Instrukcja obsługi Hayward PowerFlo VS 300

Hayward Przepych PowerFlo VS 300

Przeczytaj poniżej 📖 instrukcję obsługi w języku polskim dla Hayward PowerFlo VS 300 (20 stron) w kategorii Przepych. Ta instrukcja była pomocna dla 4 osób i została oceniona przez 2 użytkowników na średnio 4.5 gwiazdek

Pobierz PDF
Strona 1/20
IS1580X15VSP Rev-A
IS1580X15VSP Rev-A
IS1580X15VSP Rev-A
IS1580X15VSP Rev-A IS1580X15VSP Rev-A
Hayward Pool Products
620 Division St, Elizabeth, NJ 07207
Phone: (908) 355-7995
www.hayward.com
PowerFlo VS™ 300
Owner’s Manual
Model SP1580X15VSP
PowerFlo VS 300 Variable Speed Pump
Note: To prevent potential injury and to avoid unnecessary service calls, read this manual carefully and
completely.
SAVE THIS INSTRUCTION MANUAL
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 2 of 20 PowerFlo VS Variable Speed Pump
IS1580X15VSP Rev-A
Table of Contents
1.IMPORTANT SAFETY INSTRUCTIONS ................................................................................................................. 3
2.General Information ........................................................................................................................................ 6
2.1.Introduction 6
2.2.Primary Features 6
2.3.Product Dimensions 6
3.Installation and Wiring .................................................................................................................................... 7
3.1.Pump Location 7
3.2.Pump Mounting 7
3.3. 7Plumbing
3.4.Electrical 8
3.5.Electrical Specs 8
3.6.Voltage 8
3.7.Grounding and Bonding 8
3.8.Wiring 8
3.9.User Interface Summary 9
3.10.Starting the pump 9
3.11.Display Power Saving Mode 10
3.12.Stopping the Pump 10
3.13.To Change the Default Preset Speed Settings 10
3.14.Lockout Keypad Programming 10
3.15.Recover Factory Default Speed Settings 10
3.16.Fault Errors 10
3.17.Fault Error Code and Troubleshooting Chart 11
4.Maintenance .................................................................................................................................................11
5.Storage / Winterization ................................................................................................................................. 12
5.1.Storing Pump For Winterization 12
6.Shaft Seal Change Instructions ..................................................................................................................... 12
6.1.Shaft Seal Change Procedure 13
7.Replacement Parts ........................................................................................................................................ 14
7.1.Parts Diagram 14
7.2.Parts Listing 15
8.Troubleshooting ........................................................................................................................................... 16
8.1.General Problems 16
9.Product Registration ..................................................................................................................................... 18
10.Warranty ....................................................................................................................................................... 19
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Page 3 of 20 PowerFlo VS Variable Speed Pump
IS1580X15VSP Rev-A
Basic safety precautions should always be followed, including instructions may result in the following: Failure to follow
injury.
This is the safety-alert symbol. When you see this symbol on your pump or in this manual, look for one of the
following signal words, and be alert to the potential for personal injury.
WARNING warns about hazards that could cause serious personal injury, death or major property damage
and if ignored presents a potential hazard.
CAUTION warns about hazards that will or can cause minor or moderate personal injury and/or property
damage and if ignored presents a potential hazard. It can also make consumers aware of actions that are
unpredictable and unsafe.
The NOTICE label indicates special instructions that are important but not related to hazards.
1. IMPORTANT SAFETY INSTRUCTIONS
Before installing or servicing this electrical equipment, turn power supply OFF.
WARNING – READ AND FOLLOW ALL INSTRUCTIONS in this owner’s
manual and on the equipment. Failure to follow instructions can cause severe injury and/or death.
WARNING – This product should be installed and serviced only by a qualified professional.
CAUTION – All electrical wiring MUST be in conformance with all applicable local codes, regulations, and
the National Electric Code (NEC).
USE OF NON-HAYWARD REPLACEMENT PARTS VOIDS WARRANTY.
ATTENTION INSTALLER - THIS MANUAL CONTAINS IMPORTANT INFORMATION ABOUT THE INSTALLATION,
OPERATION, AND SAFE USE OF THIS VARIABLE SPEED PUMP THAT MUST BE FURNISHED TO THE END USER OF THIS
PRODUCT. FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS COULD RESULT IN SERIOUS INJURY.
WARNING – To reduce risk of injury, do climb on this product. Closely not permit children to use or
supervise children at all times. Components such as the filtration system, pumps, and heaters must be positioned
to prevent children from using them as a means of access to the pool.
CAUTION – This pump is intended for use on permanently installed swimming pools and may also be used
with hot tubs and spas if so marked. Do NOT use with storable pools. A permanently installed pool is constructed in
or on the ground or in a building such that it cannot be readily disassembled for storage. A storable pool is
constructed so that it is capable of being readily disassembled for storage and reassembled to its original integrity.
Though this product is designed for outdoor use, it is stro ectrical components from the ngly advised to protect the el
weather. Select a well-drained area, one that will not flood when it rains. It requires free circulation of air for
cooling. Do not install in a damp or non-ventilated location. If installed within an outer enclosure or beneath the
skirt of a hot tub or spa, adequate ventilation and free circulation of air must be provided to prevent overheating of
the motor.
WARNING – Pool and spa components (seals, gaskets, etc.) have a finite life. All components should be
inspected frequently and replaced at least every ten years, or if found to be damaged, broken, cracked, missing, or
not securely attached.

Specyfikacje produktu

Marka: Hayward
Kategoria: Przepych
Model: PowerFlo VS 300

Potrzebujesz pomocy?

Jeśli potrzebujesz pomocy z Hayward PowerFlo VS 300, zadaj pytanie poniżej, a inni użytkownicy Ci odpowiedzą


Instrukcje Przepych Hayward

Hayward

Hayward Easy Temp Fi Instrukcja

14 Września 2024
Hayward

Hayward Booster Instrukcja

11 Września 2024
Hayward

Hayward Max Flo XL VS Instrukcja

4 Września 2024
Hayward

Hayward RSII DI Instrukcja

1 Września 2024
Hayward

Hayward TriStar VS Instrukcja

1 Września 2024
Hayward

Hayward Super II Eco VS Instrukcja

1 Września 2024
Hayward

Hayward K-Flo Instrukcja

29 Sierpnia 2024
Hayward

Hayward MaxFlo VS Instrukcja

28 Sierpnia 2024
Hayward

Hayward PowerFlo VS 300 Instrukcja

27 Sierpnia 2024
Hayward

Hayward RSII Instrukcja

26 Sierpnia 2024

Instrukcje Przepych

Najnowsze instrukcje dla Przepych

Husqvarna

Husqvarna W25P Instrukcja

11 Stycznia 2025
Güde

Güde INOX 100/24 Instrukcja

11 Stycznia 2025
Vivaria

Vivaria Vario N-3000 Instrukcja

11 Stycznia 2025
Maruyama

Maruyama MS655 Instrukcja

11 Stycznia 2025
MSW

MSW -FM-N-53 Instrukcja

4 Stycznia 2025
MSW

MSW -OP-56-DC Instrukcja

4 Stycznia 2025
MSW

MSW -PUMP CLEAN 100 Instrukcja

4 Stycznia 2025
Simpson

Simpson SCP71008 Instrukcja

2 Stycznia 2025
Testo

Testo 565i Instrukcja

1 Stycznia 2025
Sauermann

Sauermann Delta Instrukcja

1 Stycznia 2025