Instrukcja obsługi Hudson Valley Geneva 715-AGB

Hudson Valley Ulga Geneva 715-AGB

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Hudson Valley Geneva 715-AGB (1 stron) w kategorii Ulga. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/1
709, 712 & 715 INSTALLATION INSTRUCTIONS
GENERAL
1. To insure the success of the fixture installation, the following instructions and diagram(s) should be read and understood.
2. All electrical connections must be made in accordance with the National Electric code and local codes and ordinances.
If you are uncertain of the methods of installing electrical wiring and lighting fixtures secure the services of a qualified licensed electrician.
3. TOOLS NEEDED: Blade screwdriver, phillips screwdriver, slip joint pliers or small adjustable wrench, wire cutter/stripper,
electrical current tester, stepladder and electrical tape.
NOTE: The important safeguards and instructions outlined on this sheet are not meant to cover all possible conditions and situations that may occur.
It must be understood that common sense, caution and care are factors that cannot be built into any product.
Caution and care must be supplied by the person(s) installing, operating and maintaining this lighting fixture.
INSTALLATION PREPARATION
1. TURN OFF THE ENTIRE ELECTRICAL CIRCUIT TO WHICH THE LIGHTING FIXTURE IS TO BE ATTACHED.
Move the appropriate circuit breaker to the “off position or completely remove the fuse controlling the circuit.
2. If an existing fixture is being replaced, remove it and note to which of the wires in the outlet box the fixture was attached.
DO NOT SEPARATE ANY OTHER WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION OF OLDER WIRING.
In regular circumstances the BLACK wire will be the “Hot” lead and the WHITE wire will be the “Neutral” or “Common” lead.
A GREEN or BARE COPPER wire is the “Ground”. In older buildings it is always good practice to reconfirm the polarity of the wiring.
This fixture is designed to be mounted on a standard round or octagon box. The box must be securely mounted to the structure of the building. 3.
FIXTURE INSTALLATION
1. Remove the fixture, shades and parts bag(s) from the carton.
Before discarding the carton, double check packing to make certain that all parts are found.
2. Thread the setscrew to the mounting plate.
3. Screw the mounting plate onto the outlet box.
4 Fasten the green fixture wire to the green or bare copper wire in the box .
or fasten it to the mounting plate with green screw provided.
NEVER FASTEN THE GROUND WIRE TO THE BLACK OR “HOT” WIRE!
FAILURE TO FOLLOW THIS INSTRUCTION COULD RESULT IN
SERIOUS INJURY OR DEATH !
5. Fasten the white fixture wire to the white wire in the outlet box.
Fasten the wires to together with an approved fastener (wire nut).
Starting about 1” below the fastener, tightly wrap connection with
electrical tape so that the tape seals the end of the fastener.
Make sure that there is no exposed wire or strands that
could cause a dangerous short circuit !
6. Connect the black fixture wires to the black wire
in the outlet box. Fasten the joined wires as in step 5.
7. Twist the canopy and pan, lock to the ceiling, make sure the gasket be on the
correct position.
Install the lamp (light bulb). 8.
NOTE: 709, 712 & 715 are rated for watt type A lamp. 60
DO NOT EXCEED RECOMMENDED WATTAGE !
9. Twist the glass onto the pan.
10. Restore power to circuit at breaker or fuse box.
Electrical tape
Approved fastener
(Wire nut)
P an
G as ke t
Lam p
G lass
S etscre w
O u tlet B ox G ro un d S crew
C an opy
M o untin g S crew
B all N ut
M o unting Plate

Specyfikacje produktu

Marka: Hudson Valley
Kategoria: Ulga
Model: Geneva 715-AGB

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Hudson Valley Geneva 715-AGB, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Ulga Hudson Valley

Hudson Valley

Hudson Valley Rye 2314-AGB Instrukcja

4 Stycznia 2025
Hudson Valley

Hudson Valley Geneva 712-AGB Instrukcja

4 Stycznia 2025
Hudson Valley

Hudson Valley Amboy 1548-AGB Instrukcja

4 Stycznia 2025
Hudson Valley

Hudson Valley Greenwich 8301-AGB Instrukcja

4 Stycznia 2025
Hudson Valley

Hudson Valley Newport 6513-AGB Instrukcja

4 Stycznia 2025
Hudson Valley

Hudson Valley Geneva 709-AGB Instrukcja

4 Stycznia 2025
Hudson Valley

Hudson Valley Brookhaven 7215-VGL Instrukcja

4 Stycznia 2025
Hudson Valley

Hudson Valley Geneva 715-AGB Instrukcja

4 Stycznia 2025
Hudson Valley

Hudson Valley White Plains 5210-AGB Instrukcja

4 Stycznia 2025
Hudson Valley

Hudson Valley Avondale 1753-AGB Instrukcja

4 Stycznia 2025

Instrukcje Ulga

Najnowsze instrukcje dla Ulga

BeamZ

BeamZ BTSE200 Instrukcja

7 Stycznia 2025
BeamZ

BeamZ Cobra Wash100 Instrukcja

7 Stycznia 2025
Kogan

Kogan KASMFSTN15A Instrukcja

7 Stycznia 2025
BeamZ

BeamZ Cobra Wash120 Instrukcja

7 Stycznia 2025
Kogan

Kogan KBE14CWWT1A Instrukcja

7 Stycznia 2025
BeamZ

BeamZ IGNITE300A Instrukcja

7 Stycznia 2025
Kogan

Kogan KALAMPMS31B Instrukcja

7 Stycznia 2025
Sun Joe

Sun Joe 24V-LGT500-LTE Instrukcja

7 Stycznia 2025
Infinity

Infinity iM-2515 Instrukcja

5 Stycznia 2025
Infinity

Infinity iW-1240 RDM Instrukcja

5 Stycznia 2025