Instrukcja obsługi IHome iBTW750

IHome głośnik iBTW750

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla IHome iBTW750 (1 stron) w kategorii głośnik. Ta instrukcja była pomocna dla 3 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/1

reset

RES

EST

» A voice prompt will automatically announce when the battery level is very low.

» Press and hold the Color Mode Button to hear current battery level announcement.

FCC Information

This device complies with Part 15 of the FCC Rules, operation is subject to the f ollowing two conditions: (1) This

device may not cause harmful interf erence, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

FCC Radiation Exposure Statement

The device has been evaluated to meet general RF exposure requirement.

The device can be used in portable exposure condition without restriction.

• Warning: Changes or modiﬁcations to this unit not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment o and on,

the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

CAN ICES 3(B) / NMB-3(B), CAN RSS-216/CNR-216

Canada Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic

Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.

2. This device must accept any interference, including interference that may cause undesired operation of the device.

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,

Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation

est autorisée aux deux conditions suivantes :

(1) L’appareil ne doit pas produire de brouillage;

(2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre

le fonctionnement.

WARNING/DISPOSAL OF UNIT

Do NOT attempt to change the battery. Doing so will void the warranty and could cause injury and damage to your

device. To dispose of the unit, follow the instructions below:

• Never dispose of used batteries/electronics with ordinary solid wastes, since they contain toxic substances.

• Always dispose of used batteries/electronics in accordance with the prevailing community regulations.

• Many electronics retailers now recycle batteries and other electronic components at no charge.

GENERAL BATTERY PRECAUTIONS

• Never use or charge a battery if it appears to be leaking, discolored, deformed, or in any way abnormal.

• Never disassemble the unit or attempt to remove battery as that could cause leakage of alkaline solution or other

electrolytic substances.

• Avoid charging a rechargeable battery when the temperature is not within 5°C - 35°C (41° - 95° Fahrenheit).

• Never expose a battery to any liquid.

• Never expose a battery to excessive heat such as direct sunlight or ﬁre. Never use a battery pack in an unventilated

vehicle where excessive internal temperatures may be encountered.

• Always keep batteries out of the reach of infants and small children.

Model: iBTW750

FCC ID: EMOIBTW750

IC: 986B-IBTW750

FRONT

BACK

Color Changing

Stereo Speaker System

with Wireless Charging

Model: iBTW750

» iBTW750 »

QUICK START GUIDE » Press and hold the Power Button for 2 seconds to power on the unit.

» Press and hold the Bluetooth Button for 2 seconds to enter pairing mode.

iBTW750 QSG (English)

Size: 420 x 160 mm (folded: 140 x 160 mm)

Color: 4C + 4C

Material: 260gsm Art Card, 2C + 2C

Mar 29, 2019

WIRELESS CHARGING

BATTERY LEVEL

1 Power Button

Press and hold for 2 seconds

to power unit ON or OFF.

2 Battery/Charge indicator

Solid red = charging

Solid green = fully charged

3 USB Charge Port

Connect included USB cable to

charge iBTW750 for portable

use.

4 Bluetooth Indicator

Fast blinking blue = pairing

Slow blinking blue = linking

Solid blue = paired to device

5 Bluetooth Button

Press and hold for 2 seconds to

pair a device with the unit.

Press to answer incoming call.

Press and hold for 2 seconds

to end or decline call.

6 Color Change Button

Press and release to cycle

through color change modes:

slow fade, fast change, favorite

color, pulse to music, preset

pulse mode and o.

BACK

Pairing and Playing Audio

» Select ‘iHome iAV5’ on your Bluetooth device’. You will hear a

“Connected” announcement once your device is paired. Use your

Bluetooth device to navigate/control audio.

BLUETOOTH PAIRING

7 Pinhole Reset Port

If unit fails to respond properly,

insert a paper clip or similar tool into

the Reset Port on the back of the unit.

IMPORTANT SAFETY INSTRUCTIONS

When used in the directed manner, this unit has been designed and manufactured to ensure your personal

safety. However, improper use can result in potential electrical shock or ﬁre hazards. Please read and follow

all safety and operating instructions carefully before installation and use, and keep these instructions handy

for future reference. Take special note of all warnings listed in these instructions and on the unit.

1. Water and Moisture – The unit should not be used near water. For example: near a bathtub, washbowl,

kitchen sink, laundry tub, swimming pool or in a wet basement.

2. Ventilation – The unit should be situated so that its location or position does not interfere with its proper

ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block

ventilation openings. Also, it should not be placed in a built-in installation, such as a bookcase or cabinet,

which may impede the ﬂow of air through the ventilation openings.

3. Heat – The unit should be situated away from heat sources such as radiators, heat registers, stoves or other

appliances (including ampliﬁers) that produce heat.

4. Power Sources – The unit should be connected to a power supply only of the type described in the operating

instructions or as marked on the appliance. Only use the AC adapter that came with the unit.

5. Power-Cable Protection – Power supply cables should be routed so that they are not likely to be walked

on or pinched by items placed upon or against them. It is always best to have a clear area from where the

cable exits the unit to where it is plugged into an AC socket.

6. Cleaning – The unit should be cleaned only using a warm damp cloth. Do not use solvents, etc.

7. Objects and Liquid Entry – Care should be taken so that objects do not fall and liquids are not spilled into

any openings or vents located on the product.

8. Attachments – Do not use attachments not recommended by the product manufacturer.

9. Lightning and Power Surge Protection – Unplug the unit from the wall socket and disconnect the antenna

or cable system during a lightning storm or when it is left unattended and unused for long periods of time.

This will prevent damage to the product due to lightning and power-line surges.

10. Overloading – Do not overload wall sockets, extension cords, or integral convenience receptacles as this

can result in a risk of ﬁre or electric shock.

11. Damage Requiring Service – The unit should be serviced by qualiﬁed service personnel when:

A. the power supply cable or plug has been damaged.

B. objects have fallen into or liquid has been spilled into the enclosure.

C. the unit has been exposed to rain.

D. the unit has been dropped or the enclosure damaged.

E. the unit exhibits a marked change in performance or does not operate normally.

12. No naked ﬂame sources, such as lighted candles, should be placed on the apparatus”

13. The power adapter, used as the disconnected device, It is always best to have a clear area from where the

cable exits the unit to where it is plugged into an AC socket

14. Periods of Nonuse – If the unit is to be left unused for an extended period of time, such as a month or

longer, the backup battery should be removed from the unit to prevent damage or corrosion.

15. Servicing – The user should not attempt to service the unit beyond those methods described in the user’s

operating instructions. Service methods not covered in the operating instructions should be referred to

qualiﬁed service personnel.

16. Attention should be drawn to the environmental aspects of battery disposal”

17. This product is suitable for use in tropical and/or moderate climates.”

18. WARNING: To reduce the risk of ﬁre or electric shock, do not expose this product to rain or moisture”

19. CAUTION – Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent

type.”

20.The mains plug of power adaptor is used as the disconnect device, it shall remain readily operable”

Printed in ChinaiBTW750-190329-A

For warranty and full instructions

visit: www.ihome.com/support

Questions? Visit www.ihome.com

or call 1-800-288-2792 Toll Free

CHARGE UNIT

BEFORE USE

ABOUT 7 HOURS

USB Charging Cable USB Wall Adapter»

Connecting to Power

QUICK SET-UP

PMS185C

iHome

iAV5

Do not plac e m eta l phone

cas e or me ta l obje cts in the

wireles s cha rg ing are a

» This unit will wirelessly charge Qi compatible wireless charging phones

when connected to a power outlet. Place Qi compatible device face up

on Charging Rest. Check the on the iBTW750 for Charging LED

charging status:

Solid Blue LED: Device is charging properly.

Solid Red LED: Device is fully charged.

Flashing Red LED: Charging error. Reposition device.

» Note: The LED may continue to glow solid blue when iOS devices are

fully charged.

CAUTION: Remove metal protective or magnetic case from phone before

charging. When charging phone, do not place magnetic-striped or other

metal objects on the charger. Doing so could damage the object or this

unit. Qi compatible phones with metallic looking ﬁnishes will charge

normally.

» For best results, clean the rubber pads on the charging rest regularly, using

a damp cloth.

Charging Rest

Charging LED

» Connect the USB plug to the USB wall adapter, then plug the

adapter into a working power outlet.

» Next, plug the micro USB connector to the micro USB port

located under the button controls.

8 Wireless Charging USB Port

Connect included USB cable for

wireless charging operation.

» Now plug the other micro USB connector to the micro USB

port located near the top of the unit.

» Once connected, the unit should match the drawing below:

RES

EST

3 7

Mar 29, 2019Mar 29, 2019

Mar 29, 2019

reset

res et

Specyfikacje produktu

Marka:	IHome
Kategoria:	głośnik
Model:	iBTW750
Kolor produktu:	Czarny
Typ produktu:	Przenośny głośnik stereo
Rodzaj zasilania:	USB
Wbudowany wyłącznik:	Tak
Wysokość produktu:	128.016 mm
Szerokość produktu:	125.222 mm
Głębokość produktu:	121.158 mm
Waga produktu:	1360 g
Ilość na paczkę:	1 szt.
Rekomendowane użycie:	Tablet/Smartphone
Technologia łączności:	Bezprzewodowy
Bluetooth:	Tak
Ilość głośników:	1
Moc wyjściowa (RMS):	3 W
Rodzaj baterii:	Wbudowana bateria
Ilość przetworników:	2
Średnica sterownika:	45 mm
Czas pracy na zasilaniu akumulatorowym:	30 h
Oświetlenie LED:	Tak
Kolor iluminacji:	Wielo
Rozmiar napędu (SxW):	40 x 70 mm