Instrukcja obsługi HK Audio E 110 SUB A

HK Audio subwoofer E 110 SUB A

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla HK Audio E 110 SUB A (2 stron) w kategorii subwoofer. Ta instrukcja była pomocna dla 15 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF

Strona 1/2

E 110 Sub A

Powered Subwoo fer

Mains

Gre en = On

Red = Limit/ Error

Power

Made in Germany

Cau tion : To r educ e th e ri sk o f

elect ric shoc k, g roun ding of

the c ente r pi n of thi s pl ug

must be m aint aine d.

Cau tion : Ri sk o f el ectr ic s hock !

Do no t op en! Refe r se rvic ing to

quali fied ser vice per sonn el.

121 Min. imp. 8 Ohm s

300 Watts

Speaker Out

Serial No.

E 110 Sub A

Po wered Subwoofe r

Mains

Gree n = On

Red = Limit/ Error

Power

Made in Ge rmany

Cau t ion : To r educ e th e ri sk o f

ele ctri c sh ock, gro undi ng o f

the cen ter pin of t his plug

mus t be mai ntai ned.

Cau t ion : Ri sk o f e l ectr ic s hock !

Do not open ! Re fer serv icin g to

qua lifi ed s ervi ce p erso nnel .

21 Min. imp. 8 Ohms

300 Watts

Speaker Out

Serial No.

Mains

Power

Speaker

Out

121

Min . imp.

4 O hms

600 Watts

Made in Ge rman y

Off

parallel

Speaker

out

Mains

Power

Speaker

Out

121

Min. imp.

4 Oh ms

600 Watts

Made in Ge rmany

Off

Mains

Power

Speaker

Out

121

Min. imp.

4 Oh ms

600 Watts

Made in Ge rmany

Off

E 110 Sub A

E 110 Sub

EA 600

parallel

Speaker

out

parallel

Speaker

out

parallel

Speaker

out

parallel

Speaker

out

Input Through

Made in Germany

+–

1- 2-

+–

E 110 Sub 250 Watts

10 Ohms

Input Through

Made in Germany

+–

1- 2-

+–

E 110 Sub 250 Watts

10 Ohms

E 110 Sub A

Info on connecting

Elements components

Take the time to commit these few key facts to memory, and you’ll be able

to connect every setup in no time at all.

Here are the fundamentals:

• The Through port (XLR male) provides a full-range line signal, so you

can route this signal to other devices as you see t

(amp sub, amp amp, sub sub).

• Always route a speaker signal from an EA 600 amp or E 110 Sub A to

the next EF 45 base (with an EP 1 pole holding further E 435 mid/ high

units) or to a passive subwoofer from the active unit’s Parallel Speaker

Out.

The EA 600 amp’s bottom E-Connect port serves purely as a mechanical

coupler to stabilize the setup.

It is not equipped with a bus and does not carry a speaker signal. If it

did, merely setting the EA 600 amp module on the active E 110 Sub A

subwoofer would damage the amps.

E-Connect

w i t h o u t

Signal

E-Connect

w i t h

Signal

LS-Cable (NL4)

Speakon

Mains

Caut io n: To re duce the ris k of

ele ctri c sh ock, gro und i ng o f

the cen t er pin o f t his plug

mus t be mai nt ai ned.

qua li fi ed s ervi ce p erso nnel .

Min. imp. 8 Ohm s

300 Watts

Speaker Out

parallel

Speaker

out

E 110 Sub

Input Through

Made in Germany

+–

1- 2-

+–

E 110 Sub 250 Watts

10 Ohms

Input Through

Made in Germany

+–

1- 2-

+–

E 110 Sub 250 Watts

10 Ohms

Mains

Power

Speaker

Out

121

Min. imp.

4 Oh ms

600 Watts

Made in Ge rmany

Off

EA 600

parallel

Speaker

out

2.1 Active subwoofer to passive subwoofer

E 110 Sub A Speaker Out E 110 Sub Speakon Input

2.2. EA 600 amp to passive subwoofer

EA 600 Speaker Out E 110 Sub Speakon Input

2.3 EA 600 amp to separate mid/ high unit (dual mono)

The EF 45 base’s Speakon connectors serve as input and through ports.

The amp’s lower E-Connect coupler does not route signals, so you can’t

use the bottom EF 45’s Speakon port as an output. This means you must

use the amp’s Parallel Speaker Out port to patch the signal through.

1 Routing speaker signals via E-Connect (without extra speaker cord)

2 Patching a speaker signal through via Speakon (NL4) connectors

Specyfikacje produktu

Marka:	HK Audio
Kategoria:	subwoofer
Model:	E 110 SUB A
Kolor produktu:	Czarny
Wejście XLR:	Tak
Rodzaj opakowania:	Pudełko
Klasa wzmacniacza:	D
Średnica głośnika niskotonowego (imperialny):	10 "
Moc RMS głośnika niskotonowego:	600 W
Pasmo przenoszenia subwoofera:	45 - 150 Hz
Typ głośnika niskotonowego:	Subwoofer aktywny
Szerokość głośnika niskotonowego:	300 mm
Głebokość głośnika niskotonowego:	460 mm
Wysokość głośnika niskotonowego:	480 mm
Ciężar głośnika niskotonowego:	19000 g
Bezprzewodowy subwoofer:	Nie
Liczba subwooferów:	1