84873) Instrukcja

13 Stycznia 2025
Samsung

Samsung DVD-P146 Instrukcja

10 Stycznia 2025
Samsung

Samsung DVD-E319 Instrukcja

10 Stycznia 2025
Samsung

Samsung DVD-S426KG Instrukcja

10 Stycznia 2025
LG

LG DR176H Instrukcja

10 Stycznia 2025
LG

LG DAT-200 Instrukcja

10 Stycznia 2025
LG

LG D76 Instrukcja

10 Stycznia 2025
LG

LG DVX141 Instrukcja

9 Stycznia 2025