Instrukcja obsługi JANDY CS250
JANDY
Filtr wody
CS250
Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla JANDY CS250 (36 stron) w kategorii Filtr wody. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek
Strona 1/36
Single Element Cartridge Pool & Spa CS Filters
Models: CS100 CS250
CS150
CS200
Essential installation and startup instructions are included in this manual.
Additional operation and troubleshooting information is available online by
scanning the QR code with your phone or visiting jandy.com
WARNING
FOR YOUR SAFETY – This product must be installed and serviced by a contractor who is licensed and qualified in pool
equipment by the jurisdiction in which the product will be installed where such state or local requirements exist. The
maintainer must be a professional with sufficient experience in pool equipment installation and maintenance so that all of
the instructions in this manual can be followed exactly. Before installing this product, read and follow all warning notices and
instructions that accompany this product. Failure to follow warning notices and instructions may result in property damage,
personal injury, or death. Improper installation and/or operation may void the warranty.
Improper installation and/or operation can create unwanted electrical hazard which may cause serious injury, property
damage, or death.
ATTENTION INSTALLER – This manual contains important information about the installation, operation and
safe use of this product. Thisinformation should be given to the owner/operator of this equipment.
Installation and Operation Manual
Manuel d’installation et d’utilisation
Manual de instalación y operación
Page 2
ENGLISH Jandy
®
Single Element Cartridge Pool & Spa CS Filters | Installation & Operation Manual
Section 1. Important Safety Instructions
READ AND FOLLOW ALL INSTRUCTIONS
1.1 Important Safety Warning
WARNING
• Do not connect system to an unregulated city water system or other external source of pressurized
water producing pressures greater than 35 PSI.
• Pressurized air in system can cause product failure or also cause the filter lid to be blown off
which can result in death, serious personal injury, or property damage. Be sure all air is out of
system before operating or testing the equipment.
MAXIMUM OPERATING PRESSURE OF THE FILTER IS 50 PSI. NEVER SUBJECT THE FILTER TO
ANY OPERATING PRESSURE EXCEEDING 50 PSI.
This filter operates under high pressure. When any part of the circulating system, i.e., filter, pump,
valve(s), clamp, etc. is serviced, air can enter the system and become pressurized when the system
is restarted. Pressurized air can cause product failure or also cause the filter lid to be blown off which
can result in death, serious personal injury or property damage. To avoid this potential hazard, follow
all of the instructions in this manual.
To minimize risk of severe injury or death the filter and/or pump should not be subjected to the piping
system pressurization test.
Local codes may require the pool piping system to be subjected to a pressure test. These
requirements are generally not intended to apply to the pool equipment such as filters or pumps.
Jandy Pro Series pool equipment is pressure tested at the factory.
If however this WARNING cannot be followed and pressure testing of the piping system must include
the filter and/or pump BE SURE TO COMPLY WITH THE FOLLOWING SAFETY INSTRUCTIONS:
• Check all clamps, bolts, lids, lock rings and system accessories to ensure they are properly
installed and secured before testing.
• RELEASE ALL AIR in the system before testing.
• Water pressure for test must NOT EXCEED 35 PSI.
• Water temperature for test must NOT EXCEED 100°F (38°C).
• Limit test to 24 hours. After test, visually check system to be sure it is ready for operation.
Notice: These parameters apply to Jandy Pro Series equipment only. For non-Jandy equipment, consult equipment manufacturer.
Table of Contents
Section 1. Important Safety Instructions 2 ....
1.1 Important Safety Warning 2 .........................
1.2 General Safety Instructions 3 ......................
Section 2. General Information 3 ....................
2.1 Introduction ............................................... 3
2.2 Description ................................................ 3
2.3 General Requirements 3 ..............................
Section 3. Installation Instructions 4 ..............
3.1 Filter Location 4 ...........................................
3.2 Filter Preparation 4 ......................................
3.3 Filter Installation 5 ........................................
3.4 Locking Ring and Tank Top Assembly
Installation 5 .................................................
Section 4. Start-Up and Operation 6 ..............
4.1 New Pool and Seasonal Start-up 6 .............
Section 5. Filter Disassembly
and Assembly 7 ..............................
5.1 Filter Element Removal 7 .............................
Section 6. Maintenance 7 ................................
6.1 General Maintenance 7 ................................
6.2 Pressure Gauge 8 ........................................
6.3 Cleaning the Filter Cartridge 8 .....................
6.4 Breather Tube Maintenance 8 ......................
Section 7. Winterizing 8 ...................................
Section 8. Troubleshooting 9 ..........................
Section 9. Parts List and Exploded View 10 ..
Jandy
®
Single Element Cartridge Pool & Spa CS Filters | Installation & Operation Manual ENGLISH
Page 3
1.2 General Safety Instructions
ATTENTION INSTALLER
This manual contains important information about the installation, operation and safe use of this
product. This information should be given to the owner/operator of this equipment.
1. Use equipment only in a pool or spa installation.
2. Before repositioning valve(s) and before beginning the assembly, disassembly, or adjustment of the clamp, or any
other service of the circulating system; (A) turn the pump off and shut off any automatic controls to ensure the system
is not inadvertently started during servicing; (B) open the air release valve; (C) wait until all pressure is relieved (air will
have stopped flowing from the air release valve).
3. Whenever installing the filter clamp follow Section 3.4 of this manual, “Locking Ring/Tank Top Assembly Installation”.
4. Once service on the circulation system is complete, follow Section 4 of this manual, “Start-up and Operation”.
5. Maintain circulation system properly. Replace worn or damaged parts immediately.
6. Be sure that the filter is properly mounted and positioned according to these installation instructions.
7. Do not pressure test above 35 PSI. Pressure testing must be done by a trained pool professional.
SAVE THESE INSTRUCTIONS
Section 2. General Information
2.1 Introduction
This manual contains information for the proper
installation and operation of the Jandy CS Series
Cartridge Filters. Procedures in this manual must be
followed exactly. For technical assistance, contact our
Technical Support Department at 1.800.822.7933.
2.2 Description
Cartridge filters do not require sand or diatomaceous
earth as the filter medium. Instead they contain a filter
cartridge element which is easily removed for cleaning
or replacement.
Dirty water flows into the filter tank and is directed
through the filter cartridge. The debris is collected on
the surface of the cartridge as the water flows through
it. The water will travel through the central filter
core towards the bottom of the filter into the lower
manifold. Clean water is returned to the swimming
pool through the filter outlet port at the tank’s bottom.
As debris collects in the filter, the pressure will rise and
water flow to the pool will diminish. The filter cartridge
must be cleaned when the operating pressure of the
filter rises 10 psi from the operating pressure of a
clean cartridge. See Section 6 “Cleaning the Filter”.
NOTE: A filter removes dirt and other suspended particles but
does not sanitize the pool. Pool water must be sanitized
and chemically balanced for clear water. The filtration
system should be designed to meet local health codes. At
a minimum, the system should turnover the total volume
of water in your pool two (2) to four (4) times in a 24 hour
period.
2.3 General Requirements
1. For best overall performance place the system as
close to the pool as possible.
2. The filter should be located on a level concrete slab
so that the orientation of the valve outlets and the
pressure gauge are convenient and accessible for
the installation and operation of the unit.
3. Protect the filter from the weather.
4. If fitting a chlorinator and/or any other device into
the filtration plumbing circuit, great care must be
exercised to ensure that the appliance is installed
in accordance with the Manufacturer’s Instructions
and any applicable standards that may exist.
5. Use Jandy universal unions to connect each
component of the water conditioning system for
future servicing. All Jandy filters come with these
type of fittings.
WARNING
The maximum operating pressure for this filter is 50 psi.
Never subject the filter to operating pressure exceeding
50 psi. Operating pressures above 50 psi can cause
product failure or also cause the lid to be blown off,
which can result in death, serious personal injury, or
property damage.
6. When performing hydrostatic pressure tests or
when testing for external leaks of the completed
filtration and plumbing system, ensure that
the maximum pressure the filtration system is
subjected to does not exceed the maximum
working pressure of any of the components within
the system.
Specyfikacje produktu
| Marka: | JANDY |
| Kategoria: | Filtr wody |
| Model: | CS250 |
Potrzebujesz pomocy?
Jeśli potrzebujesz pomocy z JANDY CS250, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą
Instrukcje Filtr wody JANDY
19 Grudnia 2024
19 Grudnia 2024
19 Grudnia 2024
Instrukcje Filtr wody
- Filtr wody LG
- Filtr wody Smeg
- Filtr wody Tefal
- Filtr wody Philips
- Filtr wody JBL
- Filtr wody Waterco
- Filtr wody Midea
- Filtr wody Panasonic
- Filtr wody Jura
- Filtr wody GE
- Filtr wody BRITA
- Filtr wody Haier
- Filtr wody Fiap
- Filtr wody Grohe
- Filtr wody Zanussi
- Filtr wody Juwel
- Filtr wody Ecowater
- Filtr wody Eden
- Filtr wody Oliveri
- Filtr wody Bartscher
- Filtr wody Fluval
- Filtr wody Franke
- Filtr wody Solac
- Filtr wody Verbatim
- Filtr wody Eheim
- Filtr wody Oase
- Filtr wody Breville
- Filtr wody Terraillon
- Filtr wody Sera
- Filtr wody Avanti
- Filtr wody Consul
- Filtr wody AstralPool
- Filtr wody Jata
- Filtr wody Eldom
- Filtr wody Kent
- Filtr wody Ufesa
- Filtr wody Laica
- Filtr wody Imetec
- Filtr wody Zodiac
- Filtr wody T.I.P.
- Filtr wody Everpure
- Filtr wody Pureit
- Filtr wody MSR
- Filtr wody BWT
- Filtr wody Billi
- Filtr wody LifeStraw
- Filtr wody Baracuda
- Filtr wody Aarke
- Filtr wody Zip
- Filtr wody Aquasure
- Filtr wody ZeroWater
- Filtr wody Beemur
- Filtr wody Tunze
- Filtr wody Aqua Medic
- Filtr wody PUR
- Filtr wody Hydor
- Filtr wody Heissner
- Filtr wody Aquael
- Filtr wody Platypus
Najnowsze instrukcje dla Filtr wody
23 Grudnia 2024
20 Grudnia 2024
16 Grudnia 2024
15 Grudnia 2024
15 Grudnia 2024
15 Grudnia 2024
15 Grudnia 2024
10 Grudnia 2024
10 Grudnia 2024
10 Grudnia 2024